2006 Chevrolet Cobalt Support Question
2006 Chevrolet Cobalt Support Question
Find answers below for this question about 2006 Chevrolet Cobalt.Need a 2006 Chevrolet Cobalt manual? We have 1 online manual for this item!
Question posted by Nomfather1 on April 25th, 2013
Headlights How To Change Bulbs
The person who posted this question about this Chevrolet automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by dandaman1200 on April 25th, 2013 9:12 PM
dandaman1200
Member since:
December 9th, 2010 Points: 481,180
Member since:
December 9th, 2010 Points: 481,180
-
1Set the parking brake and remove the keys from the ignition to ensure your Chevy Cobalt won't roll while you're replacing the headlight bulb.
- 2
Open the hood by pulling the hood release latch located under the instrument panel on the driver's side of the car. Locate the secondary release latch on the front of the hood at the center, slightly towards the driver's side. Slide the latch to the left to release the hood and raise it.
- 3
Locate the headlight assembly and remove the bolts by turning them counterclockwise. Set the bolts aside in a safe place, so you won't misplace them.
- 4
Remove the plastic fasteners from the headlight assembly molding. Carefully pull back the front fascia, or molding. You may need an extra pair of hands to perform this slightly awkward task.
- 5
Grab the headlight assembly and pull it towards the radiator at a slight angle to remove it. This should provide easier access to the headlight bulb and wiring harness.
- 6
Lift the plastic locking tab on the wiring harness to disconnect the bulb base. Then, disconnect the wiring harness from the bulb socket and remove the black retainer by turning it counterclockwise.
- 7
Disconnect the bulb socket by turning it counterclockwise. Remove the old bulb from the socket by firmly, but gently pulling it straight out.
- 8
Replace the old bulb with a new 9007 LL halogen headlight bulb. Put your headlight assembly back together by reversing the steps when you disassembled it. Use 89 inch-lb torque when retightening the headlight assembly bolts.
Hope this helps!
Related Manual Pages
Owner's Manual - Page 1
... ...4-1 Your Driving, the Road, and Your Vehicle ...4-2 Towing ...4-36 Service and Appearance Care ...5-1 Service ...5-3 Fuel ...5-5 Checking Things Under the Hood ...5-10 Headlamp Aiming ...5-44 Bulb Replacement ...5-47 Windshield Wiper Blade Replacement ...5-53 Tires ...5-54 Appearance Care ...5-83 Vehicle Identification ...5-91 Electrical System ...5-92 Capacities and Specifications...
Owner's Manual - Page 2
... page number where it can be found. Litho in U.S.A.
If this is done, it can be obtained from your dealer or from beginning to make changes after that time without further notice. Box 07130 Detroit, MI 48207 GENERAL MOTORS, GM, the GM Emblem, CHEVROLET, the CHEVROLET Emblem, and the name COBALT...
Owner's Manual - Page 38
...) force on a person's arms. A baby should have the protection provided by appropriate restraints. Neither the distance traveled nor the age and size of the traveler changes the need to use a child restraint.
{CAUTION:
People should not use safety restraints. Young children should never hold it. Instead, they should be restrained while...
Owner's Manual - Page 71
...on page 7-2. Q: Is there anything I might add to the front or
sides of the vehicle that change your vehicle. A: Yes. The phone numbers and addresses for Customer Assistance are in Step Two of ... or height, they may not work properly if you relocate any of the airbag system. A: Changing or moving any questions about this will affect my airbag system? The phone numbers and addresses for...
Owner's Manual - Page 78
... right, hold the transmitter higher, and try this feature, the vehicle's doors can be locked and unlocked, and the trunk can be blocking the signal. Changes or modifications to this equipment. If the transmitter does not work or if you have to stand closer to your vehicle for service...
Owner's Manual - Page 80
.... Snap the front and the back of the transmitter with you when you have a maximum of four transmitters matched to it is probably time to change the battery.
Use a type CR2032 battery, or equivalent type. 4. Test the operation of the transmitter together. 5. Slide the new battery into the transmitter with a thin...
Owner's Manual - Page 90
This device must see Fuses and Circuit Breakers on page 7-7. Changes or modifications to this system by other key, your dealer or a locksmith who can service PASS-Key® III+ to get a new key ...
Owner's Manual - Page 95
... up .
3. Hold the clutch pedal to the floor and start if the clutch pedal is designed to the floor and holding it could change the way the engine operates. When the engine starts, let go down for about 15 seconds and try to START. If the vehicle starts brie...
Owner's Manual - Page 100
... on , you can shift to REVERSE (R) while your vehicle. Notice: Shifting to the next higher gear if weather, road, and traffic conditions let you quickly change the position of your engine. While you accelerate, it is moving forward could injure yourself or others. United States Only When this position when you...
Owner's Manual - Page 108
...'s door armrest. Outside Power Mirrors
The controls for the outside power mirrors, are . Push the mirrors away from the vehicle, to the normal position, before changing lanes. Check your inside mirror or glance over your right.
Owner's Manual - Page 113
...36 Boost Gage ...3-37
Instrument Panel Overview ...3-4 Hazard Warning Flashers ...3-6 Other Warning Devices ...3-6 Horn ...3-6 Tilt Wheel ...3-6 Turn Signal/Multifunction Lever ...3-7 Turn and Lane-Change Signals ...3-8 Headlamp High/Low-Beam Changer ...3-8 Flash-to-Pass ...3-8 Windshield Wipers ...3-9 Windshield Washer ...3-10 Cruise Control ...3-10 Headlamps ...3-13 Wiper Activated Headlamps...
Owner's Manual - Page 119
... place. Turn Signal/Multifunction Lever
The lever on page 3-8. • O Exterior Lamp Control. See Turn and
To tilt the wheel, pull down the lever. Lane-Change Signals on page 3-13.
3-7 See Flash-to-Pass on the left side of the steering column includes the following:
• G Turn and Lane...
Owner's Manual - Page 120
... starts to signal a driver in the direction of you that you signal a turn or a lane change , if the arrows flash rapidly, a signal bulb may be on the instrument panel cluster will not see your lane change .
If the arrows do not go on , then release the lever to help avoid an accident...
Owner's Manual - Page 122
... accelerator. Cruise control does not work at speeds below 25 mph (40 km/h).
{CAUTION:
Cruise control can be dangerous on automatically. On such roads, fast changes in heavy traffic. Windshield Washer
To wash your washer until it cools. When you were using before.
3-10 A circuit breaker will resume the speed you...
Owner's Manual - Page 130
... ignition on.
Cooler air is no button for floor, defog and defrost modes. If window fogging is not selected. When this mode. Operation
To change the current mode, select one of the following:
9 (Off): To turn the fan off, turn the air conditioning system on or off. H (Vent):
This mode...
Owner's Manual - Page 132
... turned off by pressing the button again or by your warranty. Outlet Adjustment
Use the thumbwheels located next to and below the air outlets to change the direction of air into your vehicle more quickly in airflow, which may
adversely affect the performance of the system.
• Keep the...
Owner's Manual - Page 147
... inspection if the OBD (on-board diagnostic) system determines that your engine is not receiving enough oil. If you have a problem with the fuse or bulb. The vehicle would not be burned. Oil Pressure Light
If you do, your engine can prepare the vehicle for...
Owner's Manual - Page 238
...Turn Signals When Towing a Trailer
When you start down , you are about to turn or lane change lanes or stop. Signal well in the red area, turn signal flasher and/or extra .... Making Turns
Notice: Making very sharp turns while trailering could be sure the trailer bulbs are not. Avoid jerky or sudden maneuvers.
The arrows on the trailer are very important...
Owner's Manual - Page 287
... headlamp beam is aimed to read and follow the instructions on page 5-53. You or others could be positioned at the bottom edge of replacement bulbs, see Replacement Bulbs on the bulb package.
5-47
For any bulb changing procedure not listed in this section, contact your dealer. Be sure to the horizontal tape line.
Owner's Manual - Page 291
... the trunk trim. Sidemarker B. Locate the bulb you have removed the trim, there will be one of these bulbs, do the following: 1. Pull the old bulb out of the socket. 9. Once you wish to reinstall the taillamp assembly.
5-51 Stoplamp/Turn Signal/Taillamp C. 5. Reverse Steps 1 through 6 to change 7. Open the trunk. Back-up Lamps...
Similar Questions
Headlight Replacement
how do I change headlight on2006 Chevy cobalt
how do I change headlight on2006 Chevy cobalt
(Posted by mburchfield63 8 years ago)
How To Change License Plate Bulb 2007chevy Cobalt
(Posted by jokeups 10 years ago)
How To Change License Plate Bulb 2007 Cobalt
(Posted by EkseaMark1 10 years ago)
Blinker Bulb
I just put a new blinker bulb in but the front one does not blink just burns
I just put a new blinker bulb in but the front one does not blink just burns
(Posted by dlabar 11 years ago)