Craftsman 25cc Support Question
Craftsman 25cc Support Question
Find answers below for this question about Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr.Need a Craftsman 25cc manual? We have 1 online manual for this item!
Question posted by sherazx2 on November 5th, 2012
What Do U Call The String U Pull When Trying To Start It
what do u call the string u pull when trying to start it
Current Answers
Related Craftsman 25cc Manual Pages
Operation Manual - Page 1
OPERATOR'S MANUAL
PROPANE POWERED LINE TRIMMER
16.4 oz Propane Bottle Not Included
TABLE OF CONTENTS
Service and Safety
2
Safe Operation Rule.s
3
Understanding Your Trimme...r
4
Assembly
5
Oil Information
6
Understanding Propan.e
7
Installing the Propane Canist.e..r
8
Installing Attachment.s
9
Starting / Stopping
10
Operation
11
Maintenance
12
...
Operation Manual - Page 2
...liability or a ne.
Replace damaged parts. Make sure all adjustments or repairs before starting the unit. le
• Th
Service on forest brush and/or grass-covered ... REPLACEMENTPARTS. SERVICE AND SAFETY
S
LEHR ECO-TRIMMER
IMPORTANT SAFETY INSTRUCTIONS
DU
4-CYCLE PROPANE TRIMMER
READ ALL INSTRUCTION BEFORE OPERATING
• Ne
For service call 1-866-941-LEHR in the United States, to...
Operation Manual - Page 3
...start...trimmer. The cutting attachment remains stationary when the engine is not in a stable position while starting...anything before starting .
... or try to ...pulling the starter rope. Refer to Starting/Stopping Instructions. (p.10) .
• Allow the engine to instruct other
• Always hold the unit with propane...starting . These
unit, also loan them these instructions. parts ...
Operation Manual - Page 4
... symbols or pictographs. I
ON/OFF STOP CONTROLS ON/START/RUN
o
ON/OFF STOP CONTROL OFF or STOP
KEEP...place. OTHER OPTIONAL ACCESSORIES MAY BE USED WITH YOUR UNIT
4
LEHR | ALL RIGHTS RESERVED 2008-2009
Keep away from the rotating...oil. WARNING: Indicates danger, warning or caution. UNDERSTANDING YOUR TRIMMER
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and ...
Operation Manual - Page 5
... evenly, until D-Handle is secure. Tighten the screws evenly. LEHR | ALL RIGHTS RESERVED 2008-2009
5 CuttingAttachment Shield
Spacer
INSTALLING THE D-HANDLE AND LOWER HANDLE
STRAIGHT SHAFT AND ACCESSORY READY
TRIMMERS 1.Locate the 4 screws included in (Fig. 1). Shaft Mount
Lower Handle
Fig. 3
CURVED SHAFT TRIMMERS 1. Installing the D-Handle (non detachable model). 2.
Make sure the...
Operation Manual - Page 6
... Motor Oil
Fig. 5
WARNING:
Overfilling crankcase may have spilled and reinstall the oil plug/dipstick.
6
LEHR | ALL RIGHTS RESERVED 2008-2009 It can cause premature engine wear and failure. Place the unit on ...Fig. 5). Remove the oil plug / dipstick from the exhaust. In order to avoid damage to start the unit. Your unit is extremely important. Oil ll plug/dipstick
Fig. 7
Oil Fill Hole...
Operation Manual - Page 7
...AFTER USE 1. Detach cylinder when not in well ventilated areas.
IN CASE OF FIRE 1. LEHR | ALL RIGHTS RESERVED 2008-2009
7 Use only in use tools to heat, sparks, or... if re - Check cylinder and appliance seals. Turn trimmer o and let cool. 2. UNDERSTANDING PROPANE
SAFETY WARNINGS FOR PROPANE UNITS NOTE: Use propane only in luggage or take the following precautions:
BEFORE ...
Operation Manual - Page 8
...BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. It may cause damage to the trimmer and potentially result in a dangerous leak. INSTALLING THE PROPANE CANISTER
USE THE CORRECT PROPANE CANISTER Always use the smaller diameter canisters as they will go (Fig... SMOKE. Make sure the engine is o . Fig. 9A
Canister Clamp
8
LEHR | ALL RIGHTS RESERVED 2008-2009
WARNING:
PROPANE IS EXTREMELY FLAMMABLE.
Operation Manual - Page 9
... to be used for edging only.
Upper Shaft Housing
Knob Fig. 10
Attachment Housing
Coupler
... 11), so that the engine is upright (propane tank on straight out of the cut ting ...(Fig. 10).
2. For edging (when using the string trimmer head cut ting attachment) lock the release button of ...shaft housing, pull the cutting attachment or add-on bottom) when unit is ready to use of a trimmer ...
Operation Manual - Page 10
...the unit stops.
Release your unit is equipped with propane.
5. Throttle Control Fig. 13
10
LEHR | ALL RIGHTS RESERVED 2008-2009
WARNING:
ALWAYS WEAR...STARTING/STOPPING
STARTING INSTRUCTIONS 1. Place trimmer rmly on OFF until the engine warms up the engine for the day, disconnect the propane canister from the throttle control. MAKE SURE YOU ARE IN THE STARTING POSITION WHEN PULLING...
Operation Manual - Page 11
...8226; Slowly move the trimmer into objects such as walls or fence posts HOLDING THE TRIMMER
Fig. 15
DECORATIVE TRIMMING Decorative trimming is cut
3. OPERATION
OPERATING YOUR TRIMMER Before operating the unit,...to the ground (Fig. 16).
30°
Fig. 16
LEHR | ALL RIGHTS RESERVED 2008-2009
11 Proper adherence to advance string. Rotate the whole unit so that the cutting attachment is ...
Operation Manual - Page 12
MAINTENANCE
FREQUENCY BEFORE STARTING ENGINE EVERY 10 HOURS FIRST CHANGE AT 10 HOURS EVERY 25 HOURS THEREAFTER E VERY 25 HOURS EVERY 25 HOURS
... PAGE 13 PAGE 13 PAGE 13 PAGE 14 PAGE 17
Perform these pro cedures call 1-866-941-LEHR for the location of the engine. NOTE: Failure to maintain your trimmer at the recom mended schedule may result in the table.
Place the unit on the oil ll
...
Operation Manual - Page 13
.... 19
Air Filter Base Plate
NOTE: Wear gloves to prevent accidental starting.
2. Re ll the crankcase with the dipstick. Check the level... the lter and remove excess oil.
6. Reinstall the air lter cover. LEHR | ALL RIGHTS RESERVED 2008-2009
13 Remove the oil ll plug/dipstick....plug boot to prevent injury when handling the unit.
4.
Then
pull the air lter cover out and upwards (Fig. 21) ....
Operation Manual - Page 14
...:
• the engine will restrict air ow.
ute to Starting/Stopping (p. 10) instructions.
2. Refer to warm up.
Grasp the plug wire rmly and pull the cap from the spark plug.
2.Clean dirt from the cylinder...engine problems. If not and all of engine power
Check the spark plug for an out of the engine is 0.02 in . (0.5 mm)
Fig.23
14
LEHR | ALL RIGHTS RESERVED 2008-2009 The cor...
Operation Manual - Page 15
...pull wire through top notches in place against spring pres sure (Fig. 28). Wrap line 180° and wind extra line in the opposite direction of rotation of the line are hooked in these instructions.
2.
Lines other than those speci ed may make the engine overheat or fail. LEHR...10.
MAINTENANCE
TRIMMER HEAD LINE INSTALLATION SMALL BUMP FEED HEAD (.080" Line)
1. Lock shaft by inserting ...
Operation Manual - Page 16
... (Fig. 32).
6. Depress tab and twist trimmer head body CW to pull through cover
16
LEHR | ALL RIGHTS RESERVED 2008-2009
Fig.3 7 ...pull through holes trimmer head body (Fig. 34). Close assembly in sequence as shown for straight shaft (Fig. 37). Tab
8. Wrap line 180° and wind extra line in (Fig. 35). If your model is a curved shaft, loosen by lining up the 4 tabs on trimmer...
Operation Manual - Page 17
...
the bottom shield attachment by using line trimmer head (Fig. 41). Remove the left-hand thread nut to lock the shaft.
Disconnect the spark plug wire.
Clamp ...Plate
Star Washer
Left-Hand Thread Nut
Fig.40
• For reassembly, install all components in the tool kit (Fig. 39). Engine cover screws
Fig.42
Engine cover screws
LEHR...
Operation Manual - Page 18
...10. DISCONNECT THE SPARK PLUG WIRE TO ENSURE THAT THE UNIT CANNOT START.
Remove the rocker arm cover and gasket (Fig. 43). Pull the starter rope slowly to bring the piston to the top of its...Replacing the Spark Plug (p.14).
11. Jam Nuts
Feeler Gauge Exhaust Valve Intake Valve
Fig.44
18
LEHR | ALL RIGHTS RESERVED 2008-2009 Slide a feeler gage between the rocker arm and valve stem (Fig...
Operation Manual - Page 19
...propane canister. Repair or replace damaged parts and tighten loose screws, nuts or bolts. TRANSPORTING • Allow the engine to cool before attempting to start the trimmer after storage. 3. LEHR... AND CLEAN THE CUTTING ATTACHMENT
DIRTY AIR FILTER ENGINE LACKS POWER OR STALLS WHEN CUTTING CAUSE BAD SPARK PLUG
CLEAN OR ...Pull the starter rope slowly to Federal, State and Local regulations.
4.
Operation Manual - Page 20
... RIGHT TO MAKE CHANGES AT ANY TIME WITHOUT NOTICE.
20
LEHR | ALL RIGHTS RESERVES 2008-2009
IDLE SPEED IGNITION TYPE IGNITION SWITCH VALVE CLEARANCE SPARK PLUG GAP LUBRICATION CRANKCASE OIL CAPACITY FUEL CARBURETOR STARTER MUFFLER THROTTLE DRIVE SHAFT AND HOUSING DRIVE SHAFT HOUSING THROTTLE CONTROL APPROXIMATE UNIT WEIGHT CUTTING MECHANISM LINE SPOOL DIAMETER...
Similar Questions
Need Parts For My Craftsman Propane Powered Trimmer-
Need a line trimmer cover and intake plate or how can I convert my propane engine to gas?
Need a line trimmer cover and intake plate or how can I convert my propane engine to gas?
(Posted by funkbrew 1 year ago)
Replacing Head On A Craftsman Gas Trimmer
How do you remove the head from a 29cc 4 cycle curved shaft 8-1 attachment gas trimmer? I want to pu...
How do you remove the head from a 29cc 4 cycle curved shaft 8-1 attachment gas trimmer? I want to pu...
(Posted by pollieut 9 years ago)
How To Remove The Trimmer Head On A Craftsman 4cycle 29cc Curved Shaft Trimmer
(Posted by jcamaar 10 years ago)
Craftsman 25cc Weed Wacker Wont Start
(Posted by miJwiggin 10 years ago)
Gas Blower Wont Start Under Warranty Can I Return It To Sears For A New Blower?
(Posted by johnvanderlaan 10 years ago)