Home » Craftsman » Lawn & Garden » Craftsman 25cc

Craftsman 25cc Support Question

Find answers below for this question about Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr.
Need a Craftsman 25cc manual? We have 1 online manual for this item!

Craftsman Overview Questions Manuals Reviews Videos Research

Question posted by Aflores1 on July 27th, 2014

Weed Wackier Suddenly Stopped

Weedwacker suddenly stopped and now it does not want to start. I notice the pull string different also.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Craftsman 25cc Manual Pages

Operation Manual - Page 1

LEHR | ALL RIGHTS RESERVED 2008-2009 OPERATOR'S MANUAL PROPANE POWERED LINE TRIMMER 16.4 oz Propane Bottle Not Included TABLE OF CONTENTS Service and Safety 2 Safe Operation Rule.s 3 Understanding Your Trimme...r 4 Assembly 5 Oil Information 6 Understanding Propan.e 7 Installing the Propane Canist.e..r 8 Installing Attachment.s 9 Starting / Stopping 10 ...

Operation Manual - Page 2

...State of California (Public Resources approached, stop the unit immediately. • Ad ... damaged in any time without notice. • Al •... • Carefully inspect the area before starting the unit. Do not allow children or...LEHR ECO-TRIMMER IMPORTANT SAFETY INSTRUCTIONS DU 4-CYCLE PROPANE TRIMMER READ ALL INSTRUCTION BEFORE OPERATING • Ne For service call 1-866-941-LEHR...

Operation Manual - Page 3

... propane ...pulling the starter rope. The operator and unit must always be in the starting...LEHR | ALL RIGHTS RESERVED 2008-2009 3 SAFE OPERATION RULES DURING OPERATION • Never start or run the engine at a distance from one cutting location to stop...trimmer. The cutting attachment remains stationary when the engine is delayed or when walking from all mov - Refer to Starting/Stopping...

Operation Manual - Page 4

...burned. UNDERSTANDING YOUR TRIMMER SAFETY AND INTERNATIONAL ...START/RUN o ON/OFF STOP CONTROL OFF or STOP KEEP SYSTANDERS AWAY WARNING: Keep all warnings and safety instructions. To prevent serious injury, do so can cause severe eye injury and hearing loss. OIL : Refer to do not touch the line cutting blade. OTHER OPTIONAL ACCESSORIES MAY BE USED WITH YOUR UNIT 4 LEHR...

Operation Manual - Page 5

... as shown (Fig.2). Attaching Screws D-Handle Cap Washer Fig. 1 Attaching Screws FOR STRAIGHT SHAFT TRIMMERS Place the cutting attachment shield onto the shaft mount. Make sure the shield does not touch any rotating parts. Shaft Mount Lower Handle Fig. 3 CURVED SHAFT TRIMMERS 1. Installing the D-Handle (non detachable model). 2. LEHR | ALL RIGHTS RESERVED 2008-2009 5

Operation Manual - Page 6

...Oil (p.13). Wipe up any oil that may cause hot oil to drip from air filter, and smoke to start the unit. ADDING OIL TO THE CRANKCASE INITIAL USE NOTE: This unit is extremely important. It can cause ... Fig. 5 WARNING: Overfilling crankcase may have spilled and reinstall the oil plug/dipstick. 6 LEHR | ALL RIGHTS RESERVED 2008-2009 Check the oil before each use and change as needed .

Operation Manual - Page 7

..., a penalty up to heat, sparks, or ame. To discard, contact local refuse hauler or recycle cen ter. Turn trimmer o . 3. DURING USE Never use . 3. Replace cap to tighten. LEHR | ALL RIGHTS RESERVED 2008-2009 7 Propane is a trademark of escaping gas. Never re ll a disposable cylinder. Listen for this unit. Do not use where people...

Operation Manual - Page 8

... size. Fig. 9A Canister Clamp 8 LEHR | ALL RIGHTS RESERVED 2008-2009 WARNING: PROPANE IS EXTREMELY FLAMMABLE. ALWAYS STOP THE ENGINE AND ALLOW IT TO COOL BEFORE REPLACING THE PROPANE CANISTER. ATTACHING THE PROPANE CANISTER 3. WARNING: EXTREMELY FLAMMABLE FIRE/ EXPLOSION HAZARD CONTENTS UNDER PRESSURE. If the propane canister to the trimmer and potentially result in . Make sure...

Operation Manual - Page 9

While rmly holding the upper shaft housing, pull the cutting attachment or add-on a work bench to make accessory installation or removal easier. 1. REMOVING CUTTING ATTACHMENTS OR ADD-ONS 1. Unit is ready to be used in the upright position while operating. For edging (when using the string trimmer head cut ting attachment) lock the release...

Operation Manual - Page 10

.... Allow the engine to 30 seconds. Stop/O Safety trigger Start/On(I) WARNING: AVOID ACCIDENTAL STARTING. MAKE SURE YOU ARE IN THE STARTING POSITION WHEN PULLING THE STARTER ROPE. (FIG. 14) TO AVOID SERIOUS INJURY, THE OPERATOR AND UNIT MUST BE IN A STABLE POSITION WHILE STARTING. Throttle Control Fig. 13 10 LEHR | ALL RIGHTS RESERVED 2008-2009 WARNING...

Operation Manual - Page 11

...angle to the ground (Fig. 16). 30° Fig. 16 LEHR | ALL RIGHTS RESERVED 2008-2009 11 OPERATION OPERATING YOUR TRIMMER Before operating the unit, stand in a forwardbackward or side-to-side...shaft grip. • The operator's left arm is straight, the left hand hold the knob on ground to advance string. Cutting shorter lengths produces the best results. • Trim only when grass and weeds...

Operation Manual - Page 12

Stop the engine and allow to get a.... 18) and recheck. Oil Fill Hole Fig. 18 12 LEHR | ALL RIGHTS RESERVED 2008-2009 MAINTENANCE FREQUENCY BEFORE STARTING ENGINE EVERY 10 HOURS FIRST CHANGE AT 10 HOURS EVERY 25 ... 13 PAGE 14 PAGE 17 Perform these pro cedures call 1-866-941-LEHR for the location of your trimmer NOTE: Some maintenance procedures may be performed by any seasonal tune-up....

Operation Manual - Page 13

... oil ll hole and into a container by tipping the unit to its side (Fig. 19). Then pull the air lter cover out and upwards (Fig. 21) . 2. Dispose of operation. Position the hooks...poor performance or can cause permanent damage to prevent accidental starting. 2. NOTE: If the unit is an important item to lightly coat the lter. 5. LEHR | ALL RIGHTS RESERVED 2008-2009 13 If the level ...

Operation Manual - Page 14

...torque wrench torque to cool. Grasp the plug wire rmly and pull the cap from the spark plug. 2.Clean dirt from the... trigger and let the engine idle. ute to Starting/Stopping (p. 10) instructions. 2. Remove the plug after...Start the engine and let it to : 110-120 in . This is a loss of engine power...LEHR | ALL RIGHTS RESERVED 2008-2009 socket clockwise until the engine idles smoothly.

Operation Manual - Page 15

...in place and the direction it . 5. Lock shaft by turning CCW (Fig. 25). 8. Trimmer Head Body Spring Reel Bump Feed Button Nut Fig....25 4. Un-wind and remove the remnants of the head as shown (Fig. 24). 3. LEHR...reel. Pull reel out of line 7.5 ft (2.28 m) long. If using new line from a bulk spool, cut 2 pieces of trimmer body, ...

Operation Manual - Page 16

...pull through cover 16 LEHR | ALL RIGHTS RESERVED 2008-2009 Fig.3 7 Turn CCW until "click" (Fig. 36). Fig.33 5. Lock shaft by turning head as shown for straight shaft (Fig. 37). Retention Hook Fig.36 9. Trimmer...as shown for curved shaft and opposite for straight shaft. Top view Tab "click" Trimmer Head Body Fig.32 3. If your model is a curved shaft, loosen by ...

Operation Manual - Page 17

.... If you feel unsure or unqualified to perform this, take the unit to lock the shaft. Brush Cutter Blade 4. NOTE: Inspect the valve to dissasemble with `a feeler gage after the... screws Fig.42 Engine cover screws LEHR | All Rights Reserved 2008-2009 17 NOTE: When using the brush cutter blade remove the bottom shield attachment by using line trimmer head (Fig. 41). Hole 2....

Operation Manual - Page 18

... MAINTENANCE OR REPAIRS WITH UNIT RUNNING. Jam Nuts Feeler Gauge Exhaust Valve Intake Valve Fig.44 18 LEHR | ALL RIGHTS RESERVED 2008-2009 Readjust if necessary. 4. Clean dirt from around the rocker arm cover...Take care to insert too thick a feeler gauge and accidentally depress the valve and spring. Pull the starter rope slowly to bring the piston to the top of its travel by looking...

Operation Manual - Page 19

...screws, nuts or bolts. LEHR | ALL RIGHTS RESERVED 2008-2009 19 Remove propane canister. 2. Pull the starter rope slowly to... STOP ENGINE AND CLEAN THE CUTTING ATTACHMENT DIRTY AIR FILTER ENGINE LACKS POWER ...propane canister. WARNING: TO AVOID SERIOUS INJURY, ALWAYS TURN YOUR UNIT OFF AND ALLOW IT TO COOL BEFORE YOU SERVICE IT. TRANSPORTING • Allow the engine to start the trimmer...

Operation Manual - Page 20

...NOTICE. 20 LEHR | ALL RIGHTS RESERVES 2008-2009 SPECIFICATIONS ENGINE* ENGINE TYPE DISPLACEMENT CLUTCH TYPE OPERATING R.P.M. ELECTRONIC PUSH ON/OFF SWITCH 0.076-0.152MM (0.003-0.006 IN) 0.020 INCH (0.5 MM) SAE 10W-30 OIL 1.7 FLUIDOZ. (50mL) PROPANE... CAPACITY FUEL CARBURETOR STARTER MUFFLER THROTTLE DRIVE SHAFT AND HOUSING DRIVE SHAFT HOUSING THROTTLE CONTROL APPROXIMATE UNIT WEIGHT CUTTING ...