Dell 6224 Support Question
Find answers below for this question about Dell 6224 - PowerConnect Switch - Stackable.Need a Dell 6224 manual? We have 1 online manual for this item!
Question posted by mknathantpt on May 22nd, 2012
Creating Private Vlan In Dell 6224 Switch
Current Answers
Answer #1: Posted by WMatDell on May 22nd, 2012 4:31 PM
console# configure
console(config)# vlan database
console(config-vlan)# vlan xx
console(config)# interface vlan xx
console(config-if)# name xxxxxxxx
console(config-if)# end
Commands used to configure a port for a specific VLAN:
console# configure
console(config)# interface ethernet XX
console(config-if)# switchport mode access
console(config-if)# switchport access vlan XX (whatever VLAN you want for interface)
console(config-if)# end
You would need to run the same commands on every interface or a range of interfaces to set up each VLAN.
Command to verify set up:
console# show vlan
Vlan Name Ports Type Authorization
---- ----------------- --------------------------- ------------ -------------
1 1 e(1-10,12-24),g(1-4), other Required
100 Finance e11 permanent Required
When connecting to another switch or router you will need a trunk on that interface to allow all VLANS to move across to the other device.
console# configure
console(config)# interface ethernet e11
console(config-if)# switchport mode trunk
console(config-if)# switchport trunk allowed vlan add 100
console(config-if)# end
If you are wanting to communicate from one VLAN to the other then you would need VLAN routing enabled on the switch.
console(config)# ip routing (enables routing globally on the switch)
console(config)# interface vlan 100
console(config-if-vlan100)# ip address 172.16.100.1 /24
console(config-if-vlan100)# routing (enables routing on this specific VLAN)
console(config-if-vlan100)# exit
Related Dell 6224 Manual Pages
Similar Questions
Is there any network simulator for Dell switches like packet tracer in cisco?