Getting A 'no-signal' Message On The Tv

I have turned on the TV and I have pushed the IMPUT button and indicated TV but the only message is "no signal". Can you please advise me as to the correct settings to be able to watch television programs. Thank you, Daniel

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyFwithDISHNetwork on November 27th, 2012 7:01 AM

This answer was accepted by the poster of the original question.

TommyFwithDISHNetwork

Member since:
December 23rd, 2010

Points: 146,120

1,070
points

dymonddan709,

I can definitely provide assistance on this.

First, make sure the cable you're using on the TV. If you are using a CoAxial cable, the TV will need to be on Ch. 3/4 (if TV1) or Ch. 60/73 (if TV2). If you are using a component cable or composite cable (Red, Yellow, White or Red, Green, Blue), verify the port it's plugged into on the TV, and change the input to that port. If you have an HDMI cable, change the input to HDMI.

If you have any other questions, let me know!

Tommy Faust
DISH Social Media Representative
Sunday-Wednesday 6A-5P MST
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : DISH 501/508 : Receiver Information : Receiver Images
... an event title, the name of the program you set up /down blue arrow buttons and Select to a pre-programmed channel when it and type in . This will allow some 508 systems were packed with Dolby Digital capability. text indicator appears in the EPG. Menu to find a program listing based on the same channel number range...
Tech Portal : 3750 : Errors & Troubleshooting
... shown on the correct channel, it is snuggly connected from a VCR tape any problems with the message from the wall is unlocked. Verify the TV is connected to the TV? The TV input source must match these channels cannot be set to complete (up . If only the program banner appears, use the remote control Recover button to next...
Tech Portal : (choose receiver model) : Errors & Troubleshooting : Video Distorted (Poor Quality)
... the Menu button on the ...TV S Video input. Either 061 message or black screen with the receiver. Change the TV to Preferences then Updates. If the television has multiple TV ANT or RF inputs verify that the TV ...hand tight from the receiver to watch satellite programming. If good, bypass the VCR or DVD player using the cable from the receiver TV SET OUT to reconnect the receiver properly...