I Am Mirroring Tv2. How Do I Get Two Remotes To Both Work Tv2?

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyFwithDISHNetwork on October 9th, 2012 8:31 AM

This answer was accepted by the poster of the original question.

TommyFwithDISHNetwork

Member since:
December 23rd, 2010

Points: 146,120

1,090
points

tauber,

In order for two remotes to work tv2, all you need is a second UHF remote with a blue tab with a 2 in it.

Once you have that, access the System Information screen from the TV1 and note the number where it says "Secondary Remote Address". On the second TV2 remote, hold down SAT until all the lights on the top turn on, then let go and it will be blinking. Enter the number for your TV2 location and press #.

After that, try the remote and see if it's working! If you have any other questions, just let me know.

Tommy Faust
DISH Social Media Representative
Sunday-Wednesday 6A-5P MST
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...still nothing, press the Info button on the Receiver's home page? Once this manner If the remote works when it is a replacement receiver, verify the UHF antenna off the receiver and unplug the ...TV1 location, verify the TV1 UHF Pro Setup is Enabled. Power receiver/all others. The TV2 remote will move from the front panel. Either switch to enter a number other electronic equipment (...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... obstructions and within 40 feet of an entertainment center. Verify the remote is UHF only, the kit will not work in SAT mode. Please contact us or a local independent retailer ...lighting, or obstructions to the IR sensor like a glass door of the receiver. Does the remote work . For additional information on the front of the upgrade kit for assistance. Please refer to ...
Tech Portal : Remotes : Troubleshooting
... or UHF is the correct setting for this manner. If the remote works when it is close to female F-connector). UHF – TV2 location or TV1 if UHF is moved). Reposition the UHF remote antenna (horizontal instead of impact on the remote. Relocate the receiver away from other electronic equipment (be aware of vertical). Verify the...