Problems With Box After We Dis Connected And Re Connected Box.

We removed the satellite dish box from our sons room for two weeks as a form of punishment now that we reconnected the box we only have the dish "help" info channels .... how do we get our reg channels back???

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MikeHDISHNetwork on December 10th, 2012 12:05 PM

This answer was accepted by the poster of the original question.

MikeHDISHNetwork

Member since:
December 23rd, 2010

Points: 51,920

1,100
points

Hi tgar1415, my name is Mike Houston a Social Media Representative at DISH. I am happy to help you in getting programming back on your sons TV. Please try and unplug the receiver for 10 seconds and plug it back in, allow the receiver to acquire the signal and download the program guide. If the issue still persists please e-mail me at: [email protected]

Mike Houston DISH Network

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 222k : Errors & Troubleshooting : Video Distorted (Poor Quality)
... or channel. Unplug then reinsert the cable. TV1 TV2 TV1 and TV2 Tune the TV to reconnect the receiver properly. Yes No Use the wiring diagram located under Install to a video input source. Verify both modulator settings as this is connected from the receiver Home Distribution coax output to watch satellite programming If the problem...
Tech Portal : Errors & Troubleshooting : Video Pixels, Blocks, Audio Pops
... ' mount, or damage to the dish due to be removed. Connector Color Code Chart Reconnect the correct cable coming from the satellite dish connected hand tight? If you had any rain fade or snow fade issues. Check field . How To? One receiver (1 of 1) Two or more receivers but only one is experiencing a problem (1 of alignment, it is...
211/411 : Error 002
... color is out of sight. Go to the channels that were having the issue and verify they should be the most likely problem. Go to System Setup, Installation, then Point Dish Select Check or Check Switch on trees since your satellite dish? You have been removed or the dish has been moved if needed, the signal will...