Question posted by Debiw3 on November 28th, 2015
No Sound On Vs 2 And 3
sound works fine on tv1 where the hopper is located. But both tvs 2 and 3 have no sound. I have rebooted all three tvs and hoppers and joeys to no avail.
Current Answers
Answer #1: Posted by waelsaidani1 on November 28th, 2015 8:29 PM
sometimes this is a problem with the HDMI connection on your tv. this usually will fix itself by resetting the receiver, or changing hdmi inputs on the tv.
if you are not using HDMI, you are probably using component cables (RED,GREEN,BLUE) if this is the case, you must also run red,white RCA for sound to the connections next to rhe R,G,B connection
if you are not using HDMI, you are probably using component cables (RED,GREEN,BLUE) if this is the case, you must also run red,white RCA for sound to the connections next to rhe R,G,B connection
Dish Network Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Tech Portal : 942 : Install : 942 Initial Install
...TV that show the correct LNBF(s), switch(es), and satellite locations. Program TV mode and limited mode as needed: Program each remote TV to the TV...TV. If you can see a picture, make sure that you do so at the nearby HDTV, go to or on either remote. See the user’s guide that the Recover button works... Attach the TV1 sticker somewhere close to the Modulator Setup menu by pressing ... -
Tech Portal : 942 : Receiver Information : Receiver Images
... Control Locks from the Daily Schedule screen. Press the Info button for full DVR functionality. PIP not available. PIP available. A hybrid of timers varies by prompting you watch programming on TV1 and black screen with the other TV. Super Diagnostics Super Diagnostics allows faster access to hard drive. This application is built into the... -
Tech Portal : Remotes : 6.4 IR/UHF Pro : Troubleshooting
... they are using the correct key that came with the replacement remote and not with the working location. For keyed remotes: Change the A/B switch configuration for assistance. Go to IR-to -UHF...on the remote. Select Installation (Skip if 721 or 921). TV1, usually located where the receiver is being used in the home? IR TV/VCR/AUX Mode SAT In AUX Mode If the batteries are ...
Similar Questions
Tv2 Remote Doesn't Work When Tv1 Is In Use
(Posted by mksg 10 years ago)
Dish Network Tv 2 Remote Does Not Work If Tv1 Is On
(Posted by tommyajsaga 10 years ago)
My Dish Remote For Tv2 Will Only Work On Tv1
(Posted by Trouvd 10 years ago)
Hopper Was Working Fine Till Now Flashing Acquiring Signal.
This morning I woke up to my hopper and joeys not working. The hopper refused to turn on by remote s...
This morning I woke up to my hopper and joeys not working. The hopper refused to turn on by remote s...
(Posted by Armstras06 10 years ago)
Hd Tv1 Has No Signal At Night, Worked Fine In The Morning. Tv2 Worked Fine.
(Posted by Anonymous-70183 11 years ago)