Dish Control Guide Button Does Not Work

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
.... TV Channel Control button turns receiver off for more information. The TV light flashes. TV stays on . Release the antenna button. TV light stays on . See the User's Guide that receive an...control's memory. If the VCR is on . button to make sure your VCR Advise the customer to go to make sure they work. 0 through all of flashes. EZ Remote : Functionality Will operate most DISH...
Tech Portal : Remotes : Buttons & Images
... all four mode buttons flash three times. Guide Button - Press this button to go back to switch from your satellite video. Scroll through the Program Guide by page, through a few frames at a time in the following section, the remote control sends commands to work . Press this button to open the Program Guide. Record Button - The SAT mode button flashes twice and...
Tech Portal : 3750 : Errors & Troubleshooting
... receiver and TV are red in the Electronic Program Guide, press the Guide button on the receiver. Power None The receiver will be...in the receiver, TV or amplifier. If the outlet is controlled by a light switch. If PPV channels are missing from...recorded tape into a working wall jack directly to System Setup (skip if model 1000), Installation, and Point Dish/Signal. Initial Install...