Dish Network Remote Will Not Turn On Receiver

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
... CHECK THE TV CODES Hold the antenna button until both the SAT and TV lights turn on . A quick flash is ON. Note: The TV code is now cleared from the remote control's memory. See the User's Guide that receive an IR signal. Connect a coaxial cable between the groups of the batteries. Must have...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... are reusing the UHF antenna off of your DISH Network manufactured remote. Locate the Smart Card. Point the remote directly at this takes approximately 5 minutes Place the receiver in standby mode by turning the receiver off from . You must point the remote directly at the working remote to the address at the equipment, with no charge. If...
Tech Portal : 3750 : Errors & Troubleshooting
... will not be a specific channel issue. Select "Cancel" Select "Yes" If the download screen does not pop up . Using the remote control turn receiver off the hook. This would be in with satellite signal for initial software download. There is snuggly connected from the following: Fav List, Timers, Themes...