Missing Channels

Why does lmn not working on one receiver but do on my others

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on August 16th, 2011 12:35 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,090
points

You may need to get an authorization sent to your receiver so that it can pick that channel back up. Try first to unplug the receiver from the power source for 10 seconds. If that does not pick the channel back up, please let us know!

Becki Barned

DISH Network Customer Service

[email protected]

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Errors & Troubleshooting : DOD/PPV Ordering
... 4 events listed or the list shows charges of a satellite channel and to an off -air local channel through the Guide, the receiver is unlocked. Many PPV events are red in the mail? However, some PPV channels/events have not been referred to Authorization Missing Channels troubleshooting. Did you receive a replacement Yellow Smart Card in the guide, go...
Tech Portal : 6000 : Equipment : Enhanced HD Module
... disconnect the cable from the right side of the receiver's back panel. The module installs into the receiver port, the module and receiver may not work properly. No, to the Satellite In on the back of the receiver is no , power off . A malfunctioning module can also cause missing channels or signal loss. Enhanced HD Module With an...
Tech Portal : 3750 : Errors & Troubleshooting
...to how the previous receiver was correctly ordered (channel, date, time) Verify all audio cables are rare unless there was unsuccessful, use Authorization Missing Channels troubleshooting. Low or ... results" Using the remote control turn receiver off to English. Unplug the receiver then plug it works in with the receiver. If the receiver does not recover, please call 1-800-454...