Question posted by w704johnd on April 13th, 2014
I Pushed The Wrong Remote And Now The Cable Remote Won't Work
Current Answers
Answer #1: Posted by kimesco on April 14th, 2014 9:30 AM
Please follow the instructions below to readdress your remote to your receiver. If this does not resolve your issue please send me an email at [email protected] with more details. Thank you!
1. Press the menu button on the front of the receiver.
2. Press and hold down the SAT button on the remote until all the lights are lit.
3. Enter any number 1-15 on the remote keypad.
4. Press the pound(#) button once.
5. Press the record button 3 times.
Kimberly Escobar
Social Media Representative
DISH L.L.C
Dish Network Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Tech Portal : (choose receiver model) : Equipment : IR-to-UHF Upgrade Kit
... the converter and place the IR blaster tip next to -UHF Pro Upgrade Kit work the same as the signal converter is correct. If the converter will not fit, plug an IR extender cable into the remote. Verify the remote is ON. FAQ: Will the IR-to the DISH Network receiver. The UHF Pro... -
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...remote antenna jack and connect the cable to the UHF antenna using a Samsung LN-R408D or LN-R409D television, the issue will initiate reinitialization of the remote control.) Are there any other electronic equipment, including TVs, VCRs and stereos, that now shows the System Info screen. Point the remote directly at the working remote... you press the non-working remote. Go to go away... -
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... change on the front of paper. It will attenuate or reduce the interference coming into the receiver. Run the cable away from wrong remote. For IR ONLY, cover the receiver's IR sensor with the problem remote. Press the System Info button on it's own to the UHF Antenna connection on the front of the...
Similar Questions
My remote will not work how do i program it for my symphonic tv
Hooked up new HDTV to dish network receiver via HDMI cable--reception is great--able to use the butt...
My remote won't work during nighttime unless I turn off the dig box everytime I change channels or I...
today i changed my tv's around so the tv that used to be tv1 is now tv2 just on the other side of th...