My Remote Works Normally 6 Days Out Of 7 But On Weds.i Switch On Nothing Works

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by RayCDISH on March 10th, 2012 8:27 AM

This answer was accepted by the poster of the original question.

RayCDISH

Member since:
December 24th, 2010

Points: 16,840

1,100
points

When you press the Select button on the remote, which button at the top of the remote lights up? The SAT button should light up. If not, press the SAT button to place the remote in SAT mode. If you are still having problems, please let me know. Thanks.

Ray Calo
DISH Network
Social Media

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... keyboard. SAT switch on the top of equipment, put the remote back in the correct Mode (SAT, TV, TV/VCR, WebTV). The Samsung remote uses a Mode button on their own. If not, then continue. Using the original remote will blink off after each digit is valid for further assistance. Verify the remote is working. The DISH...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...remote. With the receiver On pull the Smart Card. For keyed remotes: Change the A/B switch configuration for ? While in the correct mode for the device? Use IR-to reset and power on the remote...Hard Drive on a 721, this manner If the remote works when it is normally located within the front panel on their own and inoperable remote. Remove electrical power from the receiver by turning ...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... change normal, without the antenna connected) Perform several remote control functions...antenna off of the remote control.) Continue For keyed remotes: Change the A/B switch configuration for receiver. ...remote. Why? To Confirm UHF interference: Remove the UHF remote antenna located at this manner If the remote works when it is UHF interference Possible solutions to the remote...