2009 Dodge Journey Support Question
2009 Dodge Journey Support Question
Find answers below for this question about 2009 Dodge Journey.Need a 2009 Dodge Journey manual? We have 2 online manuals for this item!
Question posted by cbcollision on July 2nd, 2015
Esp/bas Light
on a journey 2009 changed the switch as per recommendation by dealership, Problem not fixed. if I turn the engine off, it would not start right away, and it would not shift from park to drive. this started after I took it back on a recall on July 23 2015. The vehicle was working fine before I took it to the dealership.
Current Answers
Answer #1: Posted by TechSupport101 on July 4th, 2015 10:43 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,295
Member since:
May 24th, 2013 Points: 12,171,295
For the best assistance on the issue, it would be best to see your nearest Dodge dealer again. Explain you story and you should be assisted ideally at no charge.
Related Manual Pages
Owner's Manual - Page 25
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 23
NOTE: Pressing the LOCK button on the transmitter to lock all doors and liftgate.... on vehicles equipped with the transmitter. The turn signal lights will flash and the horn will cause the alarm to acknowledge the signal. Then, press the PANIC button while still holding the LOCK button. 2. To change the current setting, proceed as follows: &#...
Owner's Manual - Page 50
... the BeltAlert will continue to chime and flash the Seat Belt Reminder Light for the Seat Belt Reminder Light to turn off and then proceed to the next step. NOTE: Watch for ...instruct all doors closed, and the ignition switch in any position except ON or START, buckle the driver's seat belt. 2. Turn the ignition switch to the ON position, (engine does not need to be necessary to retract...
Owner's Manual - Page 59
... commands Airbag Warning Light operation. Ignoring the Airbag Warning Light in your instrument panel could mean you start -up. These include all of the instrument
2 If the light does not come on, stays on . A single chime will sound if the light comes on again after you won't have the airbag system checked right away. • The Driver...
Owner's Manual - Page 123
...other commands can be prompted to repeat it. When using this system, you can add or change commands. At any menu. Local commands are closed, and the heater/air-conditioning fan is...example, if you are in ." The system will be used depending upon the active application. Changing the Volume 1. Start a dialogue by pressing the VR hard-key. 2. Global commands are available at a normal ...
Owner's Manual - Page 150
... the front fog lights, turn ON the parking lights or the low beam headlights and pull out on as Daytime Running Lights (DRL) and operate at DRL (lower) intensity, whenever the ignition is ON, the engine is running, the HEADLIGHT switch is off, the parking brake is off, the turn signal is off, and the shift lever is turned to the...
Owner's Manual - Page 153
... the UNLOCK button on the Remote Keyless Entry (RKE) transmitter, open a door or the liftgate, or turn OFF the light manually. Press and release the lens to turn ON or turn the Dimmer Control completely upward to direct the light as desired. A courtesy light is mounted in the headliner above the second row passenger seats. These...
Owner's Manual - Page 178
...length of time to allow the alternator to degrade battery life and/or prevent engine starting. • Accessories that can power small appliances and electronic devices.
Eventually, ... OF YOUR VEHICLE
Electrical Outlet Use With Engine Off
CAUTION!
• Many accessories that draw higher power (i.e., coolers, vacuum cleaners, lights, etc.) will discharge sufficiently to recharge the...
Owner's Manual - Page 208
... range. Driving with the A/C turned off . 206 UNDERSTANDING YOUR INSTRUMENT PANEL
4. Further overheating will sound.
If the A/C system is allowed to pass H.
If the temperature gauge reads "H," safely pull over and stop the vehicle. Coolant Temperature Warning Light This light warns of an overheated engine condition. If the light turns on , turn the engine OFF immediately...
Owner's Manual - Page 211
...is changed because of repair or replacement, be determined. Fuel Cap Fault Message If the vehicle diagnostic system determines that the correct mileage can be sure to turn
4..."LoCOOL" (low engine coolant), "LoWASH" (low washer fluid), "gASCAP" (fuel cap fault), "ESPOFF"
(ESP in partial off mode), "NoFUSE" (IOD fuse out), "HotOIL" (2.4L engine oil temp too hot), or "CHANgE OIL" will display...
Owner's Manual - Page 212
... the following procedure: 1. A loose, improperly installed, or damaged fuel filler cap may fluctuate dependent upon your personal driving style. The engine oil change indicator system is started. Unless reset, this procedure. Turn the ignition switch to the ON position. (Do not start the vehicle, the oil change indicator system (after a single chime has sounded to the LOCK position.
Owner's Manual - Page 213
... when the ignition switch is started. This light will turn on and remain on briefly as possible, place the shift lever in the engine. DO NOT OPERATE THE VEHICLE UNTIL THE CAUSE IS CORRECTED. Electronic Throttle Control (ETC) Warning Light - If Equipped This light will also turn off after the engine is turned ON. The light will turn on during starting, have the system...
Owner's Manual - Page 217
....) 24. The light will turn on while driving, it indicates that the Anti-Lock portion of the brake system is not functioning and that it is not on for more information.)
23. However, the conventional brake system will turn on when the ignition switch is turned to assure that service is in the ON position before engine start . The...
Owner's Manual - Page 218
... will drive normally and will turn the light on when the ignition switch is running , severe catalytic converter damage and power loss will turn on continuously while the engine is turned to the emissions control system. The system will soon occur. Electronic Stability Program (ESP)/Brake Assist System (BAS) Malfunction Indicator Light - If Equipped The yellow ESP/BAS Malfunction...
Owner's Manual - Page 227
..." message will continue to display each time you start the engine). 2. The engine oil change indicator system is equipped with an engine oil change indicator system. To reset the oil change interval. Turn the ignition switch to the LOCK position. If necessary, repeat this message will display in Ignition • Lights On Oil Change Required Your vehicle is duty cycle based...
Owner's Manual - Page 306
... Parking Brake ...323 Brake System ...326 ▫ Anti-Lock Brake System (ABS) ...327 Electronic Brake Control System ...328 ▫ Anti-Lock Brake System (ABS) ...328 ▫ Brake Assist System (BAS) ...330 ▫ Traction Control System (TCS) ...331 ▫ Electronic Roll Mitigation (ERM) ...331
▫ Electronic Stability Program (ESP) ...332 ▫ ESP/BAS Warning Light And ESP/TCS...
Owner's Manual - Page 335
... from excessive speed in the switch bank above the climate Control. The capabilities of an ESP-equipped vehicle must never be used for specific reasons as possible. ESP cannot prevent the natural laws of others.
5 STARTING AND OPERATING 333
active. The ESP/TCS Indicator Light also flashes when TCS is located in turns, driving on the vehicle, nor...
Owner's Manual - Page 336
..., or when starting off with the engine running . If the ESP/BAS Malfunction Indicator Light turns on when the ignition switch is in motion.
If this light remains on by momentarily depressing the ESP OFF button. They should both . This may be done while the vehicle is turned to have the problem diagnosed and corrected. ESP/BAS Warning Light and ESP/TCS Indicator Light The...
Owner's Manual - Page 337
...: • The ESP/TCS Indicator Light and the ESP/BAS Malfunction Indicator Light will turn on momentarily each time the ignition switch is turned ON. • Each time the ignition is turned ON, the ESP System will be reduced, and you will feel the brake being applied to individual wheels in an attempt to follow the tongue weight recommendations. This is...
Owner's Manual - Page 424
... the problem persists, the message will see the MIL symbol come on as you turn on when the engine is ready, you must do not crank or start the engine. 3....Light (MIL) is functioning and is started. Insert the ignition key into the ignition switch. 2. To check if this test over. 4. Failure to the ON position, but do the following: 1. If the OBD II system should be ready. Turn...
Owner's Manual - Page 466
...Description Anti-Lock Brake System (ABS), Electronic Stability Program (ESP), STOP LIGHT Switch Lock/Unlock Motors Ignition Run/ Accessory Relay Ignition Run Relay Starter Solenoid Relay Ignition Run/Start Relay (NGC) Powertrain Control Module Relay
K6 K7 K8 K9... mini-fuses from the Totally Integrated Power Module located in the engine compartment. • Or, disconnect the batter negative cable.
Similar Questions
Resetting Esp/bas Light When Tire Changed On 2009 Dodge Journey
(Posted by chardonnab 10 years ago)
2010 Dodge Journey Esp Bas Light Brake Lights Wont Turn Off
(Posted by xantRow 10 years ago)
Esp Bas Lights On
I was in a car accident recently and no lights were on before the accident, The damage was done to t...
I was in a car accident recently and no lights were on before the accident, The damage was done to t...
(Posted by jui22cey 11 years ago)
Esp Bas Light
after 2or 3 miles the esp bas light come on and stays on if i stop and shut off the car it go off bu...
after 2or 3 miles the esp bas light come on and stays on if i stop and shut off the car it go off bu...
(Posted by ramos1373 11 years ago)