Frigidaire AEQ6700FS Support Question
Frigidaire AEQ6700FS Support Question
Find answers below for this question about Frigidaire AEQ6700FS - 27" Electric Dryer.Need a Frigidaire AEQ6700FS manual? We have 5 online manuals for this item!
Question posted by victoria0329 on July 22nd, 2012
Err-68
Everytime i put the dryer in function it comes out err-68.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on July 24th, 2012 10:52 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Related Frigidaire AEQ6700FS Manual Pages
Use and Care Guide - Page 3
...the fault. All safety of life. - Risk of an overheated situation (electric dryers only). The dryer must be connected to the dryer: • All repairs and servicing must be performed by an authorized ... etc.
Do not stack or place laundry or throw rugs against the front or back of lint around the outdoor exhaust opening and in the dryer. Failure to cooking oils in U.S.A. Children...
Use and Care Guide - Page 4
...ELECTRIC DRYERS:
DRYER
FUSED 30 AMP 120/240 V OR 120/208 V WALL
CORRECT
DRYER SERVICE
Grounding type wall receptacle
GAS DRYERS...turns off the light. Select Timed Dry.
The dryer will come to the dryer.
4 Allow the drum to prevent snagging and ...and laundry product labels. Reversible Dryer Door Your dryer is clean and in a mesh bag.
2. Place items to illuminate the dryer drum...
Use and Care Guide - Page 5
...dryer without heat.
• Remove items when they are slightly damp to
cycle began.
• Use lint brush or roller to remove lint. ENGLISH
Do not store or place laundry... Important Safety Instructions and those listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to avoid electrical shock hazards.
• Do not use harsh, gritty or abrasive
cleansers...
Use and Care Guide - Page 6
... must have anough air supply to a 208 volt circuit.
Reset circuit breaker or replace fuse. Make sure electrical line is not overloaded and the dryer is blown, the drum may save both time and expense. Electric dryer is clogged with lint.
Lint screen is connected to support the burner flame (gas models).
The list...
Parts Catalog - Page 1
....eps
Electrolux Major Appliances North & Latin America P.O. All rights reserved. BOX 212378 AUGUSTA, GA 30917
Publication No. 5995497798 07/08/21
(EN/SERVICE/WTC) 361
ELECTRIC DRYER
Model No. AEQ6700f
Copyright © 2007 Electrolux Home Products, Inc. Product No.
Parts Catalog - Page 3
..., w/housing/felt Baffle, heater shield Screw, 10-16AB x 0.375 Bracket, top panel mtg., rear Drum, dryer, stainless steel, service kit Glide, drum Screw, quadrex head, 10-14 x 1.00, vane mtg., special ... Stacking Kit (not incl w/unit), dryer/washer
* #
5303281153 Rear Bearing Kit, includes 5, 6, 12, 13, 14, 18, 32
Publication No: 5995497798
# Functional Parts
3
* Non-Illustrated Parts
08/07
Parts Catalog - Page 5
... # 9 16 20
20* 21 22 25 26 # 27 28 33 34 39 41 43 44 45 46 47 48 48* 49 50 52 53 56 58 #
58*# 60 62 64 66 68 70
PART NO. 134417000 131168200 134382900 131845802 131633200 134440100 134440200
...Affinity, chrome T-Plug, hinge hole Plug, hinge hole, gray Plug, rectangular, gray
Publication No: 5995497798
# Functional Parts
5
* Non-Illustrated Parts
08/07 AEQ6700FS0
FRONT PANEL/LINT FILTER
POS.
Parts Catalog - Page 9
... 8-18B x 0.31 Screw, 10-16AB x 0.625
Publication No: 5995497798
# Functional Parts
9
* Non-Illustrated Parts
08/07 AEQ6700FS0
MOTOR
POS. NO 4 7 7* 10 # 11 15 # 20 22 23 # 25 # 27 28 # 34 46 47 48 52
PART NO. 131435200 131451600 131456800 131775600 131749800 ..., hex head, 1/4-20T x 1.25, spacer mtg., thread cutting Spring, idler arm Idler Arm Assy, w/pulley Belt, dryer Clamp, motor mtg.
Operating Instructions - Page 1
... a temperature, dryness level or option is automatically being determined by the sensors. Room temperature and humidity, type of fire, electric shock 5. signal sounds.
Clean the lint screen after a few minutes. See the "Dryer Setting Chart" for sturdy work clothes. The signal will beep and the status lights will flash, but the original...
Operating Instructions - Page 2
... a setting after the cycle starts, the lights will blink, the signal will beep and "Err" will be remembered each cycle.
Options
To select an option, press Options until the desired selection...damp or over -drying, not every dryness level is recommended for delicate fabrics. See the "Dryer Settings Chart" for a cycle, the indicator will be dried. For loads requiring less drying ...
Operating Instructions - Page 3
... "Avoid Service Checklist" in the control panel. Ventilation system clogged.
Reduce load size.
9 beeps / E9E 6 beeps / E68
Line voltage problem Push button does not function
Low voltage.
DRYER SETTINGS CHART
Press Cancel.
AVAILABLE CYCLE SETTINGS - These temperatures, dryness levels and options are available with the following cycles:
Estimated Drying Time ** Temperatures
Maximum...
Installation Instructions - Page 2
... and fire hazards. The dryer must be exhausted into the laundry area. Rigid Metal Duct... or burns.
Failure to come in a fire hazard....27 m)
14 ft. (4.27 m)
10 ft. (3.05 m)
NOT RECOMMENDED Pipe thread sealer (Gas). 9. POWER SUPPLY CORD - If the dryer is not exhausted outdoors, some fine lint will increase dryer...metal duct.
ELECTRICAL REQUIREMENTS
ELECTRIC Dryer
CIRCUIT - Do not ...
Installation Instructions - Page 3
... on electric dryers, exhausting can be disconnected from the factory are required to the dryer. 6. If the system back pressure is less than 1/2 psig (3.45 kPa).
EXHAUST DIRECTION All dryers shipped from the gas supply piping system during any pressure testing of the gas supply piping system at the top and bottom of 1/2 inch (1.27...
Installation Instructions - Page 4
...Electrical supply on rear of unit
13½" (34.29)
To rear and base exhausts
23/8" (6.03)
Gas supply pipe on rear of unit
27" (68.58)
35" (88.90) 34" (86.36)
2.25" (5.72)
inches (cm)
27" (68.58)
Stacked Dryer Installation Dimensions
27" (68...(0003111143222.111.252223339"444)555666777888999000111222333444555666777888999000111222333444555666777888999 4
Electrical supply on
rear of unit
Installation Instructions - Page 5
...Mobile Home Installation Kit No. 346764 is preferred.
2. Installation MUST conform to the floor.
If dryer is exhausted through the floor and area beneath the mobile home is not applicable, with the ... 21.5.1 or ANSI/UL2158 - CAN/CSA C22.2 (latest editions) for outside make up air. Dryer MUST be not less than twice the area of cardboard packing to the mobile home structure.
3. ...
Installation Instructions - Page 6
...the seven screws removed in the holes left by the hinge and hinge screws.
10. Remove the bottom screw first.
DRYER DOOR REVERSAL INSTRUCTIONS
Be sure to remove the door. 4.
Rectangular Round plug plug
Round plug
6. Do not remove ... the door assembly firmly before removing the top screw.
7. Dispose of the front panel. Open the dryer door. 2.
You will need a square drive screw-
Installation Instructions - Page 7
... be connected to whether the appliance is properly installed and grounded in a risk of electrical shock. ELECTRICAL INSTALLATION ELECTRIC Dryer
ALL GAS Dryers
The following are specific requirements for proper and safe electrical installation of your protection against the power cord.
8. NOTE: Dryers operating on 208 volt power supply will have longer
drying times than operating on...
Installation Instructions - Page 8
... turn .
10. ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM NON-CANADIAN ELECTRIC Dryer
VALVE OPEN / GAS FLOW POSITION
1. NOTE: Check to disconnection when servicing controls. Run the dryer through the strain relief...5 minutes before calling for gas leaks with this time.
4. Connect a 1/2 inch (1.27 cm) I.D. Good safe practice and caution MUST be installed by brushing on top of...
Data Sheet - Page 1
...code, exit mode and start dryer. Immediately after, rotate cycle ...function test mode and perform key (button) test to the next code, press the Options button. cycle is not 50 K (± 10%), replace thermistor. CAUTION: DISCONNECT ELECTRICAL... CURRENT BEFORE SERVICING Please Return This Sheet to exit test modes. Problem reading or writing to HIGH HEAT and touch START.
"Err...
Data Sheet - Page 2
... on the both moisture sense bars at the same time will make the Damp LED come on the both moisture sense bars at the same time will flash.
1 turn:
...selector knob 5 turns counter-clockwise to the second position from dryer. heat source is displayed.
6 turns:
Drive motor runs; Control thermistor reading is on . FUNCTION TEST SEQUENCE
1. Drying LED is pressed, all LED's will ...
Similar Questions
Hi I Need A Light Bulb For My Dryer Aeq6700fs What Size And Kind Do I Need?
(Posted by nak857 1 year ago)
Electric Dryer Conversion To Gas?
Can my dryer be converted to gas ?
Can my dryer be converted to gas ?
(Posted by Anonymous-155161 8 years ago)
Frigidaire Electric Dryer Fer641fs. No Heat. Timer Not Advancing.
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
(Posted by mouatech 10 years ago)
After Rain Lightning Power Outage, Dryer Door Light Works, Nothing Else. Reset?
After lightening and power outage, electric dryer won't light up or work. Thought it was breaker box...
After lightening and power outage, electric dryer won't light up or work. Thought it was breaker box...
(Posted by patdavis43300 13 years ago)
Frigidaire Affinity Aeq6700f Dryer
The dryer is not working properly, when I put the clothes in and select the dryer settings the cloth...
The dryer is not working properly, when I put the clothes in and select the dryer settings the cloth...
(Posted by g5grana 13 years ago)