Frigidaire GLEQ2152ES Support Question
Frigidaire GLEQ2152ES Support Question
Find answers below for this question about Frigidaire GLEQ2152ES - Electric Dryer.Need a Frigidaire GLEQ2152ES manual? We have 4 online manuals for this item!
Question posted by vesaha on August 8th, 2014
Where Are The Fuses In Gleq2152es1
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Frigidaire GLEQ2152ES Manual Pages
Use and Care Manual - Page 2
...your gas supplier, call your
Purchase Date dryer. Instead
it in this washer may not be used when elevating the washer for ease of use any electrical switch; Read and Save These Instructions
Read ...contact your local city office, your building. • Clear the room, building or area of electrical and electronic equipment.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to ...
Use and Care Manual - Page 3
... contribute to fabrics can become airtight chambers. • Keep laundry products out of ventilating air. Regularly inspect the outdoor exhaust opening and in U.S.A. ELECTRIC DRYERS:
14-30R
FUSED 30 AMP 120/240 V OR 120/208 V WALL RECEPTACLE
DRYER
DRYER SERVICE CORD
Grounding type wall receptacle
GAS DRYERS:
Do not under certain circumstances produce fire by spontaneous combustion...
Use and Care Manual - Page 4
..., harshness, and a build-up of fire, electrical shock, or injury to do not reach into the dryer if the drum is moving. Place small items in place. 3. Check that attract lint. If the dryer is opened. Failure to persons, read and follow fabric care labels and laundry product labels.
See Operating Instructions for detailed...
Use and Care Manual - Page 5
... tumble dried. 1. The screen is equipped with the basic warnings listed in Important Safety Instructions and those listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to an exhaust outdoors. An excessive amount of lint build-up may form on the lint screen from noncolorfast fabrics, clean the...
Use and Care Manual - Page 6
...scum, and fabric damage.
Care and Cleaning con't
Do not store or place laundry products on top of dryer at medium or low heat for 5-10 minutes.
• Remove items immediately...Wrinkling
• Overloading. • Leaving items in washer or dryer to
electricity.
• Or, add a fabric softener sheet and
reduce static electricity.
• Lint screen not clean
tumble without heat.
&#...
Use and Care Manual - Page 7
...
drum finish. or buttons are 2 house fuses in this list.
Avoid Service Checklist
Before calling for service, review this dryer.
POSSIBLE CAUSE
Electrical power cord is on a 240 volt circuit...of material securely around ornaments before starting each cycle.
Lint screen is overloaded. Electric dryer is empty or there has been a utility interruption of items.
See Drying Procedures...
Technical Data Sheet - Page 1
... the Select button. Control thermistor or its wiring is not 50 K (± 10%), replace thermistor.
If dryer operates normally but the key struck code still exists, replace electronic control. If meter reads 240V on electric models and 120V on the relay RL2.
If problem persists, replace electronic control. If good, replace electronic...
Technical Data Sheet - Page 2
... buttons simultaneously for regular operation.
134509400A (0501) Immediately after, press and hold Select and Pause Cancel buttons simultaneously for six seconds or disconnect power from dryer. heat source is off . "H" and the control thermistor reading will be a key beep with each setting. heat source is on the both moisture sense bars...
Installation Instructions - Page 2
... and Materials Required for additional instructions. Carpenter's level. 4. Vent hood. 8. Individual 15 amp. maximum time delay fuse or circuit breaker.
Phillips head screwdriver. 2. Rigid or flexible metal 4 inch (10.2 cm) duct. 7. ELECTRICAL REQUIREMENTS
ELECTRIC Dryer
CIRCUIT -
POWER SUPPLY - 3 wire or 4-wire, 240 volt, single phase, 60 Hz, Alternating Current. Pipe...
Installation Instructions - Page 3
... and approved vent hood which can accumulate lint, resulting in death, explosion, fire or burns. When the dryer stops, the dampers automatically close to installing dryer duct.
The following method must be exhausted into the laundry area. Restricted air flow will be higher than 0.75 inches of the vent system, nor use plastic...
Installation Instructions - Page 4
...the full length of the door is acceptable.
1. However, on electric dryers, exhausting can be accomplished by installing Exhaust Kit, P/N 131456800, available...carpet. No other fuel burning appliance shall be installed immediately upstream of the gas supply connection to the dryer.
6.
A louvered door with curtains,
drapes, or anything that is required. EXHAUST DUCT LOCATING DIMENSIONS
...
Installation Instructions - Page 5
The following illustrations show minimum clearance dimensions for sides, rear, and top. cm)
CLOSET DOOR
0" (0 cm)
15" (38.1 cm)
1" (2.54 cm) 0" (0 cm)
5 This dryer MUST be exhausted outdoors.
5. cm)
60 sq. NOTE: Under counter and stack models - 0 inches (0 cm) for proper operation in a recess or closet installation.
0" (0 cm)
0" (0 cm)
1" (2....
Installation Instructions - Page 6
... (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to clear...
Installation Instructions - Page 7
...in the open screw holes on its left side of the door opening .
When installing a gas dryer into a mobile home, a provision must be reversed at any time without additional parts. Using the... remove the foam shipping base. Rigid metal duct is available from your dealer.
5.
This dryer MUST be made for Mobile Homes. Install the four hinge hole plugs in diameter with the...
Installation Instructions - Page 8
... screws in Step 2. 4. Step 1
Step 2
Steps 4 & 5
Step 7 Be careful to the dryer front panel. Support the door assembly firmly before removing the other screw from each hinge.
3. Retain the ... screw from each hinge first. Remove the two handle hole plugs from turning. Open the dryer door. Window Door Reversal Instructions
1. Install the plugs from the opposite side of the door...
Installation Instructions - Page 9
... equipment grounding conductor must be purchased, allowing some slack in the cord.
Check with a copper wired receptacle. ELECTRICAL INSTALLATION
ELECTRIC Dryer
The following are in doubt as to whether the appliance is properly grounded. Electrical shock can melt, creating electrical shock and/or fire hazard. Follow the instructions in a risk of least resistance for your...
Installation Instructions - Page 10
...
BLACK TIGHTEN
NUT
WHITE
TO THESE THREADS
NUT
STRAIN RELIEF MOUNTING BRACKET
STRAIN RELIEF MOUNTING B R A C K E T POWER CORD
POWER CORD
ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM
ELECTRIC Dryer
ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM
ELECTRIC Dryer
1. Do not make a sharp bend or crimp wiring/ conductor at this time.
3. Reinstall the terminal block cover.
9. Install a U.L. Install...
Installation Instructions - Page 11
... on the power at the circuit breaker/fuse box.
5. Children might use them for gas leaks with this happens, turn the timer to "OFF" and wait 5 minutes before plugging the power cord into a grounded outlet. GAS CONNECTION
1. Connect a 1/2 inch (1.27 cm) I.D.
Before operating the dryer, make materials inaccessible to flow through a cycle...
Operating Instructions - Page 1
... affect drying time. Cycle Selection
For best results, follow the fabric care label instructions on size and dampness of drying time. The dryer senses the moisture level of fire, electric shock or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS in place.
3. Drying time varies depending on items to handle during unloading...
Operating Instructions - Page 2
...from overdrying. Those adjustments will automatically be dried. See the "Dryer Settings Chart" for sturdy fabrics. Drying Temperature
For best results, ... Press Saver • Clean Lint Filter • Control
PN 134431300A (0501) Dryer Features
Control To avoid having someone accidentally start or stop the dryer, press OPTIONS and SELECT at the end of the cycle and periodically during Press ...
Similar Questions
Electric Dryer Conversion To Gas?
Can my dryer be converted to gas ?
Can my dryer be converted to gas ?
(Posted by Anonymous-155161 8 years ago)
Give Me A Diagran Of Where Is The Fuse Locatedin A Frigidaire Electric Dryer
(Posted by 101robi 10 years ago)
Gleq2152es1 Frigidaire Dryer Won't Heat, All Lights Blinking
(Posted by nearlmus 10 years ago)
Frigidaire Electric Dryer Fer641fs. No Heat. Timer Not Advancing.
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
(Posted by mouatech 10 years ago)
Frigidaire Gleq2152es Electric Dryer Runs A While, Heats On Then Stops After 10m
(Posted by thespen691 14 years ago)