Frigidaire GLET1031CS Support Question
Frigidaire GLET1031CS Support Question
Find answers below for this question about Frigidaire GLET1031CS - 27" Electric Stack Washer Dryer Combo.Need a Frigidaire GLET1031CS manual? We have 1 online manual for this item!
Question posted by AATYLER56 on October 10th, 2014
How Do I Change The Heating Assembly?
How Do I Remove The Old Heating Assembly And Replace It With A New One?
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on October 14th, 2014 8:32 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hello AATYLER56, thank you for your post! From my understanding you would like to change your heating assembly within your Frigidaire laundry center. Regrettably, this is not a simple DIY job. I would highly recommend reaching out to an expert technician to ensure the replacement part is installed correctly to prevent future issues. Some of these intricate part replacements do require precision and patience. One must be very careful as there certain replacement parts could result in potential harm. Best regards. –OOS
Online Outreach Specialist
Related Frigidaire GLET1031CS Manual Pages
Owners Guide - Page 2
... near the dryer.
Clean the dryer lint screen before reaching into a properly grounded system. Do not stack or place laundry or throw rugs against the front or back of ventilating air. To prevent personal injury, observe all occupants. Failure to comply with gasoline, cleaning solvents, kerosene, waxes, etc.
The washer will be installed and electrically grounded...
Owners Guide - Page 3
...Removal, page 5, for washing.
• Empty pockets. • Brush off lint and dirt. Add a measured amount of fire, electrical shock, or injury to persons, read and follow fabric care and laundry...before adding the laundry load.
Washing Procedures
Sort laundry into loads that can be damaged. To reduce the risk of detergent to the wash tub before operating this washer.
1.
Shake out...
Owners Guide - Page 4
... automatic dryer, line dry, or dry flat as directed by fabric care label. Replace dispenser...washer if safety lid lock is completed.
DO NOT REMOVE SERVICE CAP. Start the washer. The washer will be more than top row of fabric softener occurs, clean with a built-in a load.
Add laundry...8226; To stop the washer, push in the cycle selector knob. • To change a cycle, push in...
Owners Guide - Page 5
... using bleach safe for fabric. Badly mildewed fabrics may intensify discoloration.
Repeat, replacing paper towels frequently. Once paint is dry, it may be impossible to remove solvent. Rinse thoroughly before washing. Pretreat with product containing enzymes. For successful stain removal: • Remove stains promptly. • Determine the kind of an entire load, use rust...
Owners Guide - Page 6
... for proper diluting.
It may intensify discoloration.
6
•Do not overload washer. •Remove items from normal wear.
•Use a lint brush or shaver to lubricate...washer as soon as
cycle is attracting lint.
•Dry load in the washer to remove pills.
•Use fabric softener in dryer.
•Load washed too long
•Remove lint with prewash stain remover...
Owners Guide - Page 7
..., harshness, and a build-up of fire, electrical shock, or injury to OFF.
7
Do not overload dryer.
• When drying large items, dry only 2 or 3 at a time. When the cycle ends, remove items immediately and hang or fold. Dryer heat may not have been removed in a mesh bag. Start the dryer.
• Turn Start control clockwise to the...
Owners Guide - Page 8
...Drum Light (some models)
A drum light will sound at medium or low heat for 5-10 minutes.
•Remove items immediately. Closing the door turns off , synthetic and permanent
ball up and...•Overdrying.
The volume is clean and in washer or dryer to reduce
static electricity. •Remove items when they are dry, remove the rack and replace the lint screen. Drying Rack (some models)
Use...
Owners Guide - Page 9
... the dryer drum becomes stained from fabric dye. Rinse several times with clear water.
• Remove glue residue from the washer as soon as the cycle ends. Remove this build-up could occur.
Excess wrinkling, color transfer, and odors may remain on the laundry center.
Wash lint screen occasionally. Dry thoroughly and replace. Hazardous fumes or electrical...
Owners Guide - Page 10
... for removing
removed during installation. Stop washer and redistribute wash load. Adjust leveling legs. shipping bolt and block. OPERATING
Washer does not start. If problem is not resting on solid floor. If problem is usually normal. Turn on . Plug electrical cord into a properly grounded electrical outlet. 4. Avoid Service Checklist
Before calling for 1
minute to the laundry center...
Owners Guide - Page 11
...faucet in correct position.
Water supply faucets are clogged. Avoid running water elsewhere while washer is overheated. Water level does not cover Improper water level selection (for proper cleaning...excess dirt and sand from laundry center. Load is kinked or clogged. Rearrange load to wrong supply faucets. Drain hose is incorrect height. load. Washer is not completely closed. Adjust...
Owners Guide - Page 12
...sorting of the dryer feels too hot or smells hot.
Thermal limiter tripped.
When in place, the duct must not exceed length listed in wall outlet. Electric dryer is on ...'t heat.
Remove items as soon as cycle ends.
Make sure all lint has been removed from the dryer lint screen before starting each cycle.
OCCURRENCE
DRYER
Dryer does not start.
Replace fuse. Dryer runs...
Owners Guide - Page 13
...with original serial numbers that prove to another party or removed outside the USA or Canada.
3.
THIS WRITTEN WARRANTY ..., or for service calls to change without notice. Service calls which are subject to change or add to any after hour... REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR OR REPLACEMENT AS PROVIDED HEREIN. CLAIMS BASED ON IMPLIED WARRANTIES, INCLUDING...
Similar Questions
Video How To Change The Thermal Fuse On A Stackable Dryer
(Posted by unhector 9 years ago)
How To Change Belt On A Stack Washer And Dryer
how to change belt on dryer
how to change belt on dryer
(Posted by klbarnes57 11 years ago)
Frigidaire Stacked Washer Dryer
the tub seams to have falled about a inch, what support the washer tube, a bearing or bracket? what ...
the tub seams to have falled about a inch, what support the washer tube, a bearing or bracket? what ...
(Posted by centralmnconsultants 11 years ago)
Dryer Of Washer Dryer Combo Not Heating But Turning
The dryer in my washer dryer combo not drying but running.Just started with second load
The dryer in my washer dryer combo not drying but running.Just started with second load
(Posted by Kmbates10 11 years ago)