2008 GMC Canyon Support Question
2008 GMC Canyon Support Question
Find answers below for this question about 2008 GMC Canyon.Need a 2008 GMC Canyon manual? We have 1 online manual for this item!
Question posted by Cyph0st on April 8th, 2014
2008 Gmc Canyon How To Change Oil
The person who posted this question about this GMC automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2008 GMC Canyon Owner Manual
Seats and Restraint Systems ...1-1 Front Seats ...1-2 Rear Seats ...1-9 Safety Belts ...1-12 Child Restraints ...1-33 Airbag System ...1-60 Restraint System Check ...1-75 Features and ...
Owner's Manual - Page 2
... in Canada, substitute the name "General Motors of Canada Limited" for GMC whenever it was printed. Propriétaires Canadiens
On peut obtenir un ...helminc.com
GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Emblem, and the name CANYON are registered trademarks of General Motors Corporation. We reserve the right to make changes after that may be offered or your dealer/retailer or...
Owner's Manual - Page 40
... wrapped around their arms while riding in a vehicle needs protection! This includes infants and all other people, or can be thrown out of the traveler changes the need to use the vehicle's adult safety belts alone; Neither the distance traveled nor the age and size of the vehicle. An infant does...
Owner's Manual - Page 78
...sure the person performing work for the right front passenger's position, which includes sensors that change
about servicing your vehicle and the airbag system. A: Yes. In addition, your vehicle has... the airbag system. The passenger sensing system may keep the airbags from working properly?
Changing or moving any parts of the front seats, safety belts, the airbag sensing and ...
Owner's Manual - Page 102
..., can help in cold weather conditions at or below 0°F or −18°C), it could change the way the engine operates. If the engine does not start after 5-10 seconds, especially in very ...designed to let the cranking motor cool down . Operate the engine and transmission gently until the oil warms up to prevent cranking motor damage. To Use the Engine Coolant Heater
1. Turn off ...
Owner's Manual - Page 168
...inspection if the check engine light is designed to inspect the emission control equipment on oil and you have recently replaced the battery or if the battery has run down..... Always follow the maintenance schedule in this inspection could be considered not ready for changing engine oil. Emissions Inspection and Maintenance Programs
Some state/provincial and local governments have or might ...
Owner's Manual - Page 171
... reset stem until the next language appears. 5. Once the desired language is shown on the DIC display, the language is set your driving conditions. The CHANGE OIL message alerts you to ON/RUN and then press the reset stem until TRIP appears on the DIC display.
Always reset the...
Owner's Manual - Page 174
...
Messages are displayed on the DIC to notify the driver that the status of the vehicle has changed . Each message must be turned off. Check the brakes as soon as possible and have your... should press and release the trip odometer reset stem to correct the condition. CHANGE OIL
This message displays when the oil needs to acknowledge the message and clear it from the display. Press and release ...
Owner's Manual - Page 278
... will be indicated can calculate when the next oil change is possible that, if you are all you change the engine oil and filter based on mileage.
A CHANGE OIL message will perform this time the system must change the oil at which an oil change will indicate that an oil change the engine oil and filter. Your dealer/retailer has trained...
Owner's Manual - Page 279
....
5-19
Clean your skin for very long. If you start your vehicle, the engine oil life system has not reset.
Repeat the procedure. If the CHANGE OIL message comes back on when you have a problem properly disposing of used oil, ask your dealer/retailer, a service station, or a local recycling center for help. Never dispose...
Owner's Manual - Page 280
... is not there and the engine backfires, you are driving in dusty/dirty conditions, inspect the filter at the first oil change after each engine oil change.
{CAUTION:
Operating the engine with the air cleaner/filter off , a backfire can cause a damaging engine fire. How to use...
Owner's Manual - Page 281
... the instructions here, or you check your automatic transmission fluid level is when the engine oil is colder than 50°F (10°C), drive the vehicle in hot weather. To get...15 miles (24 km) when outside temperatures are above 50°F (10°C). If it is changed.
How to Check Automatic Transmission Fluid
Because this operation can be sure to overheat. A cold &#...
Owner's Manual - Page 283
... hot.
Manual Transmission Fluid
When to Check
A good time to have this operation can damage your manual transmission does not require changing. If you do it checked is when the engine oil is used only as
described under "How to Check Automatic Transmission Fluid," earlier in this section.
• When the correct...
Owner's Manual - Page 380
... your new vehicle warranties. Any damage caused by failure to follow scheduled maintenance might drive it . Maintenance Schedule
Introduction
Important: Keep engine oil at the proper level and change as prescribed in this manual are necessary to keep your vehicle in good working condition. Your Vehicle and the Environment
Proper vehicle maintenance...
Owner's Manual - Page 382
... is required for information on page 3-42. Scheduled Maintenance
When the CHANGE OIL message comes on, it is recommended that your first service be Maintenance I and Maintenance II ... Maintenance II was Maintenance I if the CHANGE OIL message comes on 10 months or more often. Required services are required. If the engine oil life system is changed at least once a year and at ...
Owner's Manual - Page 383
... I Maintenance II
• •
6-5 Perform any leaks or damage. See Engine Oil Life System on page 5-15. An Emission Control Service. If necessary, replace filter...wear. See footnote (b). Inspect engine cooling system. Scheduled Maintenance
Service Change engine oil and filter. See Engine Oil on page 5-18. Visually check for any needed . See footnote...
Owner's Manual - Page 386
...and filler neck. Replace belt if necessary. Add fluid if needed. (h) Change automatic transmission fluid and filter if the vehicle is mainly driven under dusty conditions, ...inspect the filter at each engine oil change. (k) Visually inspect belt for what to your vehicle. you should be complex; Inspect hoses...
Owner's Manual - Page 387
...is stored securely.
See Inflation - Failure to keep it at the proper level. Engine Oil Level Check
Notice: It is important to perform these underhood checks at each fuel fill....and add DEX-COOL® coolant mixture if necessary. See Engine Oil on page 5-62. See Engine Coolant on page 5-80. See Changing a Flat Tire on page 5-26.
See Tire Inspection and Rotation on ...
Owner's Manual - Page 403
... calendar year. 7-7
• Fuel Delivery: Delivery of enough fuel for coverage.
• Flat Tire Change: Installation of a spare tire in good
condition, when equipped and properly in Canada only, up to the...when the vehicle is covered at no charge if you are provided in Canada, call , 1-800-GMC-8782 (1-800-462-8782); (Text telephone (TTY): 1-888-889-2438).
Please allow three weeks ...
Owner's Manual - Page 405
... support program for vehicles with each new vehicle provides detailed warranty coverage information. GMC and General Motors of Canada Limited reserve the right to Bumper (Base Warranty ...violation of local, Municipal, State, Provincial, or Federal law, and mounting, dismounting or changing of the New Vehicle Limited Warranty.
By scheduling a service appointment and advising your service ...
Similar Questions
How Change Automatic Transmission Fluid In 2008 Gmc Canyon
(Posted by BLastri 10 years ago)
Change The Oil Light
how do u rest change the oil light on a 2008 GMC CANYON SLE
how do u rest change the oil light on a 2008 GMC CANYON SLE
(Posted by locklearwayne 10 years ago)
How Do You Change A Camshaft Sensor On A 2008 Gmc Canyon Does It Have To Relearn
i know where it is but after changing it do you have to have it relearned or can it relearn itself a...
i know where it is but after changing it do you have to have it relearned or can it relearn itself a...
(Posted by chrislago 10 years ago)