GE GG50T06PVK Support Question
GE GG50T06PVK Support Question
Find answers below for this question about GE GG50T06PVK.Need a GE GG50T06PVK manual? We have 2 online manuals for this item!
Question posted by Anonymous-26200 on April 5th, 2011
Fv Code
fv sensor got wet, try to start error code says fv sensor detected presense, is there a way to reset
Current Answers
Related GE GG50T06PVK Manual Pages
Use and Care Manual - Page 6
... Care Manual.
● Do not attempt to 52-gallon capacity, a brochure with local codes and the provided installation instructions. However, applicable local codes shall govern installation. WARNING! FOR INSTALLATIONS IN THE STATE OF CALIFORNIA
California Law requires that residential water heaters must be braced, anchored or strapped to resist falling or horizontal displacement due...
Use and Care Manual - Page 7
... label.
● If the water heater is required between these combustion air inlet openings and any gas appliance.
Combustible and/or flammable products and materials should be available for example, by a Qualified Service Technician. DO NOT obstruct or block the Flammable Vapor Sensor. A copy can ignite these instructions, local codes, utility company requirements, and...
Use and Care Manual - Page 8
DO NOT obstruct or block the Flammable Vapor Sensor. A confined space is installed in a confined space, provisions for combustion and ...that will shorten the life of the water heater requires air for possible damage.
Provisions for the openings MUST NOT be located within 12" above and each opening communicates with referenced codes and standards. The minimum net free area...
Use and Care Manual - Page 9
...
Cap
Thermostatic gas valve
Jacket door
Flammable Vapor Sensor
Auxiliary catch pan Drain Pan Pipe to suitable drain.
1/4" per local codes and valve manufacturer's instructions. Safety Instructions Installation Instructions Operating Instructions
Thermal Expansion
Determine if a check valve exists in the cold water line between the water heater and the check valve (see illustration below for...
Use and Care Manual - Page 10
... Bulletins 1400 Series Section and choose Bulletin #1402.
Local codes shall govern the installation of a type approved for the purpose on .
A new combination temperature and pressure relief valve, complying with water.
If, however, the condensation continues, examine the piping and fittings for Hot Water Supply Systems, ANSI Z21.22, is turned on the water heater.
Use and Care Manual - Page 11
...Code (NFGC) mandates a manual gas shut-off valve must be lower than 3/8 psi (10.5" w.c.) for natural gas, or 1/2 psi (14" w.c.) for use with main burner on the threaded joints of 3/8 psi (10.5" w.c.) for natural gas, or 1/2 psi (14" w.c.) for LP gas.
The water heater... Operating Instructions
WARNING: Do not attempt to the water heater must not exceed 10.5" w.c. Such conversion could ...
Use and Care Manual - Page 12
...the system for use on blower housing and secure it must be kept in a way that position until enough time has passed to dissipate. Attach Blower Assembly to the outdoors as ... Vapor Sensor. The vent pipe must be no more than the TERMINATION, should isolate the vent pipe from all other stresses in the joints as described in the system.
If the water heater is important...
Use and Care Manual - Page 16
...water heater. In order to dissipate.
DO NOT thin solvent cement. After checking pipe and socket for proper handling methods.
NOTICE: Cement must be acidic; Wipe all excess cement from draining back into fitting with a Flammable Vapor Sensor... passed to allow primer to local, state (provincial) or federal codes for proper fit, wipe socket and pipe with cleaner-primer.
Allow...
Use and Care Manual - Page 17
A grounding receptacle is approximately 5.0 amps.
The water heater must be electrically grounded in accordance with local codes, or, in the absence of local codes, in the heater control enclosure.
Wiring errors can cause improper and dangerous operation. The maximum current draw is required. NOTE: It is provided to permit use an extension cord). VERIFY PROPER OPERATION ...
Use and Care Manual - Page 18
... type of the sensor. This will interfere with the water heater. This area must be unobstructed so as not to restrict the proper function and operation of the water heater:
● Do not cover the operating or warning labels attached to the water heater or attempt to the top of insulation blanket.
WARNING: If local codes require external...
Use and Care Manual - Page 19
...or the Flammable Vapor Sensor located around the lower portion of nipples and heat traps on page 31. These heat traps may require a minimum of this water heater where
standing water may require an ...Manual and the National Fuel Gas Code.
❑ DO maintain proper clearances to
combustibles as specified on the rating plate. See Illustration of the water heater jacket.
❑ DON'T ...
Use and Care Manual - Page 20
... freezing
temperatures.
❑ Proper clearance from combustion air inlet
openings observed
❑ Flammable vapor sensor is not blocked.
Care and Cleaning
Troubleshooting Tips
C.
B. E. Operating Instructions Installation Instructions Safety Instructions
Installation Checklist
A. Water Heater Location
❑ Close to applying electrical power.
20
Customer Service
Use and Care Manual - Page 21
Local codes or plumbing authority requirements may be present and will be purged through the domestic water faucets and showers.
! Hot water supply to house
Hot water supply to heating unit
From HOT outlet on
water heater
Tee fitting for vertical hot water supply lines
Hot water supply to house
From HOT outlet on
water heater
Hot water supply to an existing...
Use and Care Manual - Page 23
... lower the temperature setting, the greater the savings in determining the proper water temperature for Hot Water SCALDS.
NOTICE: Flammable vapors can be considered when selecting the water temperature setting of use gasoline or other appliance. TO SHUT OFF WATER HEATER -
The recommended starting point temperature is established, the gas control will alert the user of...
Use and Care Manual - Page 25
... solids can cover the gas control (thermostat) sensors, causing the sensors to drain the water heater, turn off valve before removing anode rod. ...Water Heater
!
Make sure the cold water supply is recommended that a routine preventative maintenance program be used to make certain no one will provide years of the gas control (thermostat), burner, relief valve, internal flue-way...
Use and Care Manual - Page 26
...access door gasket must be certain it involves the disconnection of the flue way. Proper burner pattern. Reinstall the blower assembly.
The burner chamber is clean...block the Flammable Vapor Sensor. CAUTION: For your safety, cleaning of burner operation.
call the local gas utility to cleaning agents. Make certain the vent connector from the water heater. DANGER: Combustible ...
Use and Care Manual - Page 29
... Control (Thermostat) Defective. What To Do Clean tank. Wait for the water heater to gas valve error code table on how to qualified service personnel.
29
Troubleshooting Tips
Customer Service If necessary, relight using the instructions in the "Lighting The Water Heater" section of the water heater. Refer to recover after an abnormal demand.
Refer repairs to correct...
Use and Care Manual - Page 30
...Error Codes
Care and Cleaning
1st Flash, Pause 1 second Slow Flash Fast Flash
1 Flash
2 Flashes 2 Flashes
2nd Flash, Pause 3 seconds N/A N/A
1 Flash
1 Flash 3 Flashes
Possible Causes
What To Do
Normal operation. Standby Mode. l● Clean any scale buildup from gas line. (Refer to water heater... technician. Pressure Switch Fails to reset control. Inspect vent pipe and dilution...
Use and Care Manual - Page 31
... plate.
Specify type of parts desired. CAUTION: For your safety, DO NOT attempt repair of the water heater from the rating plate. Drain valve Gas Control (Thermostat)
Care and Cleaning
Troubleshooting Tips
Customer Service
*Burner
Flammable Vapor Sensor *Burner Access Door Gasket
*Burner orifice *Spark Igniter Assembly
*Burner Access Door
*Pilot supply tube...
Use and Care Manual - Page 36
... should you require service.
3 Read your Use and Care Manual carefully.
Water Heater
Model Number
Serial Number
Mr. ■ First Name
Ms. ■
Mrs. ■
Miss ■
Last Name
Street Address
Apt. #
City
State
Date Placed In Use
Month Phone Number
Zip Code
Day _
Year _
NOTICE: Failure to protect your new appliance investment...
Similar Questions
Water Heater Is Out
The gas is good to the water heater bu it will not start.
The gas is good to the water heater bu it will not start.
(Posted by dglover 8 years ago)
My Water Heater Keeps Going Into System Lockout /
water heater will work fine for a day or two then will go into system lockout , then work fine for a...
water heater will work fine for a day or two then will go into system lockout , then work fine for a...
(Posted by rmjozwiak 8 years ago)
How To Get My Ge Gas Power Vent Water Heater Out Of Vacation Mode
(Posted by velocal 9 years ago)
Gg50t06pvk Ge Power Vent Water Heater
The ignitor on my unit turns on and gets hot but burner does not fire. Error code shows green light ...
The ignitor on my unit turns on and gets hot but burner does not fire. Error code shows green light ...
(Posted by mjobrien911 12 years ago)