GE GTUP270EMWW Support Question
GE GTUP270EMWW Support Question
Find answers below for this question about GE GTUP270EMWW.Need a GE GTUP270EMWW manual? We have 3 online manuals for this item!
Question posted by rodrSlick7 on September 6th, 2014
Ge Washer Gtup270emww Fills And Does Not Agitate
The person who posted this question about this GE product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related GE GTUP270EMWW Manual Pages
Quick Specs - Page 1
... to the frame. Power cord should be exhausted to match a 20-amp receptacle.
21-5/16
Note:
Gas Rated input 20,000 BTU/HR. GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Dimensions and Installation Information (in inches)
Electrical Requirements: GTUP270EM Electric Dryer -
Quick Specs - Page 2
...: • The dryer MUST be used (Kit WX08X10077). GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Dimensions and Installation Information (in the absence of local codes,...installation must be installed in .
Ducting Materials: For best performance, this closet contains both a washer and a dryer, doors must be necessary to connect the dryer to the outside . &#...
Quick Specs - Page 3
...• 5 wash/rinse temperatures - Allow fast, easy cycle
selection • Model GTUP270EMWW - Washer will automatically
measure the load size and add just the right amount of water •...) - White on white (Electric) • Model GTUP270GMWW - GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Features and Benefits • 3.3 cu. Select the right temperature ...
Use and Care Manual - Page 1
... Washer 8 Loading and Using the Dryer 12 Loading and Using the Washer 9
Troubleshooting Dryer 16, 17 Troubleshooting Washer 13-15
Consumer Support
Consumer Support 20 Warranty 19
Owner's Manual
Write the model and serial number here:
Model
Serial
Open Dryer door for Model and Serial number tag.
189D7218P001 49-90417 10/26/10 GE
Use and Care Manual - Page 3
... approved rigid metal or flexible metal 4" diameter ductwork for the washer and dryer to climb on, hang from the door.
3... rated, protected and sized power supply circuit to the outdoors. YOUR LAUNDRY AREA
n Keep the area underneath and around your appliances free of slipping... receive one by visiting GEAppliances.com or by calling 800.GE.CARES (800.432.2737).
Exhaust/Ducting
1 Gas dryers ...
Use and Care Manual - Page 5
...or subjected to damage.
n Do not tamper with controls. GE recommends changing the hoses every 5 years.
SAVE THESE INSTRUCTIONS... discarding the appliance, or removing it from service, remove the washer and dryer lids to prevent children from traffic areas so it ... the condition of this appliance or attempt any part of the fill hoses;
GEApplances.com
WHEN NOT IN USE
n Grasp the plug...
Use and Care Manual - Page 6
.... SPIN ONLY - For draining the tub and spinning water out of the washing process.
The chart is ranked from reaching into the washer while the basket is desired. About the Washer control panel.
Fabric Softener
Detergent
Step 1
Liquid Bleach
Step 2
Step 3
Step 4
• Add detergent • Add fabric softener (optional) • Add...
Use and Care Manual - Page 7
... will blink. D Temperature
Select the water temperature for all wash temperatures. PerfecTemp senses the incoming water temperature and adjusts the fill water to obtain a more than the top row of the washer has been paused.
NOTE: If the STATUS lights are not completely dissolved in very cold water, especially in .
For example...
Use and Care Manual - Page 8
... detergent n 1 cup (240 ml) bleach
4 If necessary, loosen buildup with ammonia or acids such as the washer fills for the wash cycle.
1 Check clothing care labels for proper dispersion of the fabric softener. Pour into the agitator if the dispenser is securely attached to use a stiff brush;
n D o not mix chlorine bleach with a clean...
Use and Care Manual - Page 9
...store the washer where it will be below freezing.
9 GEAppliances.com
Proper Use of laundry problems.
You can work effectively. n Do not wrap long items like sheets or pants around the agitator. then ... when moving the washer. Wipe with product for information on how to reinstall the shipping rod to clean the basket, use harsh or gritty cleaners.)
Fill Hoses: GE recommends changing the ...
Use and Care Manual - Page 13
...less soap if you call for service.
Cooler water temperatures provide improved energy efficiency
New laundry detergents have been formulated to call for service... not set properly
60°C).
Review the... pumped out before cycle is normal
The washer may be clogged
Check household plumbing. Lid lifted or cycle was Reset cycle. Fill hoses or drain hose is delivering water ...
Use and Care Manual - Page 14
... no higher than larger loads
Detergent not dissolving
Add detergent as wash basket fills with water before completely shutting down. Check house circuit breakers/fuses.
Incorrect sorting... prevents agitation and spinning when lid is up
Circuit breaker/fuse is tripped/blown
Electronics need to the beginning if necessary. Unplug washer, wait 2 minutes, plug back in the washer basket...
Use and Care Manual - Page 15
.... Turn knits (which snag easily) inside out.
GEAppliances.com
Washer Performance Pilling
Snags, holes, tears, rips or excessive wear
Wrinkling
Possible Causes Result of agitate
"Click" when water stops filling
"Clicking" behind Control Panel during fill
Water volume changes during the spin cycle. Load your laundry. Wash in air, It starts to do
While this...
Use and Care Manual - Page 17
...If you are concerned about shrinkage in dryer after drying If you are drying only one washer load in the dryer
Make sure ducting is correct . Select a shorter drying time. ...a particular item, do
Improper sorting
Separate heavy items from lightweight items (generally, a wellsorted washer load is full
Clean lint filter before every load. Replace fuses or reset circuit breakers.
...
Use and Care Manual - Page 19
... fails due to a defect in materials or workmanship. n Incidental or consequential damage caused by a GE Authorized Servicer is product repair as described in freezing temperatures.
n Damage caused after delivery. Warrantor:...Year From the date of the original purchase
We Will Replace:
Any part of the washer which are limited to one -year warranty, we will also provide, free of ...
Installation Instructions - Page 1
...is installed, it could be in water hoses) 2 Washer Hoses
189D7219P001 31-16655 10/29/10 GE
Exposure to these substances can cause minor exposure to four ...GAS LINE CONNECTOR (KIT WE1M454)
PARTS SUPPLIED
1/4" Nutdriver
Nutdriver
1 Cable Tie
2 Rubber Washers
2 Stainer Screens/ Ruuber Washers
(washers may be exposed to water and or weather. • Save these instructions. (Installers:...
Installation Instructions - Page 2
...Exhaust (see section 11). Step 12 Place the Owners Manual and the Installation
Instructions in washer, read the follow- For Alcove or Closet Installation see section 1). Installation Instructions
INSTALLATION ... with the voltage and frequency indicated on firm flooring to 66°C) IN THE WASHER when hot wash is Clean (see section 1) and Meets Attached Installation Specifications (see...
Installation Instructions - Page 4
... IN ACCORDANCE WITH LOCAL CODES AND ORDINANCE REQUIREMENTS.
• The appliance must be reinstalled if washer is at a test pressure in excess of 0.5 PSI (3.4 KPa).
• The appliance ...back in tub opening are: 0 in the home, remove remaining packing material/ carton from washer.
REPLACE WITH NEW CSA(AGA) APPROVED FLEXIBLE GAS LINE CONNECTOR AND UL APPROVED TRANSITION DUCT....
Installation Instructions - Page 8
Note: do not use washer cover to the house vent using a flexible metal (foiltype) duct. With the appliance in walls, ceilings, floors... the transition duct, maximizing drying performance. • Avoid resting the duct on each leg up toward the base of the washer lid and check it may be used (Kit WX08X10077). • Never install flexible metal duct in its final location. Gently...
Installation Instructions - Page 10
...If water valves and drain are built into drain opening of washer. Water heater should be sure all water from the fill and drain systems has been removed. Use Siphon Break Kit... hose extension kit, GE part number WH49X301. The standpipe diameter must be connected.
•WATER PRESSURE - Hand tighten, plus an additional 1/8 turn with hose clamp (contained in the washer when HOT wash is...
Similar Questions
Ge Washer Gtw680bsj1ws Fills Higher Than Normal And Then Immediately Drains And
We just replaced the fill valve assembly on our GE washer model GTW680BSJ1WS because of a leak insid...
We just replaced the fill valve assembly on our GE washer model GTW680BSJ1WS because of a leak insid...
(Posted by cathymc1962 3 years ago)
Gtup270em5ww Washer Will Fill But Nothing Else. On Light And Wash Light Blinks.
(Posted by David69455 9 years ago)
