Hayward Navigator V-Flex Support Question
Hayward Navigator V-Flex Support Question
Find answers below for this question about Hayward Navigator V-Flex.Need a Hayward Navigator V-Flex manual? We have 1 online manual for this item!
Question posted by denniscairns on November 21st, 2023
Why Does The Suction Hose Tangle
The person who posted this question about this Hayward product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by SonuKumar on November 22nd, 2023 9:46 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,617,810
Member since:
May 9th, 2021 Points: 16,617,810
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by Technicalproblemsolver on November 21st, 2023 11:42 PM
Technicalproblemsolver
Member since:
September 25th, 2023 Points: 190,500
Member since:
September 25th, 2023 Points: 190,500
There are several factors that can contribute to the suction hose of the Hayward Navigator V-Flex tangling. Some common reasons for this issue may include the hose becoming twisted during operation, improper adjustment of the hose length and weight, or encountering obstacles in the pool that could cause the hose to tangle. Additionally, regular wear and tear on the hose or improper storage when not in use can also lead to tangling. It's important to ensure that the hose is properly maintained, the pool is free of debris that could affect the hose's movement, and that the hose is adjusted correctly to mitigate tangling.
If the issue persists, a service professional or Hayward's customer support team may be able to provide further assistance.
"Hi there,
I hope my response was helpful in addressing your question or concern. If you found it valuable, I kindly ask you to consider accepting my answer by clicking the designated button. Your support will not only acknowledge my efforts but also guide others in finding useful solutions. Thank you for your trust and I'm ready to assist you further if needed.
Best regards,
Technicalproblemsolver"
Related Hayward Navigator V-Flex Manual Pages
Owners Manual - Page 1
A NAVIGATOR®/POOLVAC
TM
V-FLEX SERIES
Suction Pool Cleaner Owner's Manual
Hayward Pool Products (Australia) Pty Ltd PO Box 4384, Dandenong South, VIC, 3164 Ph: 1300 POOLS1 W: www.hayward-pool.com.au
ISM0925AU rev.
Owners Manual - Page 2
... the Cleaner are designed to work well with cleaner.
DO NOT coil the hose. REMEMBER safety first. Lastly, one or more of your Hayward automatic suction pool cleaning system. REMOVE cleaner and hose before adding ANY chemicals to its power source. Hoses must be relative to your installation.
This call will be stored straight...
Owners Manual - Page 3
... to be used in a fibreglass or vinyl lined pool. Your cleaner comes fitted with shoes to be ordered seperately. CARTON CONTENTS
x1 Navigator® or PoolVac
Connector
Regulator Valve
Flow Gauge
Leader
Cone Adapter
Skimmer Elbow
Connector/Leader Hoses Accessory Kit
Navigator V-Flex/ PoolVac V-Flex: x11 Connectors x1 Leader
Correct shoe selection for changeover...
Owners Manual - Page 4
... C-CLIP
FIRST HOSE SECTION
TO SKIMMER OR VAC-LOCK
Make sure the Flow Gauge is purchased, install between 1st and 2nd hose sections.
6
Step 2 Pull hose to prevent air leaks. Insert Flow Gauge into the leader hose.
TIP: Wetting the hose ends will make it easier to connect the hose sections. INSTALLATION
Sizing Suction Hose
Step 1 Connect hose sections.
Owners Manual - Page 5
... If the disk is outside of the box on and allow it to a Vac Lock:
Insert the hose end directly into the
Valve. 4. Close the Regulator Valve by using the cone. Turn the blue collar...the filter system on the "MAX" side and you have connected your hose to tapered male end of the following: • Suction Valve(s) in the proper location, move on the Flow Gauge. REGULATOR VALVE
9...
Owners Manual - Page 6
Fill hose completely with the Cleaner. The Regulator Valve cannot be used to remove all air. Step 6
Step 7
Submerge the Cleaner into the water to INCREASE the ...
Owners Manual - Page 7
SUCTION
• Not Climbing the Walls or Stays on Steps/Liner/Obstacles
Your Cleaner should move about the pool without spending an excessive amount of time against the steps or...64258;apper adjuster to Position I. Due to Position III.
• Sucking Air At Surface or Climbing Too High
SUCTION
12
Be aware that your Cleaner will not climb a wall every time it comes into contact with one.
180mm...
Owners Manual - Page 8
... as bad as not to move properly.
Coiled hoses are not covered under the Hayward Warranty. Do not add chemicals to its suction source (i.e. Do not swim while cleaner is securely attached to the pool while cleaner is out of the pool, always disconnect the leader hose from the Skimmer/Regulator Valve,
"backwashing", so as...
Owners Manual - Page 11
... gear assemblies for application Lack of/improper water flow through cleaner
Cleaner fails to climb vertical walls gunite/ concrete pool
Blockage of the Cleaner throat Worn shoes Worn wings
Hose too short
Improper tension on rear flap
Cleaner climbs to water surface and sucks air
Steering failure
SOLUTION
Check water...
Owners Manual - Page 12
... HEAVIER than WATER, and should not "float
The Cleaner head is actually bottom of the pool by the cleaner hose, or return line flow -either at the surface or at the bottom of the pool -or both directions
3.
WARRANTY CLAIM
What do I do if I have to the Customer (including liability for...
Owners Manual - Page 13
To take a closer look at other product manuals or other Hayward® products, go to www.hayward-pool.com.au or call 1300 POOLS1
PO Box 4384 I Dandenong South, VIC, 3164
Similar Questions
We Assembled The Vacuum But Cannot Get The Vacuum To Go. Filter Has Been Back F
we assembled the vacuum but can't get it to start vacuuming. Filter was back flushed, rinsed, basket...
we assembled the vacuum but can't get it to start vacuuming. Filter was back flushed, rinsed, basket...
(Posted by Jenonjack73 11 months ago)
I Recently Lost Power, Now My Ecommand 4 Panel Will Not Turn My Pump On.
I can only turn the pump on and off with the panel breaker. The panel is no longer controlling the p...
I can only turn the pump on and off with the panel breaker. The panel is no longer controlling the p...
(Posted by karenmonroelvnv 9 years ago)
Dual Pool Spa System But The Settings Menu Doesn't Show Pool Heater Only Spa Hea
(Posted by Anonymous-39619 12 years ago)
Why Does It Keep Turning On Side On Bottom Of Pool And Laying There
(Posted by kdorman6 12 years ago)