Hayward Pro Logic Support Question
Hayward Pro Logic Support Question
Find answers below for this question about Hayward Pro Logic.Need a Hayward Pro Logic manual? We have 5 online manuals for this item!
Question posted by vonsuskil on October 12th, 2013
Electrolytic Cell
Where is the electrolytic cell? I understand there is a self-cleaning feature but the filter was just changed and a cell inspection is to follow.
Thanks,
Jim
Current Answers
Related Hayward Pro Logic Manual Pages
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 1
... (not scheduled)
inspect cell reason hi-speed is running (not scheduled)
countdown time remaining heater control status system manual off check system error group active
filter vsp speed/reason spa filter vsp speed/reason
lights/aux speed/reason pH/ORP levels
spa heater1 temperature pool heater1 temperature spa heater2 temperature pool heater2 temperature
spa heater2 priority pool heater2 priority...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 2
...followed, including the following:
• READ AND FOLLOW ALL INSTRUCTIONS
•
! Hayward/Goldline also warrants its Aqua Rite, Aqua Rite Pro...Pro Logic and E-Command pool automation products as well as rails, ladders, drains, or other similar hardware within 3 meters of the pool, spa...REPLACEMENT CHLORINATOR CELL OTHER THAN AN UNMODIFIED, NEW HAYWARD/GOLDLINE CHLORINATOR CELL PURCHASED FROM...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 3
...Before Startup 41 Heater Checkout 41 Service Mode 42
7. Table of Contents
Introduction
Before You Begin 1 Installation Steps 2
1. Warranty
Pro Logic Limited Warranty 44
43 Separate Heaters 9 "Dual Equipment" Pool/Spa - Configuration
Group Function 22 Configuration Menus 24 Maintenance Menu 40
6. Electrical Wiring
Main Service 12 Grounding and Bonding 12 Circuit...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 4
... the Pro Logic system, check that the following components have been included in power supply included
1
• The display will periodically indicate that you to turn outputs on/off manually at the end of the 5 minute heater cooldown period. Order Separately
T-CELL-3
Pick N MixTM Chlorinator Cell (for pools up to 15k gallons)
T-CELL-9
Pick N Mix Chlorinator Cell (for pools...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 5
... desired functions. The Pro Logic is running . Check that the Pro Logic is properly grounded and bonded. 6.
if not, then check the following: • The heater is enabled (Configuration Menu/Heater Config.). • The heater temperature setting is at least 2ºF greater than the water temperature (Settings Menu / Pool Heater & Spa Heater). • The filter pump is running...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 8
...Pro Logic functions. The Control Center is suitable for normal filter operation. Do not mount the Pro Logic inside the box), it will take 24 hours to respond to the change
Select 6B Spa A
6B A, Button 1 Pool/Spa
Push to access the 6 Button Spa...cables supplied with the Turbo Cell, flow switch, temperature sensors, and valve actuators (if applicable) are set to "spa only" or "spillover" ...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 9
...cell model based on either solar or dual equipment function.
Valve3 Config. + to view/change... after the spa filter but before installing the Pro Logic. Refer to...pool and spa lights as well as provide programmable light shows. A water sensor and an air sensor must be purchased. The following models are included with the chlorination function, the Pro Logic senses the pool...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 11
... raised spas)
WATER FEATURE
VALVE
WATER FEATURE
PUMP
SPA JET PUMP
SPA POP-UP
IN-FLOOR CLEANER
SKIM
SUCTION CLEANER
MAIN DRAIN
ENERGY SAVER PRESSURE CLEANER
SPILLOVER
POOL
OVERFLOW POP-UP
POP-UP
POP-UP
RETURN JET
VALVE WATER FEATURE
PUMP WATER FEATURE
NON-BOOST PRESSURE CLEANER
PRESSURE CLEANER
Some important notes regarding the Pro Logic control of a 2-Speed Spa Filter Pump...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 12
...:
Pool/Spa Setup Pool and Spa-Dual
Heaters Htr1=Spa,Htr2=Pool
1.
b. The dual equipment spa sensor should be changed . PS-8: Aux1 through Aux14.
The spa filter can not be a
one , two or variable pump. This is renamed "Pool Filter" and can be changed . The "Filter" pump automatically is the speed of the aux outputs control function. Aux1 Name The Pro Logic allows...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 13
... running and solar heat is available and the water is NOT disabled, the Pro Logic will override any water feature or pressure side cleaner boost pumps are two Group menus; If any previous Group function. The pool filter
can chlorinate both the pool and spa (during spillover operation). Group - When activating Group functions, be a one, two or...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 14
... spa filter pump is required. Otherwise, the Pro Logic will only chlorinate the pool when the spa does not control the heater(s) and the spa sanitization will appear under the "Filter Config." Turbo Cell (choose proper model for all available names Move to this system at startup, only the Lights Name menu will have assigned. Lights Config. + to view/change...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 22
..." = T-CELL-15, GLX-CELL-15-W
24 If both solar and dual equipment are installed: Never connect more detailed information about using the Pro Logic menu system, refer to any Aqua Rite(s) that is 500 ft (160m).
19
Accessing the Configuration Menus
Configuring the Pro Logic requires that the terminals on both the pool and spa according to the following...
Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installation - Page 24
... attempting to the Pro Logic as shown below . Function Pool/Spa Pool Filter Lights (standard relay) Lights (dimmer relay) Lights (VSP relay) Spa Filter Aux1-14 (standard relay) Aux1-14 (dimmer relay) Aux1-14 (VSP relay) Valve3 Valve4 Spa Htr1 Set Pool Htr1 Set Spa Htr2 Set Pool Htr2 Set Spa Solar Set Pool Solar Set SuperChlr
Control Parameter Unaffected, Pool only, Spa only, or Spillover...
Model: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Operation - Page 1
... decrease. Stabilizer 60 - 80 ppm Add cyanuric acid to increase.
Calcium
200 - 400 ppm Add calcium to increase. Electrolytic Cell inspect & clean Refer to decrease -OR- Elizabeth, NJ 07207
092331D RevF Copyright © 2010 Hayward
Pro Logic
Automation and Chlorination
Operation Manual
for models
PL-PS-4 PL-PS-8 PL-PS-16
PL-PS-8-V PL-PS-16...
Model: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Operation - Page 2
...09) Hayward/Goldline warrants its Pro Logic and E-Command pool automation products as well as... A REPLACEMENT CHLORINATOR CELL OTHER THAN AN UNMODIFIED, NEW HAYWARD/GOLDLINE CHLORINATOR CELL PURCHASED FROM HAYWARD/...area of the swimming pool, spa, or hot tub to a pool or spa, war or acts...not permit children to be followed, including the following:
• READ AND FOLLOW ALL INSTRUCTIONS
•
...
Model: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Operation - Page 3
... System Operation
Output Names 3 Filter Pump 3 Lights and Aux Outputs 4 Pool/Spa Valves 4 Heaters 5 System ...Spa - Table of Salt 36 How to Add or Remove Salt 36
System Maintenance
Servicing and Cleaning the Chlorinator Cell 39 Winterizing 39 Spring Startup 39
Troubleshooting & Diagnostic Information
Service Mode 40 Check System Indicator 40 Diagnostic Menu 42
Warranty
Pro Logic...
Model: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Operation - Page 4
...-4 (-8, -16) can control pumps, valves, lighting, heaters, and chlorination. The Pro Logic can control up to 4 (8 for
PS-4) PS-8,
PS-16)
120/240V Relays
Pool/Spa Suction & Return Valves
General Purpose Valves (2)
Heaters (2)
24V Valve Actuators
Chlorinator Cell
EXPANSION UNIT
(used to fully manage your pool/spa system. Aspects of the main unit (typically located near the...
Model: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Operation - Page 11
... chemistry per the levels indicated in an area that allow you to customize the operation of your pool/ spa equipment. The Pro Logic electrolytic cell has a self cleaning feature incorporated into the electronic control's logic. Note that a buildup on the cell indicates that there is an unusually high calcium level in severe cases where flushing and scraping will scratch the coating...
Model: PL-P-4 Operation - Page 8
... no spa related menu items will change this by displaying the message "Inspect/Clean Cell" after cleaning your pool. If deposits are in the selected menu. Winterizing
The Pro Logic electrolytic cell and flow detection switch will remind you on the cell indicates that are visible, reinstall.
Menu
Press the "MENU" button to get "out of the button will rotate through the filter...
Model: AQL-CHEM-3 Installation and Operation - Page 6
...following levels:
• 5 gallons of 4:1 solution for pools up to 15,000 gallons of water • 10 gallons of 4:1 solution for pools up to 30,000 gallons of water • 15 gallons of 4:1 solution for pool above 30,000 gallons of water
Connect the AQL-CHEM-3 to the Aqua Rite Pro or Pro Logic... on the UNDERSIDE of the pool's return pipeAFTER the electrolytic cell and flow switch. Fasten the...
Similar Questions
Pro Logic Electrical Wiring
What wire do I need to run from the main panel to the Pro Logic PL-PS-8 unit (for a variable speed p...
What wire do I need to run from the main panel to the Pro Logic PL-PS-8 unit (for a variable speed p...
(Posted by girmant 2 years ago)
How To Fix Ecostar Comm Bus Offline & Pro Logic Vsp Comm Error?
I cannot get my Hayward Pro Logic board to communicate with my Hayward Ecostar VSP pump. The pump sa...
I cannot get my Hayward Pro Logic board to communicate with my Hayward Ecostar VSP pump. The pump sa...
(Posted by m72422 7 years ago)
Pro Logic Automation And Chlorination Why Does My System Say Service Mode System
Pro logic automation and chlorination Why does my system say service mode system locked
Pro logic automation and chlorination Why does my system say service mode system locked
(Posted by Angiegirl2940 10 years ago)
After Cleaning The Salt Cell On The Pro Logic, How Do You Reset?
(Posted by willyspoolcare 11 years ago)