HoMedics PS-250 Support Question
HoMedics PS-250 Support Question
Find answers below for this question about HoMedics PS-250.Need a HoMedics PS-250 manual? We have 1 online manual for this item!
Question posted by carlosproesamer on September 29th, 2022
Frase Clamp Of 250
tu buy a crease clamp for then model 25
Current Answers
Answer #1: Posted by SonuKumar on September 29th, 2022 9:36 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,638,170
Member since:
May 9th, 2021 Points: 16,638,170
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related HoMedics PS-250 Manual Pages
Downloadable Instruction Book - Page 2
... the unit cool for at least 30 minutes before putting away. SAVE THESE INSTRUCTIONS
3 Do not leave appliance unattended while plugged in. • Never steam a garment while it is absolutely
necessary, a 15 ampere rated cord should be hot water in water or other liquids. • Never pull cord to HoMedics Service...
Downloadable Instruction Book - Page 3
... the hose connector. NOTE: Do not use an adapter (such as shown in Figure B may hang the steamer handle onto the hanger attachment (Fig. 3). Figure E 4
Pole Turn
Hanger Attachment
Figure 1
Clips
Figure 2
Fabric Brush
Figure 3
Crease Clamp
Turn
Figure 4
Nozzle Tab
Figure 5
Perfect Steam Features
• Safe for use on the hanger attachment...
Downloadable Instruction Book - Page 4
... . Remove the water tank from the nozzle. 4. Hang the garment onto the hanger attachment (Fig 8). When the unit runs out of the water tank. NOTE: Be cautious when handling until steamer has fully cooled.
6
Fabric Brush Steamer Nozzle
Handle
Hose
Pole
Hanger Attachment
Clips
Crease Clamp
Pole Connector
Hose Connector
Indicator Light Reset Button
Water...
Downloadable Instruction Book - Page 5
... connector until full. 8. dissipates. 12. If the procedure above does not return the unit to the steam nozzle (Fig. 5). - Place the garment between the crease clamp and steam nozzle. - Be sure the steamer is turned off and unplug the power cord. 2. Empty any water in severe cases no steam is being careful not to...
Downloadable Instruction Book - Page 6
...and push reset to "ON" position. If the reset light comes on side of the steamer, never store without cleaning and removing excess water from nozzle Condensation in hose
Nozzle gurgles
Condensation...it may be necessary to remove mineral buildup. 3. Trouble Shooting the Steamer
PROBLEM Steamer fails to heat
No steam
CAUSE Steamer not plugged in ON/OFF switch not in "ON" position Auto shut...
Downloadable Instruction Book - Page 7
... DAMAGES. Any and all rights reserved. IB-PS250A
12
PerfectSteam®
plancha a vapor comercial para ropa
Manual de instrucciones e Información de garantía
13
PS-250 HoMedics warrants that requires modifications or adoption to enable it was designed, manufactured, approved and/or authorized, or repair of an operating part from a Retailer...
Similar Questions
My Ps 250b Won't Come On We Tried Testing With Ohm Meter There Was A Infinite Re
what should I do
what should I do
(Posted by Davedebtx 7 years ago)
Ps-250 Rocker Power Switch
my steamer power rocket switch broke. I need a new off/on rocker switch that has 3 prongs. My model ...
my steamer power rocket switch broke. I need a new off/on rocker switch that has 3 prongs. My model ...
(Posted by ac3653 8 years ago)
Light Abovebreset Button.
I have a PS 250 and the light above reset button won't go off, even though I flick the switch. Unit ...
I have a PS 250 and the light above reset button won't go off, even though I flick the switch. Unit ...
(Posted by marcialettman 9 years ago)