Hoover FH52000 Support Question
Hoover FH52000 Support Question
Find answers below for this question about Hoover FH52000.Need a Hoover FH52000 manual? We have 1 online manual for this item!
Question posted by Sharifmgmt on August 10th, 2022
Wont Turn On Fh52000g.
How to disassemble to get to motor
Current Answers
Answer #1: Posted by Odin on August 10th, 2022 5:46 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,620
Member since:
April 10th, 2010 Points: 41,236,620
Before trying to disassemble the unit, consider these simpler solutions: Go to the fIrst-listed PROBLEM ar https://www.manualslib.com/manual/1426282/Hoover-Smartwash-Fh52001.html?page=23#manual.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/hoover.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/hoover.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by SonuKumar on August 10th, 2022 9:41 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,673,070
Member since:
May 9th, 2021 Points: 16,673,070
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Hoover FH52000 Manual Pages
Product Manual - Page 4
... at voltage specified on data label on back of stairs or
on cord. Unplug from openings and moving parts.
• Turn off all controls before operating.
• Operate vacuum only at bottom of vacuum canister.
• Do not leave appliance when plugged in. WASH HANDS AFTER HANDLING. To avoid injury or damage, keep...
Product Manual - Page 9
...towel) to a hard surface and (b) place unit on an absorbent material (such as a traditonal vacuum cleaner.
This removes residual carpet cleaning solution. Gently rub surface with a white paper towel.
CAUTION... cleaned. Remove Solution Tank and repeat. NOTE: Empty Dirty Water Tank when the motor sound becomes higher pitched and there is marked with a Hoover® Cleaning Solution*....
Product Manual - Page 11
Using Your SmartWash™ Carpet Cleaner
1 Unwrap the power cord and plug unit in an electrical outlet.
3 Step on the Power Pedal to turn ON.
2 Step on the Handle Release Pedal to recline the unit for cleaning position.
11
Product Manual - Page 13
... off float within your dirty water tank. Once the float is equipped with a shut off the air flow through the nozzle. Maintenance
How to Empty
1 Turn the cleaner off and unplug from carpet cleaner base at an angle.
3 Place on a flat surface and unlatch Dirty Water Tank lid to remove top...
Product Manual - Page 14
... secured before cleaning.
Avoid saturating carpet. Notices
!
If misplaced, poor to soak up drips.
14 Water will result.
! NOTE: Empty Dirty Water Tank when the motor sound becomes higher pitched and there is visible passing through the nozzle.
IMPORTANT ! Do not clean over floor electrical outlets. For heavily soiled areas, repeat...
Product Manual - Page 16
...an angle, align side B on a carpeted or wood surface. LUBRICATION
The motor is equipped with clean water.
16
Allow brushes and underside of the motor. B
2 Press Tab A down until brush snaps in upright position, follow... injury from moving parts, unplug before storing carpet cleaner on the brush to motor bearings or brushrolls.
Therefore, do not add lubricant to the drive gear. A
STORAGE...
Product Manual - Page 19
...or damage.
19 When finished cleanin, follow "after Cleaning" and "After Using Tool" instructions.
8 Turn cleaner ON. FlexForce™ PowerBrushes will also see the float rise and shut off suction at end...cleaning on floor. Release trigger at the same time. Empty Dirty Water Tank when the motor sound beccomes higher pitched and there is completely dry before using the tool again. You ...
Product Manual - Page 23
...Filter clogged
4. Blockage in the hose & pump
1. Clean Water Tank or Detergent Container is secure. Turn off engaged 1. Air is trapped in hose
8. Not connected properly
2. Make sure tank is not... defective
1. Check fuse or breaker in upright position
2. See "How to one minute.
2. Turn on the Cleaner. Clean Water Tank or Solution Tank empty
2. Unit in home.
3. PROBLEM ...
Similar Questions
Compression Spring Instructions Smartwash Carpet Cleaner Fh52000
I can't find a picture or instructions for reinstalling the compression springs on the brush cover f...
I can't find a picture or instructions for reinstalling the compression springs on the brush cover f...
(Posted by jeanniecharvey 9 months ago)
Belt Change For Hoover Fh52000
Step by step process to check or change belt of hoover FH52000
Step by step process to check or change belt of hoover FH52000
(Posted by roouj 1 year ago)
I Need To Change Belt On My Fh52000. Help!
My smartwash started to smell like a burning smell and then stopped. It won't turn on. I am getting ...
My smartwash started to smell like a burning smell and then stopped. It won't turn on. I am getting ...
(Posted by chooselove67 2 years ago)
My Hoover Windtunnel T-series Pet Rewind Bagless Upright Vacuum Wont Turn On.
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
(Posted by megancorgan 11 years ago)