Husqvarna HU700F Support Question
Husqvarna HU700F Support Question
Find answers below for this question about Husqvarna HU700F.Need a Husqvarna HU700F manual? We have 2 online manuals for this item!
Question posted by reginaldrucker904 on September 24th, 2023
Gasket Assembly And Choke Hookup
My Husqvarna hu700f self propelled won't stay running and when it does it runs to hard. The gas cutoff was broken and I replaced it with another hose and cutoff. When I started the engine it was running to high and every time I start it it does this. I think my gaskets need replacing because I didn't do anything to it and now I have to run it on full choke or it won't stay running. I have to attach something to force the choke lever to stay on full choke.
Current Answers
Answer #1: Posted by SonuKumar on September 24th, 2023 9:06 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,620,300
Member since:
May 9th, 2021 Points: 16,620,300
It sounds like there are a few possible reasons why your Husqvarna HU700F self-propelled lawnmower isn't staying running and is running too hard.
Gaskets need replacing: If you think your gaskets need replacing, then that is a good place to start. Gaskets can become damaged over time, which can cause air leaks and fuel leaks. This can lead to a number of problems, including engine stalling, rough running, and excessive fuel consumption.
Carburetor needs cleaning: Another possibility is that your carburetor needs cleaning. The carburetor is responsible for mixing air and fuel in the correct proportions for the engine to run properly. If the carburetor is dirty, it can cause the engine to run too rich or too lean, which can lead to stalling and other problems.
Choke lever is not working properly: The choke lever is used to restrict the airflow into the engine when it is cold. This helps the engine to start and run smoothly. If the choke lever is not working properly, it can cause the engine to stall or run too rich.
To troubleshoot the problem, I would recommend the following:
Check the gaskets: Inspect the gaskets for any signs of damage, such as cracks or tears. If you find any damaged gaskets, replace them immediately.
Clean the carburetor: Remove the carburetor and clean it thoroughly with carburetor cleaner. Be sure to follow the instructions on the carburetor cleaner can.
Inspect the choke lever: Make sure that the choke lever is moving freely and that it is closing completely when the choke is engaged.
If you have checked all of the above and your lawnmower is still not running properly, then it is best to take it to a qualified technician for further diagnosis and repair.
Here are some additional tips for troubleshooting your Husqvarna HU700F self-propelled lawnmower:
Make sure that you are using the correct type of fuel and oil.
Check the air filter and replace it if it is dirty.
Check the spark plug and replace it if it is worn or damaged.
Make sure that the throttle cable is properly adjusted.
If you are not comfortable troubleshooting the problem yourself, please take your lawnmower to a qualified technician for assistance.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna HU700F Manual Pages
Owners Manual - Page 1
Gasoline containing up to 10% ethanol (E10) is acceptableforuseinthismachine. Theuseofanygasolineexceeding 10% ethanol (E10) will void the product warranty.
532 44 59-33 Rev. 2
Operator's Manual Owner's Manual
HU700F / 961450006
Please read the operator's manual carefully and make sure you understand the instructions before using the machine. English
Owners Manual - Page 2
....
Be thoroughly familiar with side shields when operating mower. Always wear substantial foot wear.
• Do not pull mower backwards unless absolutely necessary. CHILDREN
Tragic accidents can occur if the operator is extremely flammable and the vapors are familiar with the engine run .
• Disengage the self-propelled mechanism or drive clutch on a slope, do...
Owners Manual - Page 3
...; If fuel is running . If this owner's manual. Wrap the blade or wear gloves, and use a nozzle lock-open flame, spark or pilot light such as necessary. WARNING: This lawn mower is complete.
CONGRATULATIONS on your vehicle before filling.
• Remove gas-powered equipment from plug to prevent accidental starting.
• Keep nuts...
Owners Manual - Page 4
... UP YOUR LAWN MOWER
TO UNFOLD HANDLE (See Fig. 1)
IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES.
1. Make sure the frame handle is outside of those parts left unassembled for shipping purposes. Your new lawn mower has been assembled at .
3. IMPORTANT: THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE.
Owners Manual - Page 5
...EACH WHEEL)
HOUSING SPARK PLUG
IMPORTANT: This lawn mower is running. OPERATOR PRESENCE CONTROL BAR -
Learn and understand their meaning.
Consumer Product Safety Commission. MEETS CPSC SAFETY REQUIREMENTS
Our rotary walk-behind power lawn mowers conform to start the engine. used for future reference. OPERATION
KNOW YOUR LAWN MOWER
READ THIS OWNER'S MANUAL AND SAFETY RULES...
Owners Manual - Page 6
...LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory for high cut, adjust cutting height to start and operate the mower. Operate mower to increase drive speed.
3. DRIVE CONTROL (See Fig. 3)
• Self-propelling... as required.
4. ENGINE ZONE CONTROL
CAUTION: Federal regulations require an engine control to be replaced.
• Your lawn mower is running.
2. Be sure ...
Owners Manual - Page 7
... remove mulcher plug. Remove grass catcher with the rear door removed or propped open .
Rear mulcher plug installed. 2.
FOR SIDE DISCHARGING 1.
CAUTION: Do not run your lawn mower without mulcher plug or approved grass catcher in place. PIVOT PINS
REAR DOOR
GRASS CATCHER
HANDLE
MULCHER PLUG
CATCHER FRAME HOOK
FIG. 6
TO EMPTY GRASS...
Owners Manual - Page 8
...Pour oil slowly. You may need to settle. Engine holds 18.5 ounces of operation or each use , see "ENGINE" in the engine.
OPEN MULCHER DOOR
INSTALL DISCHARGE DEFLECTOR
OPERATION
BEFORE STARTING ENGINE
ADD OIL (See Fig. 10)
Your lawnmower is...to use . OIL FILL CAP/ DIPSTICK
GASOLINE FILLER CAP
MOWER IS NOW READY FOR DISCHARGING OPERATION
FIG. 9
UPPER LOWER MARK MARK
FIG. 10
8
Owners Manual - Page 9
... mow your width of the blades.
• Avoid cutting your highest engine (blade) speed as very tall grass, it run the lawn mower over fill. OFF
CHOKE LEVER
MOWING TIPS
CAUTION: Do not use engine or carburetor cleaner products in storage. To prevent this time the grass has dried, yet the newly cut path and mow...
Owners Manual - Page 10
... *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel system or add Stabilizer
* (if so equipped)
** Electric-Start mowers
*** Power-Propelled mowers...
Owners Manual - Page 11
... customers expense, may cause tire damage. ENGINE
Maintenance, repair, or replacement of the straight nail exposed. The wheels not turning freely means trash, grass cuttings, etc., may be hosed with lubricant to prevent blade from spark plug and place
wire where it will cause eventual damage to lawn mower or engine.
• The blade can harm...
Owners Manual - Page 12
....) improve starting in contact with oil. Clean by gently tapping on a clean surface.
3.
Remove cover. 2.
lay aside on a flat least once a year if the lawn mower is 18.5 oz. SLOT
CONTAINER
TAB
FIG. 14
4. Fill engine with plug.
2. Replace the air filter every 100 hours of the cartridge.
MAINTENANCE
LUBRICATION
Use only high quality...
Owners Manual - Page 13
... and other debris will be replaced. If no leaks are present, start engine (as described in the Operation section of this feature, proceed as follows:
1. CLEAN THE UNDERSIDE OF YOUR MOWER AFTER EACH USE.
WATER WASHOUT FEATURE (See Fig. 17)
Your lawn mower is clean. Remove grass catcher and discharge chute assembly from accumulating. Disconnect spark plug...
Owners Manual - Page 14
...in a high or low position. Reassemble upper handle and all parts removed from mounting pins.
4. Reinstall blade.
4.
Return mower to ...on its side with air filter and carbure- Turn lawn mower on blade adapter pulley, inside tabs of lower handle are...HARDENED BOLT WASHER
TRAILING EDGE
BELT CRANKSHAFT RETAINER
FIG. 19
TO REPLACE DRIVE BELT (See Fig. 20 & 21)
1. The mounting...
Owners Manual - Page 15
... customers expense, may result in a clean, dry area.
1. Be sure that the engine is running too fast or too slow, take your lawn mower handle for storage.
1. Inspect moving parts for a period of time, clean it may be performed by an authorized engine manufacturer's service outlet. sand lightly before painting. IMPORTANT: WHEN FOLDING THE HANDLE FOR...
Owners Manual - Page 16
... a few times to gasoline in any enclosure.
16 Add stabilizer to distribute oil.
4. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to cool before storing in fuel tank or storage container. Do not empty the gas tank and carburetor if using fuel stabilizer. CAUTION: Never store the lawn mower with new...
Owners Manual - Page 17
... in engine. 6. Replace blade adapter. 4.
Catcher not venting air.
1. Replace blade. 3. Grass is too high or wheel height is too low. 2. Rear of lawn mower housing or cutting blade dragging in OFF position. 10. Empty grass catcher. 4.
Adjust drive control.
17 Control bar defective.
9. Disconnected battery connector (if equipped). 12. Too much grass. 3. Blade adapter broken...
Owners Manual - Page 20
... Rental Use)
Riding Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if made by Husqvarna/Peerless)
3 Years
No Warranty
Transmission (if third party)**
**
**
XLS Models only - stamped deck shell. Limited Lifetime Warranty Battery
Other Non-Expendable Components Residential Zero Turn Mowers ( MZ & EZ )
Engine* Transmission **
MZ5424S & MZ5425S...
Parts List - Page 3
... Door Assembly Pop Rivet Screw, Self-Tapping ...Engine, Honda, Model Number GCV160LAOS3A (order parts from Honda) O-Ring Clip, Cable Grip, Foam (2 pieces) Belt Keeper Warning Decal (not shown) Operator's Manual, English / French
3
NOTE: All component dimensions given in U.S. HUSQVARNA ROTARY LAWN MOWER - IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. HU700F...
Parts List - Page 5
... Screw, Hi-Lo Thread Screw, Pan Head, Self-Tapping #10-24 x 2-3/4
KEY PART NO. HU700F (96145000601) PRODUCT NO. 961 45 00-06
KEY PART NO. Failure to do so could be hazardous, damage your lawn mower and void your warranty. MODEL NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. inches. 1 inch = 25.4 mm. HUSQVARNA ROTARY LAWN MOWER -
Similar Questions
Automatic Choke
Mower won't start unless spray either in carburetor.Choke parts side of carburetor super clean.Looks...
Mower won't start unless spray either in carburetor.Choke parts side of carburetor super clean.Looks...
(Posted by tyl586 2 years ago)
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
I Have A Cracked Wheel Dust Cover On My Hu700f Self Propelled Debri Getting Into
how do I remove e ring and pinion to replace wheel dust cover
how do I remove e ring and pinion to replace wheel dust cover
(Posted by MarkNina25 8 years ago)
Lawn Mower Runs For About 1 Minute And Then Shuts Off
(Posted by kelvincrain98 8 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)