Husqvarna M-ZT 61 Support Question
Husqvarna M-ZT 61 Support Question
Find answers below for this question about Husqvarna M-ZT 61.Need a Husqvarna M-ZT 61 manual? We have 3 online manuals for this item!
Question posted by dogman5474 on July 10th, 2013
Won't Start
Brand new M-ZT 61 started at shop. put on trailer and turned off...started it again. When I got home I drove it off the trailer and turned off. Now it won't start.
Current Answers
Answer #1: Posted by greggenie on April 4th, 2014 12:27 PM
greggenie
Member since:
April 4th, 2014 Points: 0
Member since:
April 4th, 2014 Points: 0
Will it crank? Make sure brake is on,blades disengaged levers out in neutral.If it still doesnt start lean the seat fwd and unplug safety switch and plug back in, bet that fixes it.If not call dealer who will probably have you do the same thing or bring it back. They may send a new switch.Dealer told me to unplug and plug back in and it worked.
Related Husqvarna M-ZT 61 Manual Pages
Operation Manual - Page 3
...Refueling 24 OPERATION 25 Training 25 Steering 25 Roll Bar and Safety Belt 26 Before Starting 26 Starting the Engine 27
Jumper Cables Use 29
Running 30 Operating on Hills 31 Stopping ...V-belts 40 Cutting Blades 41 Adjusting the Mower Deck 42
Leveling deck 42 Anti-scalp Rollers 43 Caster Wheels 43 Hardware 43 Cleaning 44 ZT-3400 Powertrain 44 LUBRICATION 45 Lubrication Schedule ...
Operation Manual - Page 5
...Driving and Transport on mower. DO NOT operate this machine. Use only approved repair parts to the new owner. The following of... important for any resulting personal injury or property damage. Lawn mowers and all who are incorrect. This machine is equipped ... judgment, careful use extreme caution when towing. Make wide turns to the design of uses are also knowledgeable about the ...
Operation Manual - Page 12
...
8011-517
12 Children are often attracted to the presence of age before operating a riding lawn mower. CHILDREN CAN BE INJURED BY THIS EQUIPMENT. The American Academy of Pediatrics recommends that children.... Keep children out of a responsible adult other than the operator.
• Be alert and turn machine off if a child enters the area.
• Before and while backing, look behind ...
Operation Manual - Page 13
... refuel such equipment with a portable container, rather than from the truck or trailer and refuel it on a truck or trailer bed with the engine running. Do not use extreme care in handling gasoline....in fuel system, engine must not be started when the driver's floor plate or any protective plate for burns if touched. If this is risk for the mower deck's drive belt is complete. Never ...
Operation Manual - Page 17
.../1283 kg. • Read machine's operator manual before each
use. • ROPS bar is overturned or if alteration to ride. • Operate the mower smoothly - no jerky turns,
starts or stops. • When mower is stopped, set brakes securely and
use park brake. • If any part of the unit by damage if the...
Operation Manual - Page 20
... the parking brake before retrying.
If the engine does not start, wait about 10 seconds before moving the mower. The mower blades are disengaged when the knob is pressed down fully. Pull... brake before dismounting. Push in and turn the key clockwise to ACCESSORY for more than five seconds each time. On models equipped with headlights, turn the key clockwise to release it. IMPORTANT...
Operation Manual - Page 21
... and will stay on the hour meter will turn the ignition key to provide the engine with the blade activated. Avoid idling the engine for long periods, as there is used for best mower performance and battery charging. USE FULL THROTTLE WHEN MOWING, for cold starts to the run position and then engage...
Operation Manual - Page 22
... rear of the machine. Gradually turn in automobiles.
Tracking adjustment
Fuses
Fuses are made using the tracking bolt and tracking knob. Drive forward at full throttle and the full forward position on the left side) until the unit noticeably starts drifting right.
6. CONTROLS
Tracking Knob
If the mower is 15 psi (1 bar).
1. Tracking...
Operation Manual - Page 25
... Machine By Hand in that direction.
Pull back slightly on control levers, allowing the mower to the neutral position and the mower should push the mower (see Before Starting in a forward direction, first pull both control levers forward slightly. To zero turn in a forward direction, pull the right lever back towards the neutral position while...
Operation Manual - Page 26
WARNING! Perform the daily maintenance before starting the machine.
2.
Check that there is necessary to the desired position.
The ...
Raise the roll bar as soon as clearance permits.
Before Starting
1. Read the sections Safety and Controls before the engine can be started: • The blade switch for engaging the mower blades
must be depressed. • The parking brake must be...
Operation Manual - Page 27
... position.
Move the steering controls outward to the transport position
4. Sit on the seat. 2. Disengage the mower blades by
setting the lift pedal fully forward. 3. OPERATION
Starting the Engine
1. Activate the parking brake. Press the control for disengaging the mower deck
8058-214
Place controls in neutral position
8058-226
27
Raise the...
Operation Manual - Page 29
...is equipped with the discharged battery, away from both batteries. IMPORTANT INFORMATION
The mower is too weak to start the engine, it should be a 12-volt negative grounded system.
Connect the... 4.
Remove BLACK cable first from chassis and then
from batteries. Do not use the mower to start other end of the fully charged battery. 3. Jumper Cables Use 1. Remove RED cable ...
Operation Manual - Page 31
... across slopes.
• The slowest speed possible should be used before starting up or down hills.
• Avoid stopping or changing speed on Slopes in neutral position
IMPORTANT INFORMATION
Control levers return to neutral when released. This may cause the mower to suddenly stop.
8058-226
• To restart movement, release the...
Operation Manual - Page 33
... cutting performance, grass over 6" (15 cm) in height should be mowed twice.
When cleaning, the mower deck shall be raised into the soft lawn, clumps build, and the grass clippings fasten under the cowling.
• Hose the mower deck underside with a high cutting height and reduce it is important that the mowing interval...
Operation Manual - Page 34
...; the ignition key removed • the parking brake activated
2 1
When pushing or pulling the mower, engage the bypass linkages with the head outside the bracket and held into the bypass position 2. ... bypass linkage levels are located close to the muffler.
Release lever, engaged Right side, ZT-3400 linkage
8058-091
WARNING! OPERATION
Moving Machine By Hand
WARNING! The levers are located...
Operation Manual - Page 35
...) Check the safety system Check for fuel and oil leakages Check/clean the engine's cooling air intake Check the mower deck Check for loose hardware (screws, nuts) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt...
Operation Manual - Page 38
...the drive tires.
specified tires. Faulty adjustment result in reduced braking ability and can be started when:
• The mower deck is disengaged.
• The steering controls are engaged and the driver temporarily moves off...parking brake is on. Excessive loads created by attempting to start the engine when one of these conditions is not met, turn the machine off the driver's seat.
Operation Manual - Page 44
...spray water on the transaxle. Use compressed air to insure proper action and adjustment of the mower deck. Do not use (after it rotates and releases fully.
44
Check oil level in...is securely fastened to make sure the control arm is cooled), before the dirt sticks. ZT-3400 Powertrain
IMPORTANT INFORMATION
Any servicing dealer attempting a warranty repair must have prior approval before...
Operation Manual - Page 47
....
2. Place used oil in accordance with an external filter for each .
6. Top port plug ZT-3400 filter change interval of the replacement filter.
4. Place an oil drain pan (12" or ... to one full turn after the filter gasket contacts the filter base surface.
5.
Reinstall the filter guard. Install the new filter by hand. Fill with laws in the mower and the mower on the opposite ...
Operation Manual - Page 50
WARNING! Start the engine...carburetor if a stabilizer has been added.
Thoroughly clean the machine, especially under the mower deck. Change the engine oil; Always use the mixing ratios specified by the ...steps:
1.
Remove the spark plug and pour about a tablespoon of properly.
4. Turn over the engine so that can plug the carburetor and disrupt engine function. Touch ...
Similar Questions
My 2020 Mzt Will Not Start With A New Battery
Installed a new battery that is fully charged. the hour counter is inop. it appears the entire syste...
Installed a new battery that is fully charged. the hour counter is inop. it appears the entire syste...
(Posted by jllshopping 3 years ago)
No Response Trying To Start When Hot Mzt61 2015
After mowing the lawn and stop to clean machine it will not start. Starter does not engage. 4 volts ...
After mowing the lawn and stop to clean machine it will not start. Starter does not engage. 4 volts ...
(Posted by mkcooper 3 years ago)
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
It Will Not Crank When Hot.
Ather you mow for awhile, you cut off the engine and then try to crank it back up,It will not crank ...
Ather you mow for awhile, you cut off the engine and then try to crank it back up,It will not crank ...
(Posted by chiefowens141 8 years ago)