Husqvarna R 120S Support Question
Husqvarna R 120S Support Question
Find answers below for this question about Husqvarna R 120S.Need a Husqvarna R 120S manual? We have 1 online manual for this item!
Question posted by Rightstandingcontracting on August 5th, 2023
V Belt Sizes
What are the sizes of the rear drive belt
Current Answers
Answer #1: Posted by SonuKumar on August 5th, 2023 9:53 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,646,150
Member since:
May 9th, 2021 Points: 16,646,150
The rear drive belt size for a Husqvarna R 120S is 1/2" x 51". The belt part number is 5895631-01. You can find this belt at most lawn mower parts stores.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna R 120S Manual Pages
Owners Manual - Page 1
... de entender su contenido antes de utilizar la máquina
English (2-28) French (29-57) Spanish (58-85) Operator's manual Manuel d'utilisation
Manual de instrucciones
R 120S
Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Liattentivement et bien assimiler le manuel d'utilisation avant...
Owners Manual - Page 2
... Lubrication Checking the engine's oil level 25 Replacing the engine oil 25 Lubricating the front wheel bearings 25
2 - CONTENTS
Contents
CONTENTS Contents 2 INTRODUCTION Dear customer 3 Driving and transport on public roads 3 Towing 3 Use 3 Good service 3 Service journal Pre-delivery service 4 After the first 8 hours 4 KEY TO SYMBOLS Symbols 5 SAFETY INSTRUCTIONS...
Owners Manual - Page 3
... low speed, otherwise there is a valuable document. For example, before driving the machine on mower is securely held. Towing
When your dealer for any resulting damage or ...The machine's serial number. In addition, there is equipped with the relevant safety procedures. Driving and transport on safety and occupational medicine, and all times. Good service
Husqvarna products are ...
Owners Manual - Page 4
Check engine speed. Reverse drive. Safety switch for parking brake. Operation of following the service schedule. Seat safety switch. See the Technical data section. 9 Tell customer about: Needs and bene&#... wheel, seat and any optional equipment. 3 Check and adjust tyre pressure. (60 kPa, 0.6 bar, 9 psi). 4 Check that machine does not move in neutral. 8 Check:
Forward drive.
Owners Manual - Page 6
... in reverse unless absolutely necessary. These operators should evaluate their ability to operate the riding mower safely enough to neutral and coast downhill.
6. II. If you cannot back up and... operate this machine.
4. AMERICAN STANDARD SAFETY PRECAUTIONS
S• afety instructions for ride-on mowers
ANSI/OPEI B71.1-2012
IMPORTANT Safe Practices for all parts to come to a complete stop...
Owners Manual - Page 7
....
5. Check their proper operation regularly
4. Clean up .
English - 7 On slopes, the weight of the towed equipment may cause loss of traction and loss of ignition.
2. Mower blades are explosive.
1. Never remove gas cap or add fuel with a plastic liner. If fuel is complete. Never overfill fuel tank. Never operate...
Owners Manual - Page 8
... to a road or when crossing it . SAFETY INSTRUCTIONS
Safety instructions
These instructions are for the mower discharge and do not hit it from starting before you clean the cutting unit.
• Always...intended to stop the engine and remove the key before you start the engine, engage the drive or drive off the blades when you are not mowing.
• Take care when rounding a fi...
Owners Manual - Page 9
...any sudden changes in speed or direction.
• Avoid unnecessary turns on slopes is the greatest; Drive slowly. It is easier for help in moving parts.
• Never use or service it ...can lose their grip so that children be a
minimum of 12 year of age before operating
a riding lawn mower.
It is what you feel unsure, do
• Remove obstacles such as stones, branches, etc. ...
Owners Manual - Page 11
...before putting it in the eyes can cause cuts. Adjust and maintain as tension belts, chains or ropes when transporting.
• Check and observe local road traffic regulations... before starting.
• Never make repairs before transporting or driving the machine on the skin can cause serious crush injuries. Ensure you secure the machine...
Owners Manual - Page 13
...the blades automatically stop rotating (transport position). Cutting unit
The mower has a 2-blade cutting deck with two pedals. The lever...the pedals when mowing under
bushes.
The ground speed is fed to drive backwards.
1 2
Parking brake
The parking brake is provided by ...the lever is used to set the cutting unit in the lawn.
Make sure that will be used to temporarily regulate the...
Owners Manual - Page 14
... the machine to be moved when the engine is highly in the control to engage to the drive system. PRESENTATION
Cutting height adjustment lever
The cutting height can be pulled out in order for mower deck servicing only. Release lever
The release control must be adjusted to the end positions, do not...
Owners Manual - Page 16
...start other vehicle must also have a 12- When jump leads are used to drive forwards, and pedal (2) to drive backwards. equipped with a 12-volt system with negative earth. Do not use... the cutting unit.
• Connect each battery, exercise care not to short circuit any of the drive belts is drawn behind the black (-) cable. Therefore apply full throttle first when the cutting unit has...
Owners Manual - Page 17
...should then be increased without inferior mowing results.
• Avoid mowing a wet lawn. English - 17 Clear the lawn of carbon build-up on
! Mowing becomes more uniform and the grass cuttings ...engine speed, see technical data, (the blades rotate rapidly) and low speed (the Mower moves slowly). Driving
Cutting tips
WARNING! The mowing results are achieved if the grass is a risk of...
Owners Manual - Page 18
....
X = Described in this manual, visit an authorised service workshop. The ignition cable has been removed from the spark plug. Lubricate joints and shafts 3) Check the V-belts Checking and adjusting of the maintenance which should be lubricated twice a week. 4)Conducted by authorised service workshop.
The cutting unit is removed. English
The ignition...
Owners Manual - Page 19
...aggravate the damage.
Carry out extra lubrication when the bearings have been exposed to wash off the mower deck. IMPORTANT! There is a major risk of the machine hoods
Engine cover
The engine becomes ...hand fender
Loosen the screws holding the wing cover and lift off the cover.
To remove the rear cover completely, pull it is blown off.
Front cover
Release the clip on a thin layer...
Owners Manual - Page 23
...Loosen the spring on the drive belt's belt idler by loosening the handle.
7 Lift of the drive belt. 8 Grip the top ...tubular construction of the engine, which can be removed in the equipment frame.
3 Check that the cooling intake is free from the cutting deck.
4 Put the lifting lever in the mowing position.
11 Pull out the cutting unit. 12 Lift off the mower...
Owners Manual - Page 24
...
Damaged blades should be replaced.
Maintenance
Fitting the cutting head
1 Place the belt under the stay of the cutting deck.
8 Fit the belt according to the picture.
2 Make sure the lifting lever comes above the ...cutting deck grip.
9 Tension the belt with the belt adjuster.
3 Fit the cutting deck's pipe together with the deck frame's ...
Owners Manual - Page 26
... Long or wet grass Cutting unit skew Grass blockage under hood Different tyre pressures on right and left sides Over-speeding Engine speed too low Drive belt slipping
Owners Manual - Page 27
.... However, one should immediately be made ready for more ) can cause serious injury and
damage to distribute the oil and screw the plugs back on mower performs at least 10 minutes after adding the stabiliser so that your machine's purchase year, model, type, and serial number. Use degreasing agents
and hot...
Owners Manual - Page 28
Reverse speed, km/h Cutting unit Type Cutting width, cm/inch Cutting heights, 5 positions, mm/inch Blade length, mm/inch
R 120S
229 / 90.08 126,3 / 49.7 108 / 42.7 225 / 496 84 / 33.07 165/60-8 60 / 06 / 8.7 10°
Briggs & Stratton / ...ft Height, cm/ft Operating weight with cutting deck, kg/lb Wheel base, cm/ft Tyre dimensions Air pressure, rear - Note that no longer used .
28 -
Similar Questions
Voltage Regulator Location
Where Is The Voltage Regulator Location on A Husqvarna R 120s
Where Is The Voltage Regulator Location on A Husqvarna R 120s
(Posted by axlegrinder230 1 year ago)
I Have A Husqvarna R120 S Articulating Mower I Need All The Belts Numbers And Si
I have a husqvarna r120s articulating mower w 42" deck an 19.5 hp motor I need all the belts part nu...
I have a husqvarna r120s articulating mower w 42" deck an 19.5 hp motor I need all the belts part nu...
(Posted by Tcfender80 2 years ago)
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
My Brand New R120s Won't Start
We connected the battery but it still won't start...ideas?
We connected the battery but it still won't start...ideas?
(Posted by jonalisa 9 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)