Bt 150 Primer Not Working?

You may need to replace the primer bulb. here is a video on how to locate the bulb.

https://www.youtube.com/watch?v=_e4Mh4HqWIk

I hope this helps

---

I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers

-INIMITABLE

If the primer bulb on your Husqvarna BT 150 blower is not working, there could be a few possible causes. Here are some troubleshooting steps you can take:

1. Check for blockages: Inspect the primer bulb and the fuel lines connected to it for any blockages. Debris or old fuel residue can clog the primer bulb and prevent it from functioning properly. Clean out any blockages using a small brush or compressed air.
2. Verify fuel lines and connections: Ensure that the fuel lines connected to the primer bulb are properly attached and not damaged or cracked. If you notice any issues with the fuel lines or connections, they may need to be replaced.
3. Prime the bulb correctly: Make sure you are using the correct priming technique. Press the primer bulb multiple times until you see fuel moving through the clear fuel lines, indicating that the bulb is primed.
4. Check fuel mix: Ensure that you have the correct fuel mix ratio for your blower. Using an incorrect fuel mix can affect the performance of the primer bulb. Refer to the owner's manual for the recommended fuel mix ratio and ensure that you are using fresh, properly mixed fuel.
5. Replace the primer bulb: If the primer bulb is damaged or deteriorated, it may need to be replaced. Contact an authorized Husqvarna service center or dealer to obtain the correct replacement bulb.

---

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!