1996 Isuzu Rodeo Support Question
1996 Isuzu Rodeo Support Question
Find answers below for this question about 1996 Isuzu Rodeo.Question posted by ramseypp450 on July 4th, 2012
No Space To Get Out The Two Upper Bolt Of The Transmision
my clutch just got burn on my rodeo , i m trying to get the transmission out but those 2 upper bolt i can not take them out no space
Current Answers
Answer #1: Posted by roadrunnertim on July 4th, 2012 8:20 PM
roadrunnertim
Member since:
May 9th, 2012 Points: 1,071,190
Member since:
May 9th, 2012 Points: 1,071,190
This is a common problem with Isuzu's. The best way I saw on how to do it is to support the tranny with a jack and remove the crossmember. Then slowly lower the back of the tranny down a few inches. That should give you enough room to get at the bolts with 3 or 4 feet of extensions and a swivel socket.
Answer #2: Posted by roadrunnertim on July 4th, 2012 8:20 PM
roadrunnertim
Member since:
May 9th, 2012 Points: 1,071,190
Member since:
May 9th, 2012 Points: 1,071,190
This is a common problem with Isuzu's. The best way I saw on how to do it is to support the tranny with a jack and remove the crossmember. Then slowly lower the back of the tranny down a few inches. That should give you enough room to get at the bolts with 3 or 4 feet of extensions and a swivel socket.
Similar Questions
Is The Clutch In This Vehicle Hydraulic..if So How Do U Bleed The Line?
the cluch was repaired a year ago no it doesn't work. the fluid resovoir was empty. So new fluid was...
the cluch was repaired a year ago no it doesn't work. the fluid resovoir was empty. So new fluid was...
(Posted by mdn1 10 years ago)
Clutch System
for two weeks it would slip some times. now the pedel goes almost to the floor with little signs of ...
for two weeks it would slip some times. now the pedel goes almost to the floor with little signs of ...
(Posted by nastylee617 12 years ago)
Loose Upper Control Arm Shaft
the mounting shaft bolt is loose on the right front upper control arm (this shaft is mount onto the ...
the mounting shaft bolt is loose on the right front upper control arm (this shaft is mount onto the ...
(Posted by angelnailsokemos 12 years ago)
Clutch Release Bearing And Lever Assemble
I need a diagram for the clutch release bearing and lever how it goes together?
I need a diagram for the clutch release bearing and lever how it goes together?
(Posted by montanamtman123 13 years ago)