Jenn-Air JGS8860BDP Support Question
Jenn-Air JGS8860BDP Support Question
Find answers below for this question about Jenn-Air JGS8860BDP.Need a Jenn-Air JGS8860BDP manual? We have 5 online manuals for this item!
Question posted by mazijan on August 17th, 2016
Warming Drawer Error Code
I have a Jenn air jes9800cab 30' slide in electric range and the hood doesn't work and there is a "warming drawer" error code in red on display! Please tell me what's the problem and how I can fix it?Thank you
Current Answers
Answer #1: Posted by zzed41 on August 18th, 2016 9:33 AM
zzed41
Member since:
December 12th, 2014 Points: 914,010
Member since:
December 12th, 2014 Points: 914,010
Hi! Please try the following steps.
- Power the unit off by pressing the "Power On/Off" key.
- Press and hold "Power On/Off" key, along with "MED" and "PROOF" keys simultaneously for 5 seconds; the display should now read "RE".
- Press and hold "TIMER" Up & "TIMER" Down simultaneously for 5 seconds; the unit will beep one time.
- Press "TIMER" Up one time and release. If cleared, display should now read "Error None".
- Exit diagnostic mode by pressing "Power On/Off" key.
- Verify unit operation by turning unit on and allowing to preheat.
Hope this helps! If it does, please click on the Accept Answer button. I will greatly appreciate it! :)
Related Jenn-Air JGS8860BDP Manual Pages
Dimension Guide - Page 2
...opening width F. clearance from back wall or range will not slide all the way back. Electrical and gas supply - 5½" (14.0...min. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for planning purposes only.
A. 13" (33.0 cm) upper cabinet depth B. 30" (76.2 cm) min. ...
Installation Instruction - Page 3
... or fire by installing a range hood or microwave hood combination that all governing codes and ordinances. Parts needed
■ Anti-tip bracket (taped to package containing literature in the kitchen.
■ Recessed installations must be avoided. Range Foot
Anti-Tip Bracket
To verify the anti-tip bracket is installed and engaged: • Slide range forward. • Look...
Installation Instruction - Page 5
... circuit serving only this range be installed with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1. Electrical Requirements
WARNING
Electrical Shock Hazard Plug into cutout. If codes permit and a separate ground wire is used, it is shielded by not less than 2¼" (5.7 cm) from back wall or range will not slide all the way back...
Installation Instruction - Page 10
...range.
3. Use wrench to look underneath the bottom of the
warming drawer to back.
The first time a burner is removed from the mounting wall, the rear range...air in place of the anti-tip bracket.
6. Do not operate the range without resistance, stop tilting the range...bracket.
Slide range back so the rear range foot is a snapping or popping sound when lifting the range, the range may...
Installation Instruction - Page 11
...60 seconds for it may take up on the display.
Remove the oven rack. 2. Place bake burner cover on the rear wall,
inside the storage drawer compartment. 3.
Adjust Oven Bake Burner Flame (if ...: The flame can be adjusted, locate the air shutter near the center rear of Oven Bake Burner
1. A B
A. Remove storage drawer or warming drawer. 2. Light 1 burner and turn to "HI... of the range.
Installation Instruction - Page 12
...range operation. The igniter used to light. Tighten air shutter adjustment screw.
This flame should be adjusted: 1.
To Replace Storage Drawer or Warming Drawer: 1. For more information, see which step was skipped.
2. If range...Range is plugged into the rails in the range. 2. Under certain conditions, it to light the broil burner will show
in the display. 3. Adjust the air...
Installation Instruction - Page 13
... of the oven.
Failure to do so can result in the slot of the anti-tip bracket. Slide range back so rear range foot is moved. B
A
C
A. Gas supply line
2.
See "Replace Oven Racks and
Storage Drawer or Warming Drawer" section. 3. See "Oven Door" section in death or serious burns to children and adults.
1. Securely tighten all...
Installation Instruction - Page 16
...Repeat steps 1 through 8 for Model JGS8750
Location
Burner Rating Color
Right Front 14,000 BTU
Red
Right Rear 9,100 BTU
Clear
Left Front
9,100 BTU
Clear
Left Rear
4,000 BTU
Blue
Number...the "Replace Oven Racks and
Storage Drawer or Warming Drawer" section for Models JGS8850 and JGS8860
Location Burner Rating Color
Number
Right Front 14,000 BTU
Red
114L
Right Rear 4,000 BTU
Blue...
Installation Instruction - Page 17
...oven bake burner to children and adults.
1. Slide range back so rear range foot is moved. Re-engage anti-tip bracket if range is engaged in the slot of the storage drawer compartment.
2
A B
IMPORTANT: Do not ...anti-tip bracket to the closed position) C. See "Replace Oven Racks and
Storage Drawer or Warming Drawer" section. 3. Remove the 2 oven bake burner screws and set aside along ...
Use and Care - Page 4
... with the National Electrical Code, ANSI/NFPA 70. Flammable materials should not be stored in accordance with a three-prong grounding plug for the anti-tip bracket securely attached to children in or on the doors or drawers.
■ Maintenance - Re-engage anti-tip bracket if range is installed and engaged: • Slide range forward. • Look...
Use and Care - Page 8
...Warm drawer O. Enter
A
B
C
D
E
F
G
H
I . Display
E. Clean J. Setup L. Enter
OP
Electronic Control Pads
When pressing any control pad function on each side of 1 hour or more than 30 seconds elapse between steps in the display... option in the display. When using the Timer, for settings of day. For settings of the display window and are used to the range or after entering ...
Use and Care - Page 12
... the beeps at the end of the oven control displays the Jenn-Air Customer eXperience Center toll-free phone number. 1. Use the right Quickset pad to scroll and select:
1-30 SEC to hear 1 beep every 30 seconds. Select the desired beep using the Quickset pads... highlighting the features of 12 hours if you unintentionally leave it is displayed at the end of the range. 1.
Use and Care - Page 19
... or proofing bread. It may be displayed. 5.
Meat probe jack
1.
Different types of poultry, away from room temperature. For best results, do not hold foods longer than 1 hour. Remove food from the oven when removing food. Cover foods with plastic wrap.
See "General Cleaning" section. Press WARM DRAWER when finished. 6. mashed ■ Poultry...
Use and Care - Page 24
...the Cycle Works IMPORTANT: The heating and cooling of cleaning time. The oven light will be displayed while the...average to certain birds.
RANGE CARE
Self-Cleaning Cycle (on some models)
WARNING
Prepare Cooktop and Storage Drawer or Warming Drawer:
■ Remove plastic ...display when the oven door has unlocked.
24 The Self-Cleaning cycle uses very high temperatures, burning soil to slide...
Use and Care - Page 26
... caps, do not bang grates and caps against each other or hard surfaces such as cast iron cookware. Remove racks or they will help them slide. ■ Steel-wool pad
STORAGE DRAWER OR WARMING DRAWER (on panel. ■ All-Purpose Appliance Cleaner Part Number 31682 (not included): See "Assistance or Service" section to...
Use and Care - Page 27
... tissue or wearing cotton gloves to remove the drawer. Plug in the range. 2. To Remove: 1. Fit the ends of the ceramic base.
4. Open drawer to its front, gently pull it is closed.
Lift drawer up and out.
Loop
3. Remove bulb from inside the warming drawer, and allow the warming drawer to cool completely before attempting to handle bulb...
Use and Care - Page 30
... Center.
This information will fit right and work right because they are available from whom your dealer or servicer.
4. Call the dealer from Jenn-Air Brand Home Appliances, Customer eXperience Centre.
30
Proof of your request. If you are having .
5. NOTE: When writing or calling about a service problem, please include the following information:
1. If you...
Use and Care - Page 31
... in materials or workmanship and is reported to Jenn-Air within 30 days from the date of purchase.
6. Repairs...Jenn-Air brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter "Jenn-Air") will pay for other damage to the finish of your major appliance. Costs associated with electrical or plumbing codes, or use of consumables or cleaning products not approved by a Jenn-Air...
Warranty - Page 1
... or workmanship and is reported to Jenn-Air within 30 days from the date of purchase.
6.
In Canada,
call 1-800-536-6247. Damage resulting from accident, alteration, misuse, abuse, fire, flood, acts of God, improper installation, installation not in accordance with electrical or plumbing codes, or use your authorized Jenn-Air dealer to determine if another warranty...
CAD - Page 1
... are appropriately UL, CUL or CSA approved.
00
00
I0
'LlANCE DIMENSION
2 FRONT ELEVATION
3 SIDE ELEVATION
[Manufacturer:
Jenn-Air
Model Number:
JGS8860BDP
JENN-AIR®
Date:
MM/DD/YY
Scale:
2iv - 1 1 0" 30 i" APPLIANCE DIM.
0 Lu 0 z aEL
PLAN
NOTE: Dimensional information is provided for planning purposes only. Do not make any cutouts based on this information. Refer...
Similar Questions
How Do I Set My Jenn-air Oven Jgs9900cd To Bake
(Posted by lesliesisley2003 11 months ago)
Pb With The Display Of My Jenn Air Jdrp436wp Screen Is Frozen
(Posted by bgunst 2 years ago)
My Jenn Air Jgs9900cds Range Shuts Off While Baking....
My Jenn Air JGS9900CDS will just shut off while I'm baking. The timer will keep running but the oven...
My Jenn Air JGS9900CDS will just shut off while I'm baking. The timer will keep running but the oven...
(Posted by Sctenney 8 years ago)
Jenn-air Jgs9900 Downdraft Fan Only One Speed Is Working
Only one of the 2 speeds is working on my Jenn-Air JGS9000 downdraft fan. Is there a fix for this
Only one of the 2 speeds is working on my Jenn-Air JGS9000 downdraft fan. Is there a fix for this
(Posted by kfcarpenter 8 years ago)
Does Was The Error Message Ee-214 M-214 Mean On A Jgs8750bdw
error message EE-214 M-214 appears on electronic control board of Jenair Range/oven model JGS8750BDW...
error message EE-214 M-214 appears on electronic control board of Jenair Range/oven model JGS8750BDW...
(Posted by iguana0007 10 years ago)