Jenn-Air JMC3415ES Support Question
Jenn-Air JMC3415ES Support Question
Find answers below for this question about Jenn-Air JMC3415ES.Need a Jenn-Air JMC3415ES manual? We have 5 online manuals for this item!
Question posted by thatnanny on March 14th, 2022
Jenn-air Install Kit With Duct System # For A Jmc3415es Microwave/convection Bui
- for building in area above oven. Just need the kit number so I can order it on line ? My dimensions of microwave are 24 7/8" W x 14 13/16" H x 19 1/8 " D
Current Answers
Answer #1: Posted by SonuKumar on March 15th, 2022 8:48 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Jenn-Air JMC3415ES Manual Pages
Dimension Guide - Page 1
... is used to ensure the oven has adequate space from back wall when installed for white spacer and back plate emboss. E* E*
F* F*
TOP VIEW SIDE VIEW
F* E*
D
IMPORTANT: Dimensional specifications are appropriately UL, CUL or CSA approved.
8791AdZw616 JENN-AIR® DETAILED PLANNING DIMENSIONS
BUILT-IN/COUNTERTOP MICROWAVE OVEN WITH CONVECTION
JMC3415ES - 245⁄8" x 141⁄4" x 191...
Dimension Guide - Page 2
JENN-AIR® DETAILED PLANNING DIMENSIONS
BUILT-IN/COUNTERTOP MICROWAVE OVEN WITH CONVECTION
JMC3415ES - 245⁄8" x 141⁄4" x 191⁄8"
2 of 3
OPENING/CLEARANCE DIMENSIONS
C
C
A
A
B
B
e
De
D
F*
E
E
FRONT VIEW
A
A
SIDE VIEW
MODEL #
JMC3415ES
30-inch Installation
27-inch Installation
in
cm
in
cm
A Width of cutout
291⁄4291⁄2
74.374.9
261⁄...
Dimension Guide - Page 3
... ventilation. VENTING REQUIREMENTS If microwave oven is built in, a trim kit is recommended. Refer to floor
36 91.4 36 91.4
E
F* Depth of cutout (min.)
23 58.4 23 58.4
e Recommended electrical connection location
* D epth requirements depend upon receptacle and its location within or outside of recommended region. JENN-AIR® DETAILED PLANNING DIMENSIONS
3 of frame
11⁄...
Flush Installation Instructions - Page 2
.../straight edge
■■ Pencil
■■ Drill (for wall cabinet installations)
■■ Z\zn" (0.16 cm) drill bit (for wall cabinet installations)
■■ 6" (15.2 cm) level Parts Supplied Check that can kill or hurt you don't follow instructions. BUILT-IN MICROWAVE OVEN SAFETY
Your safety and the safety of injury, and tell you...
Flush Installation Instructions - Page 5
...can
result in a risk of microwave oven. WARNING: Improper use an extension cord. If the power supply cord is properly installed and grounded. Product Dimensions
Trim Kit Frame Dimensions
A
AA
CC
B
DD
BB EE
C*
*Measurements include front facing of electric shock.
DIMENSION
Width (Dimension A)
Height (Dimension B)
Depth (Dimension C)
27" (68.6 CM) INSTALLATION 24M\," (63.2 cm)
14ZC...
Flush Installation Instructions - Page 6
...toward the back of cabinet is level.
#8-14 x 1⁄x" screw
Install Rear and Top Ducts
1. Fasten together with #8-18 x C\," screws just removed from the microwave oven.
Insert the edge of the double hole.
3.
On each side of duct 4, screw 1 #8-14 x Z\x" screw into the front-most hole of duct 1 into duct 4.
Duct 1
Duct 2
#8-18 x 3⁄," screw
#8-18 x 3⁄," screw...
Flush Installation Instructions - Page 7
...duct from front of rail. Make sure notch is incorrect.
27" (68.6 CM) INSTALLATION
30" (76.2 CM) INSTALLATION
26Z\v" (66.7 cm)
29Z\v" (74.3 cm)
Correct
Incorrect
Install Rails, Vent Deflectors, and Bottom Duct..., line-up with the microwave oven itself and not the door.
3.
NOTE: Drive screws in the center of the duct should be flush with drilled pilot holes, and insert 4 #8-14 ...
Flush Installation Instructions - Page 8
... screws just removed to left, remove the third and sixth screws from door.
4. Install Microwave Oven and Trim Kit Frame
1.
NOTE: Do not remove screws from the front of the microwave bottom plate. Make sure the feet are firmly seated in the same holes the screws were removed from the bottom duct. Riser
2. Embossment
5.
With the microwave oven near...
Flush Installation Instructions - Page 9
... use. Replace the fuse or reset the circuit breaker.
Complete Installation
1.
If you need the microwave oven model number and serial number. Remove protective film from the edge, so the trim kit frame will need additional assistance, call , you call us at vent area and pull away.
Align trim kit frame studs with corresponding holes
in only 1 way. 6. Check the...
Installation Instruction - Page 2
... wall cabinet installations)
■■ Z\zn" (0.16 cm) drill bit (for wall cabinet installations)
■■ 6" (15.2 cm) level Parts Supplied Check that can happen if the instructions are included. Trim Kit Frame (1)
Shims (1 pack)
Duct 1 (1) 2
Duct 2 (1) Duct 3 (1) Duct 5 (1) Bottom Duct (1)
Duct 4 (1)
Mounting Rails (2)
Bottom Duct Attachment Bracket (2)
#8-14 x Z\x" screws (20...
Installation Instruction - Page 5
...\v" (62.9 cm)
30" (76.2 CM) INSTALLATION 29C\v" (75.6 cm) 20Z\," (51.1 cm) 1Z\v" (3.2 cm) 14M\zn" (36.7 cm) 24C\v" (62.9 cm)
Electrical Requirements
WARNING
Observe all cord connected appliances: The microwave oven must be grounded. Required: ■■ A 3 prong, polarized 115- SAVE THESE INSTRUCTIONS
5
Product Dimensions
A
Trim Kit Frame Dimensions
AA
B
CC
DD
BB
C*
EE...
Installation Instruction - Page 6
... 2 #8-14 x Z\x" screws.
#8-14 x 1⁄x" screw Ducts 1 and 2
Duct 3
Failure to front of duct 1 into duct 3. Secure ducts 1 and 2 with 1 #8-14 x Z\x" screw. INSTALLATION INSTRUCTIONS
WARNING
Excessive Weight Hazard Use two or more people to duct 3 using 2 #8-14 x Z\x" screws. Insert the edge of microwave oven.
6. Secure duct 4 to move and install microwave oven.
4. Duct 4
#8-14...
Installation Instruction - Page 7
... the microwave oven itself and not the door. Correct
Incorrect
Install Rails and Bottom Duct
1.
Drill pilot holes for 2 holes on the front of duct is at bottom of duct 5 go under duct 4.
Pilot holes
5. Attach mounting rail using 4 #8-14 x Z\x" screws. Position bottom duct in cabinet so that each side of the bottom duct.
2. A
B
Dimension A must equal Dimension B. NOTE...
Installation Instruction - Page 8
Install Microwave Oven and Trim Kit Frame
1. Moving from right to install the Bottom Duct Attachment Brackets in embossments located on the risers. NOTE: Do not remove screws from the bottom duct. Riser
2. Secure the microwave oven to the first and fourth holes in the cabinet on risers.
Embossment
5. Make sure the feet are firmly seated in the same holes...
Installation Instruction - Page 9
... on the turntable and programming cook time of 1 minute at vent area and pull away. Installation is plugged into place.
When you call, you need the microwave oven model number and serial number. Remove protective film from the edge, so the trim kit frame will need additional assistance, call an electrician.
■■ Check that a household fuse has not...
Use and Care - Page 1
... Power 11 Time Cooking 11 Convection and Automatic Mix Cooking 11 Broil Cooking 13 Slow Cooking 13 Sensor Defrosting 13 Manual Defrosting 14 Sensor Cooking 14 Convect Bake/Roast/Broil 16 Multiple Sequence Cooking 17 More or Less Time Adjustment 17 Add Minute 17 Touch On 17 MICROWAVE OVEN CARE 18 General Cleaning 18 TROUBLESHOOTING 19 ACCESSORIES 21 WARRANTY 22
W10781928C...
Use and Care - Page 2
... paper, plastic, or other combustible materials are very important. We have provided many important safety messages in the "INSTALLATION INSTRUCTIONS" section. Do not use the microwave oven near a swimming pool, or similar locations. Call an authorized service company for storage purposes. I Keep cord away from paper or plastic bags before using electrical ...
Use and Care - Page 19
... Road Benton Harbor, MI 49022-2692
Please include a daytime phone number in death, fire, or electrical shock.
Microwave oven makes humming noise. Is the Timer in the magnetron cycles on the turntable support.
See "Deactivating Tones" in the "Microwave Oven Control" section. In Canada:
Jenn-Air Brand Home Appliances Customer eXperience Centre 200 - 6750 Century Ave. PROBLEM...
Use and Care - Page 22
...number ■■ Model number and serial number ■■ A clear, detailed description of the problem ■■ Proof of purchase including dealer or retailer name and address
IF YOU NEED SERVICE:
1. is installed, operated and maintained according to :
Jenn-Air...province to you also may not apply to province.
12/14
22 Some states and provinces do not allow limitations on ...
Warranty - Page 1
... or installation,
Whirlpool Corporation or Whirlpool Canada, LP (hereafter "Jenn-Air")
installation not in accordance with original model/serial numbers removed, altered or not easily determined.
Jenn-Air will pay... built-in -home repair.
■■ Sealed gas burners
13. Repairs to parts or systems to province.
12/14
22 which it was purchased or, at its sole discretion replace...
Similar Questions
Fan On Builtin Microwave Not Turning On But Foof Get Worm ?
Top Fan On Builtin Microwave Not Turning On But Food Get Worm ? Model M-130is It Dangerous To Operat...
Top Fan On Builtin Microwave Not Turning On But Food Get Worm ? Model M-130is It Dangerous To Operat...
(Posted by AMINVINOD 8 years ago)
Where Is The Light Bulb In The Microwave Of Jennair Jmw2430ws?
(Posted by Anonymous-151174 9 years ago)
What Are The Trim Kit Sizes For Jmc3215bs Microwave
(Posted by orthotom 9 years ago)
Microwave Oven
microwave model number JM8130DDS will not microwave anything. It counts down and the light comes on ...
microwave model number JM8130DDS will not microwave anything. It counts down and the light comes on ...
(Posted by williamhamilton9987 9 years ago)
Microwave Turntable Motor
I have now replaced the microwave turntable motor 3 times. Each time it starts to make squeeking ...
I have now replaced the microwave turntable motor 3 times. Each time it starts to make squeeking ...
(Posted by aaronlerer 10 years ago)