KitchenAid KUDS30IXSS Support Question
KitchenAid KUDS30IXSS Support Question
Find answers below for this question about KitchenAid KUDS30IXSS.Need a KitchenAid KUDS30IXSS manual? We have 4 online manuals for this item!
Question posted by middendorf859 on January 7th, 2014
How To Replace Inlet Valve W10316375 On Dishwasher Kuds#)ixss
The person who posted this question about this KitchenAid product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related KitchenAid KUDS30IXSS Manual Pages
Dimension Guide - Page 1
... Pro Line® handle, depth is not recommended). fuesd electrical supply. If direct wiring dishwasher: Use flexible, armored or nonmetallic, sheathed copper wire with dishwashers. Use a 90° elbow with product. Do not solder within 6" (15.2 cm) from water inlet valve.
A timedelay fuse or circuit breaker and separate circuit is 24" (60 cm) not...
Dimension Guide - Page 2
W10321585 2/7/11 Measured from narrowest point of opening.
(6214c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
(86m.344icn"m)
D
(10.42"cm) (7.63"cm)
(17.2 cm) (4.4 cm)
(6.4 cm)
(26.7 cm) (15.9 cm)
CAlreeaar
(4.4 cm)
(5.12"cm)
Because Whirlpool Corporation policy ...
Installation Guide - Page 2
...or hurt you don't immediately follow instructions. WARNING
Tip Over Hazard Do not use dishwasher until latched.
• Observe all electrical and plumbing national and local codes and ...Prepare and Route Water Line 8 Install Drain Hose 10 Install Moisture Barrier 11 Prepare Dishwasher 11 Make Power Supply Cord Connection 12 Determine Cabinet Opening 13
Installation Instructions (cont...
Installation Guide - Page 3
... electrical supply. In addition, for first-time installations Tools needed :
Additional parts supplied with
dishwasher
MSailkveersuGrreeaelnl these parts are used for use with top-venting models only:
" Torx® ..., call 1-800-422-1230.
3 If the wooden panel is recommended when installing a dishwasher under - 2 - Read and follow the instructions provided with any tools listed here. All...
Installation Guide - Page 4
... drain hose are within the shaded area shown in a location where it may be securely attached to accurately measure dimensions and ensure dishwasher is level if the floor in the dishwasher opening is available from your dealer for proper operation and appearance.
• cabinet front perpendicular to floor.
• level floor. (If...
Installation Guide - Page 5
... the lowest point on all models)
3 "-4 " (8.8 cm -10.6 cm)
3" (9.4 cm)
(532.31"cm)
(621 4c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
NOTE: Shaded areas of cabinet walls show where utility connections may be installed. May be compressed. (not used on the underside of opening...
Installation Guide - Page 6
...is not recommended. • A 90° elbow with ³⁄₄" hose connection with dishwasher.
• Power supply cord must plug into a grounded 3 prong outlet, located in conformance with...time-delay fuse or circuit breaker.
• A separate circuit.
Use of the water inlet valve.
6
Electrical Requirements
Be sure that the drain hose either be looped up and securely ...
Installation Guide - Page 7
...
1 Disconnect power
Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher.
2
3 Do you use? No -Follow instructions in the "Prepare Cabinet
Opening-Existing ... Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. Failure to the "Install Drain Hose" section. Prepare Cabinet Opening-New Utilities
...
Installation Guide - Page 8
... and cabinet opening from power supply through the left side of copper tubing or flexible braided water supply line. Tape cable to the dishwasher should have a manual shutoff valve.
Drill hole
Optional location
PPrreferrreedd lolocactaitoionn
(1.9 cm)
Drill a ³⁄₄" (1.9 cm) hole in compliance with local codes and ordinances.
The water line...
Installation Guide - Page 9
...8224;® Teflon is facing upward as it to the dishwasher inlet on the front left side of particles that it does not touch the dishwasher base, frame or motor.
6 Add 90° elbow...turn water shutoff valve to get rid of the dishwasher.
4 Flush water supply line
Ferrule
Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm) onto copper tubing. Turn shutoff valve to elbow using ...
Installation Guide - Page 10
...be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will prohibit it from the floor.
2
2. no air gap
SLcarregwe-tsyilpveer drainchlaomsep clamp Waste tee
Drain ... gap • Option B, No waste disposer - Connect black end of of drain hose to disposer inlet with air gap • Option D, No waste disposer - Use pliers to squeeze clamp open and ...
Installation Guide - Page 11
...Use pliers to 5 cm) screw-type clamp (not provided).
5. Attach drain hose to disposer inlet.
Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from... to connect from waste tee to move into disposer.
2. If the drain hose was cut , use dishwasher until completely installed. If the drain hose
was cut , use a 1¹⁄₂" to 2" ...
Installation Guide - Page 18
... the tensioner to a higher-numbered hole and replace the screw. Increase spring tension
When door is unlatched, if door opens by itself , move dishwasher close door
Water line
Drain hose
Cable
Direct ... few times. Helpful Tip: Temporarily tape utilities to the floor in the front leg of dishwasher should be put into the cabinet opening.
2 Check water and drain
hose position
Check that ...
Installation Guide - Page 19
... legs if needed , adjust leveling leg until the coupling is not level, adjust front legs up to the valve and hand tighten to seal the rubber gasket. Check that dishwasher is plumb. Hand tighten until dishwasher is level from side-to adjust front legs. Using pliers, check the tightness of the coupling. NOTE...
Installation Guide - Page 23
... FAQ tab.
Make sure the vinyl pad is properly centered, replace plastic buttons.
7 Remove towel and replace
lower dishwasher rack
Bottom Sound Pad Installation (on some models)
1.
When dishwasher is tucked up behind the door and the dishwasher front legs, as it out of the dishwasher, making sure not to push or pull any wires or...
Installation Guide - Page 25
... per load, but use less water and energy, so they depend on the water sheeting action of the dishwasher tub. Your new dishwasher will flash until you must make sure the door is used, replace inlet hose after 5 years to possibly avoid the cost of a service call 1-800-422-1230, or in the bottom...
Use & Care Guide - Page 4
... revolution. Upper level wash
Water feed tube Model and serial number label Water inlet opening
Heating element Rinse aid dispenser reduces spotting and improves drying.
Food disposer-...powerful jets target water toward pots, pans, or casserole dishes loaded in the back of the dishwasher to clean stubborn messes.
Lower spray arm
Overfill protection float
Food disposer-based wash system has ...
Use & Care Guide - Page 7
...■ Run hot water at
"Full."
Add Rinse Aid
■ Your dishwasher is located on the package when using your dishes and dishwasher interior will have hard water or notice rings or spots, try a higher ...and lift off the option, or select a different option.
Replace the dispenser cap and
turn off .
IMPORTANT: If anyone opens the door (such as spots or streaks...
Use & Care Guide - Page 14
... while the dishwasher is draining. ■ Normal water valve hissing may ...replacing the rinse aid dispenser cap after filling (or refilling) the rinse aid. ■ Using an excessive amount of the cycle. ■ Improper installation will blink one time with water. (See "BLINKING LIGHTS" in between blinks.
See "Will Not Fill" in the dishwasher. Scrape food from the disposer inlet...
Use & Care Guide - Page 16
..., installation not in accordance
with electrical or plumbing codes, or use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing.
3. Pickup and delivery. This..., first see the "Troubleshooting" section of the Use & Care Guide. KITCHENAID® DISHWASHER WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance ...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Display shows F20 or FH - Front-load washer
...the hot and cold water faucets are screens. Remove any accumulated film or particles from the inlet valves in the back of water. My front-load washer display shows F20 or ... your model number in my washer? Are you using flood-preventing inlet hoses that will begin to pause or cancel the cycle for a replacement set. the washer will not properly operate with only one of... -
Washer will not start - Front-load washer
Are the water inlet valve screens on the water. Has a cycle been selected, but may not start. Are both the hot and cold water faucets turned... if the hot and cold water faucets are with four bolts, which are designed to see if a fuse has blown and replace it, if necessary. Allow the cycle to occur, call an electrician. This will not start a new cycle. If the door is... -
Water supply hookup - Bottom freezer/French door refrigerators
...Read all directions before starting installation. If you begin. To connect a refrigerator to the valve inlet using the water supply line, if possible. Add aprox. 7' (2.1 m) to allow for... inlet valve of service loop. 1. Replace the filter if necessary. Remove plastic cap from the water valve inlet port. Non water-filter models To connect to a water source or replacing ...
Similar Questions
My Kitchen Aid Dishwasher Kuds30ixss Wont Work
(Posted by hoastuar 10 years ago)
How To Replace Fuse In Kitchenaid Dishwasher Kuds30ixss 1
(Posted by saugadoofus 10 years ago)
Kitchenaid Dishwasher Kuds30ixss Will Not Stop Beeping
(Posted by youjasl 10 years ago)
My Kitchenaid Dishwasher Kuds30ixss Does Not Complete The Cycles.
My Kitchenaid dishwasher KUDS30IXSS starts the cycle but stops after the prewash drains properly but...
My Kitchenaid dishwasher KUDS30IXSS starts the cycle but stops after the prewash drains properly but...
(Posted by sdecorte5 11 years ago)
I Need A Replacement Part For This Dishwasher. Where Can I Get It?
(Posted by Anonymous-54283 12 years ago)