What Is The Cause Of Error Code C3825 And How To Solve It

Error code C3825 is a common error that can occur on a Canon printer. This error code typically indicates that there's a problem with the drum unit, which is responsible for transferring toner to the paper. Here are the steps you can take to try to resolve this issue:

1. Reset the printer: Turn off the printer and unplug it from the power source for at least five minutes. Then plug it back in and turn it on. This will often clear up any temporary issues that were causing the error.
2. Replace the drum unit: If the error persists, you may need to replace the drum unit. You can order a replacement drum unit for your specific Canon printer model. Follow the instructions provided with the new drum unit to replace it in the printer.
3. Check the toner cartridges: If the drum unit is not the issue, the problem may be with the toner cartridges. Check to make sure that the toner cartridges are properly installed and that they are not empty. If a toner cartridge is empty, replace it with a new one.
4. Clean the printer: If the error still persists, you can try cleaning the printer to remove any built-up toner or debris. Use a soft, lint-free cloth to wipe down the inside of the printer and the drum unit. Avoid using any liquids, as they can damage the printer.
5. Contact support: If none of the above steps resolves the error, you can contact Canon support for further assistance. They may be able to provide additional troubleshooting steps or arrange for a repair or replacement if necessary.

I hope this helps you to resolve the C3825 error code on your Canon printer

Code: C3825

Description:

Fusing abnormally low temperature detection (Main of the heating roller)

The heating roller temperature sensor (TEMS) continues to detect a temperature lower than a predetermined one for a predetermined period of time.

Remedy:

1 Check the fusing unit for correct installation (whether it is secured in position). 2 Check the open/close operation of the upper right door. 3 Check the fusing unit and PRCB for proper connection and correct or change as necessary. 4 Replace the fusing unit. 5 PRCB ICP15 conduction check. 6 Replace PRCB.

---

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!