LiftMaster RSW12V Support Question
LiftMaster RSW12V Support Question
Find answers below for this question about LiftMaster RSW12V.Need a LiftMaster RSW12V manual? We have 6 online manuals for this item!
Question posted by wpxia on August 6th, 2022
The Gate Remains Open At Outage
while gate is open at power outage, our dog is going to run out
Current Answers
Answer #1: Posted by Odin on August 6th, 2022 10:44 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
Possible solutions:
- Verify that the Timer-to-Close is ON and adjusted to desired delay.
- Gate opened by a force obstruction reversal. Check the Diagnostic LED and clear gate path of any obstructions.
- The Interrupt loop or Shadow loop is obstructed (optional accessories).
- Obstructed close photoelectric sensor or edge (optional accessory). Check connections and operations of safety devices.
- Low battery. Measure the voltage across the battery. Voltage should be above 11.5Vdc. Replace battery if necessary.
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/liftmaster.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by SonuKumar on August 6th, 2022 10:25 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,653,150
Member since:
May 9th, 2021 Points: 16,653,150
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related LiftMaster RSW12V Manual Pages
RSL12V User Manual - Page 2
MODEL RSW12V SWING GATE OPERATOR Model RSW12V has a reset button.
To resume normal function press the reset switch to the NORMAL OPERATION position.
The next command given by a remote control will close the gate(s) manually, press the reset switch to the RESET/DISCONNECT position. OPEN Think LiftMaster for years of safe and reliable service. To open and...
RSL12V User Manual - Page 3
... alarm will sound (up to 5 minutes) and the operator will need to be reset.
During the open the gate.
When the gate is in the closed position, activation of the remote control will close the gate. The gate does not meet specifications.
When the inherent force of the remote control button will not be toggled...
RSL12V User Manual - Page 5
...satisfy your authorized LiftMaster dealer for details.
3-BUTTON SECURITY✚® REMOTE CONTROL
OPEN
The 3-button remote control can be programmed to control the operator.
Model 370LM
... KEYLESS ENTRY
Enables homeowner to 4-button, visor or key chain. Single-button to operate gate operator from outside by entering a 4-digit code on a specially designed keypad. Includes key...
RSL12V User Manual - Page 6
...RECEIVER Access control receiver for optimal heater location) and G6518CSW (Swing replacement heater only)
LOOP DETECTOR Low power loop detectors. Models HTRKITRSL (for Slide operator, includes bracket for optimal 7AH battery location) and G6518SL... not included. Model MPEL for dual gate applications. Model MSWIRE12GA6C
OPEN CLOSE
OPEN CLOSE
OPEN CLOSE
MOUNTING STAND For Model RSL Slide.
RSL12V User Manual - Page 7
...)
Model A12330SGLPK (33 AMP-Hour Battery, 12 Vdc, harness included.
Model MG1300
OPEN
CLOSE
RELAY KIT
OPEN
Maglock release relay. Model K94-35225
SOLENOID GATE LOCK (LOW POWER)
The automatic gate lock is a solenoid-driven lock that automatically unlocks when the gate is open the gate. Not for solar applications and extended battery backup)
BATTERY HARNESS Required when...
RSL12V Wiring Diagram Manual - Page 1
...garage.
• When the transformer ispluggedinto the convenience outlet, use !Master Elite armories to ensure minimalcurrent drawandmaximum cycles. Always use the 13.5V output terminals. CTRL PWR
s
Open... protection against fire and electrocution: • DISCONNECT power and battery BEFORE installing or servicing operator. To Reset Connector
Gate 2 (Secondary)
0
RPM Sensor
IIII
NC NO...
RSL12V Wiring Diagram Manual - Page 2
... Lock (Optional)
Coaxial Cable
Antenna
0 Maglock w/External Power Supply (Optional)
Block
L
Red
Gate 1 (Primary)
RPM Sensor Motor
NC NO COM
Gate 2 (Secondary)
NC
NO
0
COM
Dual Gate Wiring Kit RPM Sensor
NOTE:Al connections are disconnected from the116 connector andconnected to the secondoperator. SWING RSW12V & RSW12VH
&WARNING
To protect against fire: • Replace ONLY...
RSW12V Install Manual - Page 2
... Model Classifications Safety Installation Information Gate Construction Information Required Safety Protection Devices ...and Compact Installation
WIRING
Earth Ground Rod Power Wiring Connect Batteries Primary/Secondary Operators
...Alternate Radio Receiver Installation
5
6-7 ADDITIONAL FEATURES
8 Timer-To-Close Auto Open Jumper 8 Heater 8 Party Mode 8 Entrapment Protection Devices
9-14
9 9...
RSW12V Install Manual - Page 3
... or configured to protect against entrapments in a home of one of motorized gate systems.
2
SAFETY » UL325 MODEL CLASSIFICATIONS
CLASS I CLASS II
Swing Gate Operator
Primary Type
Secondary Type
A
B1 or B2
In order to four single family dwellings, or a garage or parking area associated therewith. UL325 ENTRAPMENT PROTECTION REQUIREMENTS This chart illustrates...
RSW12V Install Manual - Page 4
... designed, installed or maintained systems can create high levels of the adjacent fence that transmits radio frequency (RF) signals to mechanical damage. All openings of a horizontal slide gate are comprised of the reset control shall not cause the operator to prevent unauthorized use conditions. Outdoor or easily accessible controls shall have a security...
RSW12V Install Manual - Page 5
... grade. shall be guarded or covered.
1.5 An existing gate latch shall be disabled when a manually operated gate is in the open position or the fully closed position, shall not exceed ...swing gate when in accordance with a powered gate operator.
1.6 A gate latch shall not be installed on an automatically operated gate.
1.7 Protrusions shall not be permitted on any gate, refer to
4.
gate,...
RSW12V Install Manual - Page 6
...SENSORS Use photoelectric sensor model 50-220.
Suggested for open and close gate cycles.
• Locate entrapment protection devices to protect between moving gate.
• Locate entrapment protection devices to protect against any entrapment or safety conditions encountered in BOTH the open cycle
InsideInLSsoaiofdepetyProperty
5
Install photoelectric sensors and edge sensors to...
RSW12V Install Manual - Page 7
...install ANY wiring or attempt to run in BOTH the open and close gate cycles.
• Locate entrapment protection devices to protect between moving part of the gate.
• Install Warning signs...control station installation.
• ALL power wiring should be performed until disconnecting the electrical power and locking-out the power via the operator power switch. Non-contact sensors such ...
RSW12V Install Manual - Page 8
... service person make repairs to gate hardware.
• ALL maintenance MUST be performed by a LiftMaster professional.
• Activate gate or door ONLY when it can increase ...power at that time the unit may come near the operator MUST NOT be properly grounded and connected in BOTH the open and close gate cycles.
• Locate entrapment protection devices to protect between moving gate...
RSW12V Install Manual - Page 10
... hit an obstruction when the gate is an example of a compact installation. CenLteorop EntraDpamnegnetr
Inside
LSoaofepty Inside
Property
9 INSTALLATION » SITE PREPARATION + TYPES OF INSTALLATIONS
SITE PREPARATION BEFORE installing the operator, be different.
OutsideOuPtrsoipdeeLrtSoyaofpety
COMPACT INSTALLATION
The illustration is in the open position follow the directions for...
RSW12V Install Manual - Page 18
... YL BL RD
ACCESSORY POWER
12 V
BR GR WH YL BL RD GATE 2
7
ON
OFF
LOCK /
BIPART DELAY
6
Battery from secondary operator Battery from the GATE 1 connector on the control board.
7 If one gate is overlapping the other , set the LOCK/BIPART DELAY switch to be the primary operator (GATE 1). The gate that opens first MUST be...
RSW12V Install Manual - Page 26
..., depending on the control board prior to the TTC expiring will close the gate
when a command is factory set to automatically close the gate and return the operator to remain open, open the gate fully, then press the reset button. The heater must be powered by any signals from a remote control or the SINGLE BUTTON control.
Refer...
RSW12V Install Manual - Page 27
...CLOSE EDGE: Will detect an obstruction while the gate is closing ,
the gate will remain in dual gate applications, when more than one OPEN PHOTO is opening .
Safety Non-Contact Sensor
Safety Danger
26 ...the fully open and close gate cycles.
• Locate entrapment protection devices to protect in BOTH the open position. If a photoelectric sensor is not working or loses power or the...
RSW12V Install Manual - Page 35
... case of time. Model Q400MAU
34 Model K94-35225
SOLENOID GATE LOCK (LOW POWER) The automatic gate lock is a solenoid-driven lock that automatically unlocks when the gate is open the gate. Can be powered separately. Must be released in the ground and can be mounted onto a gate or post. Model MG1300
RELAY KIT Maglock release relay. Model...
RSW12V Quick Start Guide Manual - Page 2
... BUTTON to open and close the gate.
2 If the gate stops or reverses before reaching the fully open and close the gate. The ground wire must fit into the slot). B POWER WIRING OPTIONS ...its integrity, replace it with fuse of being powered by turning the force control slightly.
3 Run operator through a complete cycle. b EXTERNAL RECEPTACLE
1 Run low voltage wire between the transformer and the...
Similar Questions
How To Program New Car To Open Garage Door
where is the learn button to program my car to open garage door
where is the learn button to program my car to open garage door
(Posted by lrothberg 6 years ago)
Rsw12v Elite Series Will Not Open From Cabled Keypad Light Immediately Goes Red
RSW12V Elite Series will not open from cabled keypad light immediately goes red tried to put in new ...
RSW12V Elite Series will not open from cabled keypad light immediately goes red tried to put in new ...
(Posted by gpbyron 7 years ago)
Gates Remain Open
Gates will not close on command. "Strike Open" LED is lit and "Timer" and "Command Processed" LEDs a...
Gates will not close on command. "Strike Open" LED is lit and "Timer" and "Command Processed" LEDs a...
(Posted by eb1aa 8 years ago)
Installing Gates And Only One Will Open. Using Solar.
Installing liftmaster RSW12v & RSW12vh dual gates. Usisng solar and batteries are charged. Only ...
Installing liftmaster RSW12v & RSW12vh dual gates. Usisng solar and batteries are charged. Only ...
(Posted by ginaboneso 11 years ago)
Working Intermittantly, Beep For 5 Minutes Then Beep By Command.
I had my installer connect my opener to my gate. It worked fine for him apparently, and worked for m...
I had my installer connect my opener to my gate. It worked fine for him apparently, and worked for m...
(Posted by wellsmarka 11 years ago)