Question posted by rodneycotton22 on August 29th, 2023
Gate Won't Close Back.
Current Answers
Answer #1: Posted by INIMITABLE on August 29th, 2023 11:49 AM
- If any red LEDs are on, check the corresponding input. An installed accessory may be wired incorrectly or malfunctioning. Remove the accessory and test the operator.
- If the soft open or interrupt (safety) loop LED is on, make sure factory plug-in loop detectors are working properly and appropriate loops are installed on the loop input terminals
If the problem persists, or if you require further explanation, you'll have to consult LiftMaster/Chamberlain. Use the contact information here--https://www.contacthelp.com/chamberlain/customer-s....
See https://www.manualslib.com/manual/609825/Chamberlain-Sl595.html?page=27#manual [fifth-listed FAULT].
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Answer #2: Posted by SonuKumar on August 29th, 2023 10:19 PM
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Similar Questions
gate has a code of three flashes . Replaced hall effects . Still gate opens but will not close .
When I open gate and drive over exit loop to enter gate will not closewith gate open when I drive ov...
Outer gate will not close, Power light on solid. Timer & Command Processed lights flashing, Gate...