Maytag MAH2400AWW Support Question
Maytag MAH2400AWW Support Question
Find answers below for this question about Maytag MAH2400AWW - 2.4 cu. Ft. Compact Front Load Washer.Need a Maytag MAH2400AWW manual? We have 3 online manuals for this item!
Question posted by fenwick on November 26th, 2011
Washer Not Starting.
This unit, SN 14041657JT Will not start, From Idle (no lights), I select run options, press start and unit attempts to fil (solenoid engages), and immediately stops. It takes approximately 1 minute for it to reset and appear to be ready to select run options again. No problems appear during diagnostics. Bad valves? Bad Motor?
Current Answers
Related Maytag MAH2400AWW Manual Pages
Owners Manual - Page 1
...
Table of Contents
Important Safety Instructions 1-2
Operating Instructions 3
Load the Clothes Washer Start the Washer Water Use
Using the Controls 4-6
Turn the Washer On Select the Cycle Select Wash/Rinse Temperature Select Spin Speed Select Soil Level Select Cycle Options Changing a Cycle Canceling a Cycle Cycle Indicator Lights
Features 7-8
Automatic Dispenser Detergent Compartment Bleach...
Owners Manual - Page 2
...be necessary to make changes to the appliance without revising this guide. Always contact your washer, follow basic safety precautions, including the following:
1.
Hazards or unsafe practices which ...plug the appliance cord into a receptacle which is not grounded adequately and in the clothes washer until all instructions before using the appliance.
2. Any material on a floor that may ...
Owners Manual - Page 3
... of the clothes washer.
18. Hazardous fumes can stick to fabrics washed in following loads and cause skin ...near children.
10. Unplug power supply cord before attempting to service your clothes washer.
8. Do not tamper with vegetable or cooking oil...replace them .
13. Check the hoses periodically for several minutes. Store laundry aids and other material in the same wash. Do not use an...
Owners Manual - Page 4
... light will go out, add the item, close the door and press Start/Pause. To add a forgotten item, see Load The Clothes Washer section. • When the washer is restarted after the cycle has started to add the items.
Start the Washer
1. The washer will vary depending on water pressure.
3
Press any water remaining in the washer from the manufacturer's test run without a load...
Owners Manual - Page 5
... • To minimize wrinkling of loads, select the Wrinkle Control cycle.
4 The indicator light by the cycle name will illuminate.
• Rinse & Spin - To drain water from tub without starting the washer, the power automatically turns off . Using the Controls Controlst aa glance
STEP 1 Dryer Exhaust tips
Turn the Washer On
Press any pad or turn the...
Owners Manual - Page 6
... dissolve well or clean well. STEP 5
Select Soil Level
Press the Soil Level pad to select the appropriate spin speed for the load. Use for cleaning lightly soiled loads.
5
most loads. STEP 4
Select Spin Speed
Press the Spin pad to select the appropriate soil level for the load. The other rinses will illuminate. Brightly colored, lightly soiled items
Cold/Cold - Use for...
Owners Manual - Page 7
...on, start the washer, press the Start/Pause Pad. The Child Lock light will start counting down.
4. The delay time will illuminate.
3. Turn the Cycle selector dial to the desired cycle. 3. Using the Controls Controlst aa glance
STEP 6 Dryer Exhaust tips
Select Cycle Options
Press the pads to select onNeotoesr more thoroughly remove laundry additives and perfumes.
Press the Start/Pause...
Owners Manual - Page 8
...cleaning results, use :
1. The Automatic Dispenser MUST ALWAYS be in your localCowntartoelrstuaatilgitlyanocreState University Extension office in place before starting the washer.
2. Pour the recommended amount of laundry detergent directly into the compartment. All laundry additives are added to use high efficiency (HE) detergeCnytcsle. DETERGENT
SOFTENER
BLEACH
To use a high...
Owners Manual - Page 9
..., use color-safe non-chlorine bleach, add it reaches the wash load. The dispenser automatically dilutes liquid chlorine bleach before it to the detergent compartment. Fabric softener should be diluted with
this washer. Avoid splWahsahtincagn o&r coavnenero-tfiblling the compartmwaeshnetd.
3. Bleach Softener
M A X M A X
Fabric Softener Compartment 1. The dispenser automatically releases...
Owners Manual - Page 10
...washer should be removed, if needed. To clean and freshen the washer interior:
Controlst aa glance
1. Dryer Exhaust tips
2. We recommend taking the following as recommended:
Control Panel - Do not spray cleaners directly on the washer... unpleasant odor and/or permanent stains on the panel. Run the washer through your washer interior. Leave the door open to
any dirt, soil, odor,...
Owners Manual - Page 11
... all of your washer during extreme cold temperatures,
call 1-800-688-2080. Press the release lever on long-term storage or storage of the parts under running water. 4.
loading
DETERGENT
SOFTENER BLEACH ...800-688-2002 Canada. Run the washer through the cycle without any water left over in the
washer. customers using TTY for storage as follows:
• Select the Quick Wash cycle and...
Owners Manual - Page 12
... . Code Symbol
Controlst aa glance
Meaning
Solution
Unbalanced loadDrpyerrevEexhnatuesdt tthieps
Redistribute the load, press Start/Pause.
The door will not unlock. Make sure the door is not ... running .
er
washer from spinning. The washer failed to unlock. The washer has tried to fill but was unsuccessful. Make sure the water faucets are open when washeNorteiss running ...
Owners Manual - Page 13
... other object.
• Make sure the laundry load is not activated, see page 6. Continued...
12 Stops
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close door and push the Start/Pause pad to press the Start/Pause pad.
Contr•olMst aaakeglsanucree the washer is plugged in the inner parts...
Owners Manual - Page 14
...take a few moments for the door lock mechanism to deliver a minimum 120°F (49°C) DryehroEtxwhaaustetrtaitpsthe tap. If there is firmly closed. • Make sure hose connections are selected. U.S. customers using TTY for service. • Close the door and press the Start/Pause pad. It should be plugged.
• As the washer... loads (one or two items) may change as the washer ...
Owners Manual - Page 15
... before draining out of the machine.
14 Rapid snapping and/or popping sound from the rear of the washer during spin.
• Before the washer starts to fill, it sounds like an out-of-balance load.
• The tumbler will begin to accelerate to speed, then slows back down dramatically when it will occur...
Installation Instructions - Page 2
... for installation: Cable tie to secure drain hose to standpipe, inlet hose or laundry tub
ELECTRICAL
Refer to floor is 33 1\4" this includes the leveling leg screwed all the way in. Depth -
READ THIS BEFORE YOU START... CABINET DIMENSIONS
WASHER DIMENSIONS
A.
Tools needed for installation:
• Multi wrench • Utility knife • Channel...
Installation Instructions - Page 3
...
grounding must be done in doubt as to back of the washer.
3 is equipped with the cabinet ground screw and washer. Water pressure less than 4 feet from the back of unit with a power cord. NOTE: Accessory inlet hoses are in accordance with the washer. BASIC LOCATION REQUIREMENTS:
ELECTRICAL
• 120 Volt 60 Hz 15...
Installation Instructions - Page 4
...must be large enough to the standpipe. The drain hose is acceptable. Never install the washer on a solidly constructed floor.
ALCOVE OR CLOSET INSTALLATION
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE ...load situations.
LOCATION CONSIDERATIONS
It is 18".
To Avoid The Possibility Of Water Damage:
• Have Water Faucets Easily Accessible • Turn Off Faucets When Washer...
Installation Instructions - Page 5
...damaged during shipping or you have all of the washer. Proper installation is the responsibility of the items, contact your washer requires replacement parts or accessories, contact Maytag Customer...FOR TECHNICAL ASSISTANCE, REPLACEMENT PARTS AND ACCESSORIES For technical assistance or if your Maytag dealer immediately.
5 This model is not designed for shipping damage and have you do not ...
Installation Instructions - Page 6
... 1
PREPARE WASHER
Removing The Shipping Bolts
Before using the washing machine, you install the washing machine, select a location with spacer through the hole in the rear wall of the washer. Fill the... from sources of the unit.
1.
Remove The Door From All Discarded Appliances To Avoid The Danger Of A Child Suffocating. STEP 2
INSTALLING THE WASHING MACHINE
Selecting a location
Before you ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Recall Information
... recall. The U.S. Consumers should immediately stop using the recalled dishwashers, disconnect the electric supply by homebuilders nationwide from a fire. United States *Registered trademark/ ™ Hazard: An electrical failure in : United States Remedy: Consumers should stop using products immediately unless otherwise instructed. Serial numbers will start or end with OR... -
Sounds during drain - Top-load washer
...;portion of the cycle usually lasts 3-5 minutes. Leaking water - What are the gears engaging prior to the start of spin. This is normal. Top-load washer Sound after drain and before spin. (6... normal. During drain, the washer pump will run continuously to remove the water released from the load. Due to this continuous running, the pump will remove most of the... -
Vibration - Front-load washer
... the start of a spin cycle. (16 seconds, 260 KB) Play the sound of the washer as the final spin ends. (18 seconds, 286 KB) Please take a short survey regarding the quality of the cycle is not on how to remove all four washer feet need to a standard top-load washer. When the washer...
Similar Questions
Maytag Washer, Mah2400aww 45 Second Timer.
Have a Maytag MAH2400AWW top loading washer and had the all too ofter problem with coins obstructing...
Have a Maytag MAH2400AWW top loading washer and had the all too ofter problem with coins obstructing...
(Posted by kkdman2 10 years ago)
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
(Posted by hhppjj 10 years ago)
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer.
The washer makes extremely loud noise during spinning. Do you know what's going on?
The washer makes extremely loud noise during spinning. Do you know what's going on?
(Posted by hhppjj 10 years ago)
Maytag Washer Mah2400aww
this washer starts vibrate like crazy with a load it look like nothing is preventing it from shaking...
this washer starts vibrate like crazy with a load it look like nothing is preventing it from shaking...
(Posted by cleveru 11 years ago)