Maytag MVWC200XW Support Question
Maytag MVWC200XW Support Question
Find answers below for this question about Maytag MVWC200XW.Need a Maytag MVWC200XW manual? We have 3 online manuals for this item!
Question posted by mcconpajkaj on June 14th, 2014
What Is Water Level Set On Mvwc200xw Washer For Large Load?
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Maytag MVWC200XW Manual Pages
Installation Instructions - Page 2
...washers
To order, please refer to improve performance and minimize noise and possible "washer walk". Tools needed:
Parts needed: (Not supplied with washer)
Adjustable or open end wrench 9/16" (14 mm)
4" min (102 mm)
Level...Select proper location for installation are in cardboard insert in the top of your washer in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (...
Installation Instructions - Page 3
... valves on back of washer. If you must be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Consider allowing more than 96" (2.44 m) from bottom of washer. If a closet door or louvered door is installed, top and bottom air openings in low temperatures.
You will need:
n A water heater set to reduce noise...
Installation Instructions - Page 4
... and ordinances. If a mating outlet is not available, it is adequate. Set washer upright. Tip washer back and place on floor behind washer. n Do not have the properly grounded outlet installed by a qualified electrician.... base. n Do not ground to a gas pipe. NOTE: To avoid floor damage, set washer onto cardboard before moving it and make sure lid is necessary for proper operation and to...
Installation Instructions - Page 5
... plug and pull to back of washer.
4.5" (113 mm)
Place hose into standpipe or lay on elbow end of drain hose, slide it over side of laundry tub. Free power cord
If clamp...cord over console to allow free access to free from tub. NOTE: Keep tray in place on bottom of laundry tub. Drain hose form must be inside standpipe; For a floor drain, remove the preinstalled drain hose form as...
Installation Instructions - Page 6
... must be connected to inlet valves. Use pliers to check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to faucets or washer. Use pliers to washer correctly. Repeat with a red ring. A small amount of water may need to remove the drain hose form from the end of the drain hose. Repeat...
Installation Instructions - Page 7
...
Laundry Tub
Standpipe
Wall
14. Check levelness of washer.
Rock washer back and forth to prop up front of washer about 1/2" (13 mm) from the washer cabinet.
Adjust leveling feet
Jam nut
Secure drain hose to raise the washer. Tighten leveling feet
Jam nut
With washer in its final location, place a level on top edges of washer
Place level here
Place level here
If washer...
Installation Instructions - Page 8
... all of /recycle all parts are on washer. If there is plugged into a grounded 3 prong outlet
Complete Installation CHECKLIST
q Check electrical requirements. q Check that yellow shipping materials were completely
removed from console and any cycle.
q To test and clean your Washer User Instructions. q Check that water faucets are now installed. Plug into a grounded...
Owners Manual - Page 3
... correct time in a cold and cool water wash, some warm water may vary.
1 WATER LEVEL Select the setting most suitable for detailed descriptions of water for load balance. Appearance may be cooler than what your load. You may take several minutes to spin and spray in the cycle. NOTE: If the washer is spinning, it may hear the motor...
Owners Manual - Page 4
...may take several minutes if the load was spinning at increasing speeds for proper water removal, based on the care...speed spin for lightly soiled mixed loads.
To allow for heavily soiled cottons or mixed fabric loads. Large items such as sport shirts, ...items. This cycle uses spray rinses only. Items to drain washer after cancelling a cycle or completing a cycle after power interruption...
Owners Manual - Page 5
...using an Oxi or color-safe bleach laundry boost product, add to the bottom of detergent to use.
5 Loose change, buttons, or any small object can set stains into the bottom of detergent into ...to avoid further damage to determine the amount of the washer basket, as well. Helpful Tips:
• When washing water-proof or water-resistant items, load evenly.
• Use mesh garment bags to help...
Owners Manual - Page 6
... at correct time in loose heaps evenly around basket wall. Do not wrap large items such as sheets around the sides of the rim. Lift the lid and...Load laundry into dispenser; MAX FILL
Dilute liquid fabric softener by filling the dispenser with liquid chlorine bleach. Try mixing different sized items to start the washer.
load them in the same cycle with warm water until the washer...
Owners Manual - Page 7
... temperature by turning the Temperature knob to the appropriate setting based on some models)
Select the Water Level setting most amount of metal hooks, zippers, and snaps. If your load. When the cycle has finished, the DONE indicator will unlock once the washer movement has stopped. Select WATER LEVEL
9.
Then close lid and press START/ Pause/Unlock again...
Owners Manual - Page 8
... power.
IMPORTANT: Do not add detergent. Do not use abrasive products.
8 Select Heavy Duty Regular cycle, hot Temperature, and large Water Level.
5. Press START/Pause/Unlock. Water will pour into washer for 3 seconds to the washer or clothing, do not interrupt cycle.
NOTE: For best results, do not wash clothes with thumbs.
2. Press and hold the...
Owners Manual - Page 9
... towels into a pan or bucket. Disconnect drain hose from back of detergent for a medium-size load.
9 Run washer through the following recommended procedure:
To use , vacation, winter storage, or moving .
3. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again:
1. Flush water pipes and hoses. Close lid and place tape over edge and into...
Owners Manual - Page 10
... or sagging. Both hoses must be out of alignment and cause water to splash off basket if washer is not level. http://www.maytag.com/help - Load dry items in washer drain system.
Avoid washing single items.
Use Normal Regular cycle and Super Plus or Large load size for oversized, non-absorbent items such as coins could...
Owners Manual - Page 11
... 2 additional items after cycle has started to possibly avoid the cost of the spins. Load may not allow the washer to allow even distribution of cycle. Lower drain hose if the end is power to pump out water within 10 minutes
Empty pockets and use an extension cord.
Solution
Plug power cord into...
Owners Manual - Page 12
...
High speed spins extract more moisture than your load with the best cycle.
Washer not loaded as expected (cont.)
Dry spots on .
Use cycle designed for proper water supply.
Choose a load size (water level) that matches the load being washed.
12 See "Using Your Washer" section. Reduce tangling by mixing types of load items. Use the recommended cycle for proper...
Owners Manual - Page 13
...fabric softener. Use a higher soil level cycle option and warmer wash temperature to avoid chlorine bleach and fabric softener staining.
Not washing like colors together and remove promptly after washer is complete. Incorrect dispenser operation
Clogged dispenser.
added incorrectly.
The washer may take several minutes if washing large loads or heavy fabrics.
13 In Canada...
Owners Manual - Page 14
MAYTAG® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is... also may have other rights that vary from unauthorized modifications made to repair or replace appliance light bulbs, air filters or water filters. Service calls to the appliance.
8. Pick up and delivery. Replacement parts or repair labor on the duration of implied...
Energy Guide - Page 1
...(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$50 ▼
$10
$71
Cost Range of ...$29
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility rates and use....capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer is not cleaning laundry - Top-load HE washer with Dispensers in Corners
... motion. See Max-fill-line arrows on clothes. See also: Why HE High Efficiency detergent is not cleaning laundry. Top-load HE washer with this washer should move easily for temperature recommendations. The water level on this washer. Separate dark load items from my washer - The following illustrates how your Bravos How the dispensers work differently than the... -
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
... timer is lined up to be space for the proper water level: Without any accumulated film or particles from the washer. For best results, determine load size with agitator. Load-sensing Energy Star top-load washer with dry items only. This is not completely submerged in the washer, select the Rapid Wash cycle. The following illustrates how... -
Detergent is on the load - Top-load washer
... option, turn the knob to the new setting. If you have very soft water or a very lightly soiled load, you add detergent on the load - Older laundry detergent does not dissolve well in the dispenser Make sure the water level selected matches the load size. Try selecting a higher water level setting. Detergent remains in the washer, especially powdered detergent. Use liquid detergent...
Similar Questions
Cold Water Will Not Enter Washer. Valve Open And Working. Switch Set To Cold
(Posted by modane7521 9 years ago)
How To Change Setting For Water Levels In Maytag Washer Top Load Mvwb850wq1
(Posted by bobcalonl 9 years ago)
Maytag Mvwc200xw How Much Water In Large Load Setting
(Posted by kycamg 10 years ago)
Fabric Softener Selection And Water Level Control
if fabric softener switch is on does that override level selection?
if fabric softener switch is on does that override level selection?
(Posted by rbhouse 11 years ago)
Water Levels
Water levels are less then adequate for cleaning and rinising my clothes. I have watched several cyc...
Water levels are less then adequate for cleaning and rinising my clothes. I have watched several cyc...
(Posted by vkilby 12 years ago)