2003 Mazda Protege5 Support Question
Find answers below for this question about 2003 Mazda Protege5.Need a 2003 Mazda Protege5 manual? We have 1 online manual for this item!
Question posted by tcrailallyt on October 12th, 2013
How To Install Antenna 2003 Mazda Protege5
The person who posted this question about this Mazda automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Manual Pages
Owner's Manual - Page 2
...We assure you may find some explanations for equipment not installed on your vehicle. ©2002 Mazda Motor Corporation Printed in your full satisfaction with your ...handy reference for the safe and enjoyable use of your Mazda. If the air conditioner does not operate properly, consult an Authorized Mazda Dealer. Mazda Motor Corporation HIROSHIMA, JAPAN
Important Notes About This Manual...
Owner's Manual - Page 36
In your Mazda, tethered child-restraint systems can only be installed on the seats that a child is clearly the worst choice for ...'s instructions carefully. J39L_EA.book Page 25 Saturday, June 8, 2002 5:35 PM
Essential Safety Equipment
Child Restraint Installing Child-Restraint Systems
Accident statistics reveal that take tethers to air bags. Some child-restraint systems now come with...
Owner's Manual - Page 39
...shoulder. NEVER use a rear-facing childrestraint system in the front seat with tether anchors. If installing the child-restraint system on the front seat are particularly dangerous. To check if your vehicle...: As your vehicle has front air bags and doubly so because your Mazda front seats have side air bags: Every Mazda side air bag will have an optional side air bag, it is unavoidable...
Owner's Manual - Page 42
...LATCH Child-Restraint Systems: Not following the child-restraint system manufacturer's instructions when installing the child-restraint system is dangerous. Attaching Two Child-Restraint Systems to the ... 2002 5:35 PM
Essential Safety Equipment
Child Restraint LATCH Child-Restraint Systems
Your Mazda is installed improperly, the child-restraint system could move in a sudden stop or collision ...
Owner's Manual - Page 50
... the supplemental restraint system. An Authorized Mazda Dealer can be heard and some smoke will be released. It also includes installing extra electric equipment on body parts not...Saturday, June 8, 2002 5:35 PM
Essential Safety Equipment
SRS Air Bags
WARNING
Installation of Front-End Equipment: Installation of front-end equipment, such as frontal protection bar (kangaroo bar, bull bar...
Owner's Manual - Page 60
...button Panic button
3-3
Form No. 8Q94-EA-02G J39L_EA.book Page 3 Saturday, June 8, 2002 5:35 PM
Knowing Your Mazda
Doors and Locks
NOTE
NOTE
• The keyless entry system is designed to operate up to Maintenance (page 3-4). • ... the LOCK button and the hazard warning lights will flash once. To install a new battery, refer to about 2.5 m (8 ft) from the center of Industry Canada.
Owner's Manual - Page 61
... open or closed. J39L_EA.book Page 4 Saturday, June 8, 2002 5:35 PM
Knowing Your Mazda
Doors and Locks
Unlock button To unlock the driver's door, press the UNLOCK button and the...will flash twice.
Turning on them. NOTE
Turning off the alarm Press any door or the liftgate is installed with the same type battery (CR2025 or the equivalent). • Dispose of the battery using cellophane ...
Owner's Manual - Page 62
...Install a new battery (CR2025 or the equivalent) into the slot and gently pry open the transmitter. 3. CAUTION
Do not press any buttons when replacing the battery. The electronic code could be altered and cause the keyless entry system to operate, contact an Authorized Mazda....book Page 5 Saturday, June 8, 2002 5:35 PM
Knowing Your Mazda
Doors and Locks
Replacing the transmitter battery 1.
Owner's Manual - Page 78
... necessary. A special attachment kit is fixed in an automatic car wash, always remove the roof rack. Consult an Authorized Mazda Dealer. • The maximum load on the brakes while the roof rack installed.
Before washing the vehicle in place. Doing so may cause an accident or the luggage may loosen initially, retighten...
Owner's Manual - Page 79
... bolt at both ends of the rear cross bar, then remove the rear cross bar covers.
Install the rear cross bar cover by inserting the clips into the square hole of the rear cross ...roof rack can result in noise.
J39L_EA.book Page 22 Saturday, June 8, 2002 5:35 PM
Knowing Your Mazda
Doors and Locks
3.
Tighten the bolt at both ends of the rear cross bar until they click, then...
Owner's Manual - Page 92
... J39L_EA.book Page 9 Saturday, June 8, 2002 5:35 PM
Before Driving Your Mazda
Driving Tips
M Tire Chains
Installing the chains 1. Always follow the chain manufacturer's instructions. 3.
If tire chains are...them. 2. Retighten the chains after driving 1/2-1 km (1/4-1/2 mile). Please consult an Authorized Mazda Dealer. Use only SAE Class "S" chains, and make sure they fit.
4-9
Form ...
Owner's Manual - Page 147
... be raised and lowered by hand.
CAUTION
To prevent from damaging the antenna, retract it clockwise. Make sure the antenna is security installed.
6-10
Form No. 8Q94-EA-02G M Detachable Type
To remove the antenna, turn it before entering a car wash facility or passing beneath a low overhead clearance. NOTE
When leaving your vehicle unattended...
Owner's Manual - Page 171
...Mazda may cause undesired operation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to provide reasonable protection against harmful interference in a residential installation...: (1) This device may result in a particular installation.
6-34
Form No. 8Q94-EA-02G It ...
Owner's Manual - Page 186
...vehicle high enough so that isn't designed for your Mazda is firmly in this manual. Before removing the lug nuts, make sure your Mazda. Insert the jack handle into the jack.
WARNING...dangerous. The vehicle could slip off the jack and seriously injure someone. The jack could be installed. Jack handle
6. then remove the wheel.
7-9
Form No. 8Q94-EA-02G
The vehicle could...
Owner's Manual - Page 211
...
Loosen
2. Run the engine at MAX. At this point, wait until the system is full. 8. Install the cooling system cap. Inspect all connections for leaks.
If it is cool, remove the radiator drain... when the engine is excessively low, have the brake/clutch system inspected by an Authorized Mazda Dealer. then depress the accelerator two or three times. Inspect the level in the coolant...
Owner's Manual - Page 235
...fuses. If the same fuse blows again, avoid using that system and consult an Authorized Mazda Dealer as soon as the RADIO circuit. Open the fuse panel cover.
4.
Normal
Blown... the electrical system doesn't work , inspect the appropriate circuit protector. Otherwise you have an Authorized Mazda Dealer install it 's blown. If you may damage the electric system.
8-38
Form No. 8Q94-EA-02G...
Owner's Manual - Page 241
...nylon cloth. • Rub gently when washing or drying the vehicle. • Take your Mazda thoroughly and frequently, at a car wash that uses brushes that contain abrasives. This may discolor or ...paint. • To prevent damaging the antenna, retract it before washing. • Use plenty of the doors and rocker panels are clean.
• Mazda is washed improperly, the paint surface could...
Owner's Manual - Page 255
... have an accident or increase your vehicle's performance or safety system; Always consult an Authorized Mazda Dealer before you install any non-genuine parts or accessories, consult an Authorized Mazda Dealer. WARNING
Installation of Non-Genuine Parts or Accessories: Installation of injuries in stores.
This could affect your chances of non-genuine parts or accessories...
Owner's Manual - Page 260
...PR 038C 03 (Puerto Rico only) PUBLICATION DESCRIPTION 2003 WORKSHOP MANUAL (English) 2003 WIRING DIAGRAM (English) 2003 OWNER'S MANUAL 2003 OWNER'S MANUAL 2003 OWNER'S MANUAL
M WORKSHOP MANUAL:
Covers recommended ...Customer Information
Service Publications Service Publications
Factory-authorized Mazda service publications are available for owners who wish to the chart below...
Owner's Manual - Page 271
...Add-On Non-Genuine Parts and Accessories ...9-10 Air Bag Systems ...2-36 Air Filter ...8-19 Antenna ...6-10 Anti-Lock Brake System (ABS) ...5-7 Warning light ...5-7 Appearance Care ...8-42 Ashtray ... Cell Phones ...9-11 Center Console ...6-39 Child Restraint Child restraint precautions ...2-22 Installing child-restraint systems ...2-25 LATCH child-restraint systems ...2-31 Child Safety Locks for ...
Similar Questions
2003 Protege5 What Size Tools Are Needed For Changing Right Front Wheel Bearing
(Posted by aimacce 10 years ago)
How To Change Licence Plate Bulb 2003 Mazda Protege5
(Posted by Inspelo 10 years ago)
How To Install 2003 Manual Protege5 Shift Knobs
(Posted by katiehfoluch 10 years ago)
Rocker Panel Retainer Clip Size
I broke some rocker panel retainer clips cant find anywhere and dont know what size 2003 protege5 an...
I broke some rocker panel retainer clips cant find anywhere and dont know what size 2003 protege5 an...
(Posted by Anonymous-115975 10 years ago)