Error Code 1 And Upper Left Corner An "l" Over An Upside Down "l"

The error code "1" and the symbol "L" over an upside-down "L" displayed on an Omron device typically indicate a communication error between the device and its controller. This error can occur due to various reasons, such as:

Loose or damaged cable connections: Verify that the cables connecting the device to the controller are properly plugged in and secure. Inspect the cables for any visible damage or signs of wear.

Incorrect cable type or configuration: Ensure that you are using the correct cable type for the specific connection. Double-check the cable configuration and wiring to ensure it matches the device and controller requirements.

Communication protocol mismatch: Check if the communication protocol settings on the device and controller match. Incorrect protocol settings can prevent proper communication and lead to error codes.

Hardware malfunction: If the error persists after checking the cable connections and communication settings, there might be a hardware issue with either the device or the controller. In such cases, it's recommended to contact Omron technical support for further assistance and potential repairs or replacements.

If the error code is accompanied by other specific symptoms or messages, refer to the Omron device's user manual or contact their technical support for more detailed troubleshooting steps.

---

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!