Onkyo TX-SR500 Support Question
Onkyo TX-SR500 Support Question
Find answers below for this question about Onkyo TX-SR500.Need a Onkyo TX-SR500 manual? We have 1 online manual for this item!
Question posted by edwardep on September 24th, 2016
My Receiver Amp Speaker Setting.......when All 5 Speakers Are Set To 12 Db The A
speaker setti .......no problems with. Performance after all these. Years.except when speakers are. Set to 12db and when I have finished and put back. Into standby and to on again speakers. Go back to. Zero....thanks Edwar
Current Answers
Related Onkyo TX-SR500 Manual Pages
Instruction Manual - Page 1
... performance and listening enjoyment from your new AV Receiver. AV Receiver
TX-SR500 TX-SR500E
Instruction Manual
Contents
Before using
Important safeguards 2 Precautions 3 Features 4 Supplied accessories 4 Before using the unit 5
Facilities and connections
Index to parts and controls 6 Connecting to audio/video equipment 10 Positioning speakers/Connecting speakers .... 12 Connecting...
Instruction Manual - Page 4
... other chemical solvents or cloths since these could damage the finish or remove the panel lettering.
4. The following accessories are...
Be sure to set this unit will vary depending on the area which it was purchased.)
1 2 3
Speaker Cable
Conversion plug &#...set to local power supplies. AC Fuse
The fuse is located inside the chassis and is illegal without permission of the TX-SR500/ TX...
Instruction Manual - Page 5
... WOOFER
FRONT SPEAKERS A
FRONT SPEAKERS B
SURROUND SPEAKERS
L
L
L
R
R
R
CENTER SPEAKER
AC OUTLET
VOLTAGE SELECTOR
120 V 220-230 V
VOLTAGE SELECTOR
120 V
220-230 V
Setting the AM... compartment.
3 Attach the battery cover. Remote control sensor
Receiver
STANDBY indicator
30˚ 30˚
16 feet (5m)... the batteries.
• Make sure the audio rack doors do not have colored glass.
...
Instruction Manual - Page 6
... is selected, you pressed and stop when it tunes into one of the TX-SR500/TX-SR500E, use this is displayed in sequence. When FM is set the brightness of the mode selected using the AUDIO ADJUST, SPEAKER ADJUST or AUDIO SELECTOR button.
~ MASTER VOLUME dial [21, 24]
The MASTER VOLUME dial is used to the standby state.
Instruction Manual - Page 7
... button, the display changes.
$ AUDIO SELECTOR button [28]
Press to adjust bass, treble, late night function and cinema filter function setting.
* VIDEO 3 INPUT jacks [33]
For connecting a video camera or game device. h RDS indicator (European models only) [24]
Lights up when an FM stereo broadcast station is received. The (SPEAKERS) A/B indicators corresponding to the...
Instruction Manual - Page 9
... the AUDIO ADJUST, SPEAKER ADJUST or AUDIO SELECTOR button.
# VOLUME 5/∞ button [21, 24]
For adjusting the volume.
9 This button is provided only on this page are provided only on the TX-SR500/TX-SR500E or put it in brackets.
1 SLEEP button [27]
For setting the sleep time. This button is provided only on the remote controller.
2 STANDBY...
Instruction Manual - Page 10
...not plug in noise, poor performance, or damage to S ... sources by referring to "Setting the digital inputs" on page...
SUB WOOFER
FRONT SPEAKERS A
FRONT SPEAKERS B
SURROUND SPEAKERS
L
L
L
R
R
R
AC OUTLET
CENTER SPEAKER
DO NOT connect the...TX-SR500/SR500E in use the OPTICAL 1 input jack. When not in the standard manner. Improper connection
Inserted completely
• Do not bind audio...
Instruction Manual - Page 11
... FRONT L/R jacks on the TX-SR500/TX-SR500E, use the 2 channel audio output jacks on the DVD player.
• If the DVD player only has the 2 channel audio outputs, connect it to the FRONT L/R jacks.
• To connect the digital output from satellite tuner etc. ANTENNA
AM
FM 75
FRONT SPEAKERS A
FRONT SPEAKERS B
SURROUND SPEAKERS
AC OUTLET
L
DIGITAL...
Instruction Manual - Page 12
... of the FRONT SPEAKERS B system The FRONT SPEAKERS B system consists of identification.
Refer to this unit are colored as the label attached to the Receiver. The illustration below shows an example of a layout for ease of the front left speaker (+):
blue
Surround right speaker (+):
gray
Speaker
12 The configuration of the FRONT SPEAKERS A system The FRONT SPEAKERS A system consists...
Instruction Manual - Page 14
...IN
OUT
IN
SUBWOOFER PRE OUT
CD
TAPE
S VIDEO
IN
OUT
IN
FRONT SURR CENTER
L
L
R VIDEO 2
VIDEO 1
R DVD
SUB WOOFER
FRONT SPEAKERS A
FRONT SPEAKERS B
SURROUND SPEAKERS
L
L
L
R
R
R
CENTER SPEAKER
AC OUTLET
VOLTAGE SELECTOR
120 V 220-230 V
North American models 1 Strip away the insulation from the TX-SR500/TX-SR500E, televisions, speaker cables, and power cords.
Instruction Manual - Page 19
.../4.5
Center delay 0 1 2 3 4 5
Surround delay 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Setting the center delay Calculate the difference between (L) and (L1), find the closest value to 15 ms.
19 Press SPEAKER ADJUST repeatedly until
"CenterDelay" is (L2). Assume that the distance from the listening position to each speaker type (front, center and surround) and arrival...
Instruction Manual - Page 21
... stereo) indicator lights up according to the received sound system in this section. The initial settings are lit on the AV Receiver • Using the sleep timer
Enjoying the...SPEAKERS A/B
Input Selector buttons
Input Selector buttons VOLUME 5/∞
This section shows you how to play the sources connected to audio/video equipment" on page 10 while following the steps in the AV Receiver...
Instruction Manual - Page 23
... from the speaker levels set the AV receiver to show "MD" when the TAPE source is canceled automatically. • Regardless of the speaker configuration, the input signal will be adjusted between -12 to +12 dB. If necessary, press CH SEL on the unit or remote controller to set to 2 ch, sound comes from all speakers. Adjust the speaker output level...
Instruction Manual - Page 26
... headphones to the PHONES jack on . Note If you disconnect the headphones, the listening mode returns to the PHONES jack. When you turn on the SPEAKERS B system, the SPEAKERS A system also reproduces stereo sound automatically. (The listening mode is set to "Stereo.")
The lit (speaker) A/B indicators indicate the corresponding speaker systems are on the AV Receiver.
Instruction Manual - Page 28
...speaker, then press LEVEL 5/∞ to check each speaker's relative volume balance. Setting...problem as...Setting to play a digital signal in the speaker configuration on page 20 when the AV Receiver enters standby mode, or the main power is switched off
Note Any speaker...set... speaker and the selected speaker ...set...AUDIO SELECTOR
DVD
CH SEL
AUDIO SEL DVD
LEVEL 5/∞
Adjusting each speaker...
Instruction Manual - Page 29
... through speakers in the range between -12 dB and +12 dB.
Item
2.
Cinema sound has a vast dynamic range; When this function is set to easily hear minute sounds at larger volumes. This parameter is Dolby Digital surround. Refoer to all the sources
PRESET/ADJUST ™/£ AUDIO ADJUST
CINE FLTR LATE NIGHT
AUDIO ADJUST ADJUST 2/3
Using the AUDIO ADJUST...
Instruction Manual - Page 30
... Receiver ...TX-SR500/TX-SR500E output analog audio. See "Positioning speakers/Connecting speakers" on the player.
When playback concludes and the DTS signal transmission stops, the TX-SR500/TX...TX-SR500/TX-SR500E lights up while it simulates the acoustics in front of a TV program being compressed. Do not record CDs or LDs that provides performance...Speaker Setup configurations have been set...
Instruction Manual - Page 38
... is activated. • The AV receiver is not properly
connected. • Input selector is not set properly. • Headphones are connected.
• The input signal format is set to "PCM". • The speakers are worn out. • The remote controller is not pointed at the remote
sensor of a problem before contacting service. If not recovered...
Instruction Manual - Page 39
...speakers but not recorded.
• The sound system you are selected. Remedies • Switch the frequency receiving...front display and the TX-SR500/TX-SR500E enters the standby state.
39 This ...Multichannel audio is not output.
• Playback source is not Dolby Digital encoded.
• Input signal format is set to ... Set the input signal format to "Multich".
28
• Check that performs ...
Instruction Manual - Page 40
...
Pre out (SUBWOOFER): 1 V, 470 ohms
Frequency Response:
10 Hz to 10 kHz, +1/-3 dB (Direct mode)
Tone Control
Bass:
±12 dB at 50 Hz
Treble:
±12 dB at 20 kHz
Signal-to-Noise Ratio:
CD/TAPE: 100 dB (IHF-A, Direct mode)
Muting:
-50 dB
VIDEO SECTION
Input Sensitivity and Impedance VIDEO (DVD, VIDEO 1, 2, 3): 1 Vp-p, 75 ohms...
Similar Questions
Onkyo Av Receiver Tx-sr343 Firmware File
Where can I download the firmware file for Onkyo AV Receiver TX-SR343?
Where can I download the firmware file for Onkyo AV Receiver TX-SR343?
(Posted by kamalbul 1 year ago)
How Do I Hook Up An Onkyo Equalizer To My Onkyo Av Receiver Tx-sr600
how do I hook up my Onkyo equalizer to my Onkyo AV receiver TX-SR600
how do I hook up my Onkyo equalizer to my Onkyo AV receiver TX-SR600
(Posted by casesimmons94 3 years ago)
Remote Apps That Came W/ The Onkyo Av Receiver Tx-nr414. Manual For Same.
Need to replace the small remote apps that came w/ the ONKYO AV Receiver TX-NR414. Sons installed as...
Need to replace the small remote apps that came w/ the ONKYO AV Receiver TX-NR414. Sons installed as...
(Posted by tgwin1261 10 years ago)
Can I Connect My I Pod To Onkyo Tx Sr500 Receiver
(Posted by Anonymous-44716 12 years ago)