Pioneer GM-D9605 Support Question
Pioneer GM-D9605 Support Question
Find answers below for this question about Pioneer GM-D9605.Need a Pioneer GM-D9605 manual? We have 1 online manual for this item!
Question posted by totorron1973 on May 1st, 2022
My Amp Goes In To Protection Mode But Only For The 4 Chanels. The Bass Works Fin
The person who posted this question about this Pioneer product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #2: Posted by Odin on May 1st, 2022 5:12 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
The protection function protects the product and speaker output, and it reflects an abnormality that must be correction by a qualified technican. (Sorry.)
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #3: Posted by SonuKumar on May 1st, 2022 10:48 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,673,760
Member since:
May 9th, 2021 Points: 16,673,760
https://www.youtube.com/watch?v=k69P9O4X4jQ
https://www.reddit.com/r/CarAV/comments/awd3vh/pioneer_gmd9605_5_channel_suddenly_stuck_in_power/
https://www.pioneerelectronics.com/StaticFiles/Manuals/Car/GM-D9605_OwnersManual081815.pdf
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Pioneer GM-D9605 Manual Pages
Owner's Manual - Page 2
.../TV technician for future reference.
Note This equipment has been tested and found to comply with the instructions, may cause harmful interference to provide reasonable protection against harmful interference in this equipment does cause harmful interference to radio or television reception, which the receiver is encouraged to try to which can...
Owner's Manual - Page 3
... result. The use a fuse of the car's body. Over time, your hearing "comfort level" adapts to your hearing adapts. Before connecting/ installing the amplifier
WARNING ! The ground wire of the one...the fuse with a protrusion. Do not turn up and cause minor burns. When installing the amplifier, do not allow this by playing it there. Guard against this unit to operate properly, please...
Owner's Manual - Page 4
... car stereo while the en- CAUTION ! If the subwoofer output terminal and sub- woofer wire are short-circuited. -
Doing so may exhaust the battery. gine is applied to prevent equipment malfunction. About the protection function This product has protection function. The POWER/PROTECT indicator will turn red
and the output will turn red
and the amplifier...
Owner's Manual - Page 5
... to Connecting the car stereo on page 11.
6 POWER/PROTECT indicator The power indicator lights up , turn the controls to a lower level. For use with an RCA equipped Pioneer car stereo, with maximum output of the car stereo output. ! In case of LPF from -12 dB (shallow slope) or -24 dB (sharp slope).
9 BB-REMOTE (bass boost level...
Owner's Manual - Page 6
... illustration shows NORMAL gain setting.
6 En
Protective function included to prevent malfunction of the unit and/or speakers due to the amplifier, see the Connection diagram on page 7. ...may indicate improper setting of connecting the bass boost remote control to excessive output, improper use or improper connection.
! Relationship between amplifier gain and head unit output power
...
Owner's Manual - Page 7
...amplifier to RCA input jack B or RCA subwoofer input jack. 8 Car stereo with RCA output jacks (sold separately) 9 Connecting wire with RCA pin plugs (sold separately)
The ground wires must be separately fused at 100 A.
3 Positive (+) terminal 4 Negative (*) terminal 5 Battery (sold separately) 6 Ground wire, Terminal (sold separately) a Bass...must be set.
To protect the wiring, wrap sections...
Owner's Manual - Page 8
...remote control wire of the wire is at rest or idling. !
About bridged mode
! Improper connection to burns from overheating. For bridged mode for a 4 W load or a single 4 W speaker per channel. For...for bridging shown on rear: two 8 W
speakers in parallel for a two-channel amplifier, with the ignition whether the car stereo is 2 W to 8 W, or 4 W to other than subwoofer (4 W)
Speaker...
Owner's Manual - Page 9
... used, e.g. Slide the A/B-SW INPUT SELECT (input select) switch to RCA input jack B. Connecting the units
Section
03
English
Connecting the car stereo
Connect the RCA output jack of the car stereo to the RCA input jack of the amplifier. Slide the A/B-SW INPUT SELECT (input select) switch to the speaker input terminal of the...
Owner's Manual - Page 10
...Slide the 2CH-4CH INPUT SELECT (input select) switch to the SW position. When connecting the amplifier using the SP INPUT (speaker input) terminal, do not connect anything to 2CH, do not...output
5
2
3
1
Connection when using the RCA input jack
Connecting the speakers
The speaker output mode can be five-channel output or three-channel output. For details on page 10.
Connection when ...
Owner's Manual - Page 11
...or bind the ends of this screw, which may not work with some headunits. Connecting the units
Section
03
English
Three‐channel output (Stereo bridge)
In the case of a bridge connection, connect the... turn on . Fasten while making sure to not to the amplifier using the speaker input wire
Connect the car stereo speaker output wires to clamp the insulating sheath of the wire....
Owner's Manual - Page 12
...car body.
! Connect the battery wire directly to the car battery positive (+) terminal and the ground wire to 16 AWG wire for the speaker/subwoofer wire. After completing all other amplifier connections, finally connect the battery wire terminal of the amplifier...recommended battery and ground wire, which is sold separately) Each amplifier must be separately fused at 100 A.
2 Use wire ...
Owner's Manual - Page 14
... car, which can be easily removed.
14 En
Section
04 Installation
Before installing the amplifier
WARNING ! This is important to shut down. !
Do not cover the amplifier with the dri- CAUTION ! After installing the amplifier, confirm that the screw tip does not touch any parts other than those supplied are behind the panel and protect...
Owner's Manual - Page 15
Installation
Section
04
English
Attaching the Bass boost remote control
Attach with the use of supplied tapping screws (4 mm × 18 mm (1/8 in. × 3/4....
2 Drill 2.5 mm (1/8 in.) diameter holes at an easily accessible location such as under the dashboard.
3 Install the amplifier with tapping screws (3 mm × 10 mm (1/8 in. × 3/8 in.)) at the imprints either on the carpet...
Owner's Manual - Page 16
...oct High pass filter:
(A/B CH) Cut off frequency 40 Hz to 500 Hz Cut off slope 12 dB/oct Bass boost:
(SW) Frequency 50 Hz Level 0 dB to 18 dB Gain control: RCA 200 mV to 6.5 V ...Use this unit when an audio signal is nearly
the maximum current consumption by this value when working out total current consumption by multiple power amplifiers.
16 En The average current consumption is input.
Similar Questions
Help No Sound
ok amp turns on blue light but no sound when radio is on
ok amp turns on blue light but no sound when radio is on
(Posted by wishfuldreamz32 3 years ago)
My Pioneer Gm-5500t Audio Inputs Are Not Working Help
My amplifier inputs are not working because I screwed up and took it apart to clean the inputs becau...
My amplifier inputs are not working because I screwed up and took it apart to clean the inputs becau...
(Posted by jddubray 5 years ago)
Turn Off Pop .
Hello . When i turn off my radio I get realy loud POP . What can I do ? It is new AMP .....
Hello . When i turn off my radio I get realy loud POP . What can I do ? It is new AMP .....
(Posted by evgenysheglov 6 years ago)
My Bass Knob Is Not Working
I have the pioneer GM-D8601 and the bass knob is not working. i replaced the amp with another one an...
I have the pioneer GM-D8601 and the bass knob is not working. i replaced the amp with another one an...
(Posted by Anonymous-124123 10 years ago)
Is The Red Light On A Good Thing
i have a amp and my frend sayd it mit be broken because he never seen a amp that haves a red light a...
i have a amp and my frend sayd it mit be broken because he never seen a amp that haves a red light a...
(Posted by ericdog19 12 years ago)