How Do You Reset The Tire Light On A 08 Pontiac G6

1. Set the parking brake.

2. Turn the ignition switch to ON/RUN with the

engine off.

3. Using the Driver Information Center (DIC), press

the INFO and Set/Reset buttons at the same time

for about one second. Then press and release

the INFO button until the TIRE LEARN? message

displays.

4. Press and hold the Set/Reset DIC button for

approximately three seconds to start the TPMS

learn mode. The horn sounds twice to indicate the

TPMS receiver is ready and the TIRE LEARN

ON message displays. The driver side front turn

signal also comes on to indicate that corner sensor

is ready to be learned.

5. Start with the driver side front tire.

6. Remove the valve cap from the tire’s valve stem.

Activate the TPMS sensor by increasing or

decreasing the tire’s air pressure for about

eight seconds. The horn chirp, can take up to

30 seconds to sound. It chirps one time and then

all the turn signals flash one time to confirm

the sensor identification code has been matched to

the tire/wheel position.

7. The passenger side front turn signal comes on to

indicate that corner sensor is ready to be learned.

Proceed to the passenger side front tire and

repeat the procedure in Step 6.

8. The passenger side rear turn signal comes on to

indicate that corner sensor is ready to be learned.

Proceed to the passenger side rear tire and

repeat the procedure in Step 6.

9. The driver side rear turn signal comes on to

indicate that corner sensor is ready to be learned.

Proceed to the driver side rear tire, and repeat

the procedure in Step 6.

10. After hearing the single horn chirp for the driver

side rear tire, two additional horn chirps sound to

indicate the tire learning process is done. The

LEARN COMPLETE message displays if all four

tire positions are learned. Turn the ignition switch to

LOCK/OFF.

If no tires are learned after entering the TPMS learn

mode, or if communication with the receiver

stops, or if the time limit has expired, the TIRE

LEARN? message displays on the DIC. Turn the

ignition switch to LOCK/OFF and start over

beginning with Step 2.

11. Set all four tires to the recommended air pressure

level as indicated on the Tire and Loading

Information label.

12. Put the valve caps back on the valve stems.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!