2001 Saab 9-3 Support Question
2001 Saab 9-3 Support Question
Find answers below for this question about 2001 Saab 9-3.Need a 2001 Saab 9-3 manual? We have 1 online manual for this item!
Question posted by viggenowner on December 8th, 2012
Crank Position Sensor Location?
The person who posted this question about this Saab automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by bengirlxD on December 8th, 2012 9:31 AM
bengirlxD
Member since:
November 5th, 2012 Points: 6,395,085
Member since:
November 5th, 2012 Points: 6,395,085
It's low down on the right hand side of the engine block facing the radiator. you should see the metal heat shield that covers it, you won't be able to see the actual CPS.
It's held on with one torx bolt that goes through the heat shield as well. Access is a real PITA, make sure the engine is cold as you're near the turbo & exhaust. I found that bending the heat shield out of the way made removal easier.
It's held on with one torx bolt that goes through the heat shield as well. Access is a real PITA, make sure the engine is cold as you're near the turbo & exhaust. I found that bending the heat shield out of the way made removal easier.
Feel free to resubmit the question if you didn't find it useful.
Related Manual Pages
Owner's Manual - Page 8
... DEATH or SERIOUS INJURY can occur. • Children 12 and under can be killed by the air bag. • The BACK SEAT is in unlocked position. weight 30 lbs. (15 kg). • Max. length 6 ft. (2 metres). For further information, see the manual.
IB994 Use the jack only on firm, level ground...
Owner's Manual - Page 20
...use of the locking function of the child. The button for the locking function is located on the back of the buckle. 1 Position the child seat in the back of the car. 2 To activate the locking ....
The belt must always read the instructions supplied by pulling on the tongue of the belt to the position marked "CHILD SEAT" (item 1 in the figure) in order to activate the locking function. 3 ...
Owner's Manual - Page 21
... for CHildren) consists of two types of attachments for each seat position, see page 23 and 24. IB1683 Saab recommends rearward facing child restraints.
21
Illustration showing lower attachments (ISOFIX) in the rear set, ISOFIX and top tether. Top tether are located behind the head restraints, one for child restraints in the...
Owner's Manual - Page 22
... There are two bars attached to the car body for the center rear seating position. Always follow the installation instructions supplied with the standard safety belts.
LATCH child seats...an uniform method of LATCH child restraints may be fitted where a integrated booster seat is located on the seat back just above each specially designed LATCH child restraint. Child restraints using...
Owner's Manual - Page 23
...belts. • Harnesses. • Attaching other items or equipment to the anchorage that is located just behind the child restraint. 7 Secure the lower part of the child restraint by correctly..., Coupé and 5door models.
IB1362
WARNING Forward facing child restraint in center rear position
When installing a forward facing child restraint in use.
23
Child restraints with the top...
Owner's Manual - Page 42
...breakage. If a fault is detected in position ON. If the signal is activated. The car alarm must now be activated within three minutes, or the glass sensor will once again be excluded from the ... of the dash double-flashes when the car is in the glass sensor, "SERVICE THEFT ALARM" will appear on the SID. The sensor is detected (e.g. Next, press and hold the NIGHT PANEL button until...
Owner's Manual - Page 45
...once every third second. Have the car checked by an authorized Saab dealer. Window-glass sensor is included in a switch serving doors, hood Flashing (instead of keys (remote key).... Turn the ignition key to position ON and then press the button for different countries. Fault in circuit. Alarm not activated. Start the engine. Window-glass sensor is disabled. SID displays the ...
Owner's Manual - Page 66
...cut-out function (in the ABS system. speedometer shown)
The speedometer receives signals from a wheel sensor in the fuel system) prevents the engine speed exceeding approximately 6,200 rpm (2.0 Turbo) and 6,... in the main instrument panel. vehicles and on Canadian vehicles the distance indicated is located close to 87 mph (140 km/h). IB606 IB341
Speedometer (U.S. 66
Instruments and controls...
Owner's Manual - Page 83
... steps to heat the cabin and defrost the windshield as quickly as the rear window is located on the fan switch, as this is mainly intended to provide rapid cooling in the button ... damage if such objects touch the rear window. the heater elements may be chosen. Do not use position 4 on the climate-control panel. Switch off the heating as soon as possible. Avoid placing sharp ...
Owner's Manual - Page 84
... preference and what clothing is worn.
• It is recommended that heating or cooling is located on the inside the car. • The most effective, all windows, and the sunroof if...Conversion between °C and °F is done in the SID unit; it , there is the HI position (max.
Air vent at the bottom edge of the windows. 84
Instruments and controls
Automatic climate control ...
Owner's Manual - Page 85
... properly.
85
Condensation water
When the A/C compressor is dehumidified. The resulting condensation water is parked. Blended-air temperature (located in the heater unit). • Coolant temperature. Instruments and controls
The system uses five sensors Outside-air temperature. Cabin-air temperature. It is therefore perfectly normal for water to be seen dripping from...
Owner's Manual - Page 118
...15 minutes. You will then help you with any of wireless communications, GPS (Global Positioning System) satellites and advanced vehicle electronics. The Advisor will hear a chime, followed by...cellular service is a sophisticated in your OnStar service: 1 Push the blue OnStar button located in -vehicle system allowing convergence of the services included in your personal profile. The ...
Owner's Manual - Page 119
... vehicle is the heart of assistance you in progress. OnStar uses sophisticated Global Positioning System (GPS) satellites to locate your Saab. Blinking Green - The light blinks green to pinpoint your OnStar...our Premium Plan* included for 12 months with directions, making sure your Saab´s location precisely. If you with your Saab. If you cannot contact the OnStar Center, ...
Owner's Manual - Page 141
... it back, align it in . One is 240 W (20 A). Glove compartment
1 To unlock 2 To lock
Ashtrays
(accessory)
The car can be equipped with the two locating pins on the dash and the other electrical accessory.
An open it with two ashtrays. WARNING
The maximum output that can be taken from the...
Owner's Manual - Page 144
... beam is vital since the upper anchorages for the safety belts are in the most rearward position.
The alarm horn sounds three times and the lights flash when the trunk is released with... red warning tabs must be almost vertical. 1 Flip up the seat bottom by pulling the loops located between the backrest cushions and seat cushions. 2 Rest the seat cushions on edge just behind the front...
Owner's Manual - Page 152
... sure to see that you can only be removed when the gear lever is in the ON position while the engine is not running.
Start position (ST) The starter motor operates in the center console located between OFF and LOCK before you release the key, it . IB862
Ignition switch
The single lock used...
Owner's Manual - Page 183
Fold back the rubber strip and locate the fixing holes. In fitting the rear carrier on Coupés, press the foot down over the pins ... assembly. 2 Open all the doors. On Coupés, the cover plates for the rearmost points of attachment must be removed. 3 Position the carrier gently across the roof, with a knob for load carrier, front on Coupés and front/rear on five-door models...
Owner's Manual - Page 188
...your warranty. This will avoid sparks and help save your radio.
4 Open the hood and locate the battery. NOTE
If the other system is not running and can injure you have an... radio on the negative jumper cable should inadvertent contact be injured if the vehicles roll. Find the positive (+) and negative (-) terminals on each other vehicle. Keep hands, clothing and tools away from any...
Owner's Manual - Page 192
... but not closing the hood.
IB1514
IB887 Open the hood in the following way: 1 Pull the release handle. 2 The hood moves to the half-locked position and is located on the left under the instrument panel.
Owner's Manual - Page 222
... jack under the rear axle or under the front of the four jacking points (front or rear) located beneath the sills.
Loosen the wheel bolts by the dealer or centrally under the rear floor. IB924
Positioning the jack
5 Remove the wheel cover (where applicable). Saab 9-3 Viggen: The front and rear jacking points...
Similar Questions
How To Change Crank Shaft Position Sensor On Saab 9-3
(Posted by geortommya 10 years ago)
How To Change Crankshaft Position Sensor On 2006 Saab 9-3
(Posted by mscechoch 10 years ago)
Saab 9-3 Crankshaft Position Sensor Where Is Part Located Car
(Posted by avdmselv 10 years ago)
Replace Crankshaft Position Sensor (cps) For A Saab 2006 9-3 Sedan
Does anyone know where the CPS is located and how to replace it for a SAAB 2006 9-3? Any help would ...
Does anyone know where the CPS is located and how to replace it for a SAAB 2006 9-3? Any help would ...
(Posted by Rodriguezh02 11 years ago)