My 300z Turns On ,but When I Disengage The Switch It Turns Off

https://www.youtube.com/watch?v=koOTKMS6Hc0

https://www.youtube.com/watch?v=R2-fF_J-KV8

https://www.youtube.com/watch?v=NIoqQPtAQ1o

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. ... This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner.

https://www.youtube.com/watch?v=MT14zEPxMHw

How do you bypass the safety switch on a lawn mower?

How to Bypass Seat Safety Switch on Lawn Mower?

Step 1: Set the Mower on Flat Ground. ...

Step 2: Disconnect the Battery Terminal. ...

Step 3: Get Access to the Seat Safety Switch. ...

Step 4: Take off the Safety Switch Wires. ...

Step 5: Cut the Wire & Tape Them. ...

Step 6: Take the Seat Back to Its Position.

Why does my mower die when I let off the clutch?

If the fuel tank is empty or you've left the throttle in the choke position -- or opened it too slowly -- the engine will cut off. Smooth starts also depend on easy movement of engine parts and the crankshaft, so an empty crankcase or low oil level can lead to seizing and stalling.

Why does my lawn mower only run for a few seconds then dies?

If your lawn mower starts, runs briefly, then dies these are the four most common reasons that's happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.

========================

Thank you, Happy to serve !

" accept my work-- Sonu Kumar

=========================