Tanaka TCS33EB14 Support Question
Tanaka TCS33EB14 Support Question
Find answers below for this question about Tanaka TCS33EB14.Need a Tanaka TCS33EB14 manual? We have 2 online manuals for this item!
Question posted by jeanguyjoyal on June 3rd, 2016
Carb Kit
Where can I get a carburator kit for this machine ? and what price ?
Current Answers
Related Tanaka TCS33EB14 Manual Pages
Handling Instructions - Page 6
... 11 OPERATING PROCEDURES 11 MAINTENANCE 13 Parts breakdown
6 It is important that you read, fully understand and observe the following show symbols used for the machine. Always wear eye, head and ear protectors when using this manual and on the unit. Read, understand and follow all warnings and instructions in this...
Handling Instructions - Page 7
...Throttle trigger: Device activated by the operatorʼs finger, for acting as a cutting tool. 11. Oil tank cap: For closing the fuel tank. 8. Spiked bumper (optional): ...13. Fuel tank cap: For closing the oil tank.
8
E
5. F
6
R
9. Combi box spanner: The tool for stopping or locking
the chain. 12. Chain brake (Front hand guard): Device for removing or installing a spark
4...
Handling Instructions - Page 8
... safety ○ Do not cut with feet well balanced and your unit/
machine for any job except that for this tool when you use . Never cut any material other than the items listed in...accustomed to pre-plan a safe exit from the cutting attachment. ○ Always carry a first-aid kit when operating any way. Do not use .
If fuel is caused by the manufacturer. Do not over-reach...
Handling Instructions - Page 9
...or
G
in a vehicle.
○ Empty the fuel tank before storing the unit/machine. B
Transport and storage
○ Carry the unit/machine by hand with chain
R
cover.
If fuel is
left in the tank, store so... fuel will not leak.
○ Store unit/machine out of the reach of personal injury or equipment damage, if
N
instructions are not covered in ...
Handling Instructions - Page 11
... of installing the spiked bumper (3), install the spiked
bumper (3) (if so equipped) to get out of saw horizontally, release your
9. WARNING Do not carry the machine with a two-stroke engine. Before fueling, clean the tank cap area carefully, to ensure that the fuel is well mixed by shaking the container, before...
Handling Instructions - Page 13
... about 100 operation hours or earlier if the electrodes are not properly trained. Begin with this machine was originally
Stop the engine. NOTE
Some models sold in warm soap suds. Cross cut
new...
you can come loose and cause personal injuries. Raise the log or change its position, using the machine, clean the groove and oiler port (37) in all your Tanaka dealer. Do not try to...
Handling Instructions - Page 14
... and lower the
depth. 2) Check depth gauges every third sharpening. 3) Place depth gauge tool on cutter. After that nuts and screws are properly tightened before starting engine. To avoid this... resulted from the fuel tank. Depth Gauge Setting
0.025"
4.
Especially inspect the bolt of the tool. CHAIN SHARPENING Parts of a cutter (Fig. 38, 39)
WARNING ○ Gloves should be loose...
Similar Questions
Tcg24ecpsl Fuel Nhose Routing
looking for a diagram or instructions to replace fuel hoses, 2 hoses -pickup and return out of the t...
looking for a diagram or instructions to replace fuel hoses, 2 hoses -pickup and return out of the t...
(Posted by rbdjr 2 years ago)