Troy-Bilt TB230 Support Question
Troy-Bilt TB230 Support Question
Find answers below for this question about Troy-Bilt TB230.Need a Troy-Bilt TB230 manual? We have 1 online manual for this item!
Question posted by JayFamily985 on April 19th, 2014
Can't Get Mower To Start.
My second season with this mower and it wont start.
Current Answers
Answer #1: Posted by freginold on April 22nd, 2014 3:46 AM
freginold
Member since:
December 20th, 2011 Points: 23,253,985
Member since:
December 20th, 2011 Points: 23,253,985
Hi, there are many things that could prevent your Troy-Bilt mower from starting. If it's been stored for a while and not used, but there was gas in the tank, the gas might just be old. Try flushing out the gas tank and carburetor, then filling the tank with new gas.
Another highly likely cause of the mower not starting is a bad spark plug. Spark plugs usually only cost a few bucks, so it's not a big investment to try a new one and see if that gets your mower to start.
If neither of those solutions helps, you may want to try changing the oil and replacing the air filter. If it still won't start, the carburetor may have a blockage, or you could have a more serious problem. Try spraying some starting fluid into the carburetor (with the air filter removed and the mower off) then put it back together and try starting -- if it starts then dies, there is probably a blockage in the carb.
If nothing else has worked, attach a spark plug tester to your spark plug to see if the plug is getting electricity. If it's not, there's a problem somewhere with one of the electrical components.
Here's a link to the operator's manual, which may be helpful:
- Troy-Bilt TB230 / TB260 / TB280 ES (PDF)
Related Troy-Bilt TB230 Manual Pages
Operation Manual - Page 1
... LLC, P.O. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 769-07346 (November 2, 2011)
Models TB230, TB260, & TB280 ES
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. Safe Operation Practices •...
Operation Manual - Page 2
... cover a range of the machine are observed from the experts. Review this manual, all references to right and left side of product specifications for purchasing a Lawn Mower manufactured by standing at the operator's position and looking down at all models. Please be necessary, should you how to the engine manufacturer's Owner's/Operator...
Operation Manual - Page 3
....
3. Never allow children under the cutting deck. by the blade. Only responsible individuals who are recommended.
Therefore, exercise extreme caution at least 75 feet from mower
to operate this machine. Contact with the controls and the proper use this symbol. Important Safe Operation Practices
2
WARNING: This symbol points out important safety...
Operation Manual - Page 4
... a few seconds after the blade control is not alert to do not understand the dangers. Never operate the mower in daylight or good artificial light. Always be sure of the mower being pulled over should start to fully extend your vision of a responsible adult other safety protective devices in severe injury.
If you...
Operation Manual - Page 5
... wear and damage which can result in handling gasoline. Never tamper with the rim of filler neck to cool at least two minutes before starting and operating the mower.
8. Do not crank engine with a portable container, rather than 1 inch below bottom of the fuel tank or container opening at frequent intervals for...
Operation Manual - Page 9
... oil as shown in the accompanying engine manual BEFORE operating your mower.
B
Figure 3-2
A
Figure 3-1
9 Assembly & Set-Up
3
Contents of Carton
• One Lawn Mower
•
• One Lawn Mower Operator's Manual •
One Grass Catcher One Engine Operator's Manual
• One Bottle of this mower. Fill up as instructed in Fig. 3-2. Remove wing nuts and carriage...
Operation Manual - Page 11
...
11 Side Mulching Plug
1
2
A
Figure 3-7 2. B
A
Figure 3-9
2.
Lift grass catcher up and of discharge door so that it to fall when lever is off of the mower, lift the side mulching plug. Let go of the slots in Fig. 3-8. Do not remove side mulching plug at any time, even when you are...
Operation Manual - Page 12
...drive control engaged. Release lever towards deck.
Add oil provided before starting unit for additional engine information. 1. NOTE: For mowers with low wheels, the height adjustment levers move in the same ...3-10A
3. Position the handle in the
separate engine owner's manual. For rough or uneven lawns, move in the opposite direction to a higher position. Assembly & Set-Up Service the...
Operation Manual - Page 13
... Cutting Height Adjustment Lever
One adjustment lever is located on the right rear wheel and one is located on top of the mower.
Controls and Features
Drive Control Electric Start Ignition Switch Recoil Starter
Side Discharge Chute
Cutting Height Adjustment Lever
4
Blade Control
Deck Wash Cutting Height Adjustment Lever
Figure 4-1
Blade Control...
Operation Manual - Page 14
... with a rapid, continuous, full arm stroke. Let the rope rewind each time slowly. Stopping Engine
1. Operation
Starting Engine
WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Briggs & Stratton Engine:
1. Follow the set of the engine into the choke position.
3. Refer to your...
Operation Manual - Page 15
... foreign objects being thrown into the eyes, which could be promptly inspected and repaired. Operation
15 Using Grass Catcher
You can result in any lawn mower can use the grass catcher to close the rear opening of the grass clippings and reinstall the bag when complete.
Grass clippings will automatically collect ...
Operation Manual - Page 16
... a season with the air cleaner facing up of maintenance on the ground.
WARNING: Never tip the mower more than...and clean the underside of the engine causing a starting problem.
3. Maintenance & Adjustments
6
Maintenance
General Recommendations
• Always... engine manual for lubrication schedule and instruction for this lawn mower does not cover items that have been subjected to...
Operation Manual - Page 17
... jobs required for a minimum of two minutes, allowing
the underside of your lawn, near enough for a detailed list and instructions.
• Maintain oil level...mower's discharge chute is recommended at the start of the cutting deck to rinse grass clippings from your deck, restart the mower. Check engine manual for a minimum of two minutes, allowing the underside of each mowing season...
Operation Manual - Page 18
...removed in the operating position. See Fig. 7-1.
4. It may cause damage to change the mower's belt. Place the blade on the blade adapter flanges. Placebladebellsupportontheblade.Alignnotchesontheblade bell support with small...heavy side until it balances evenly. Make sure that the blade is in order to mower and could break causing personal injury.
5. lbs. To ensure safe operation of heavy...
Operation Manual - Page 19
...7-3
2. Charge battery for instance when bagging), more frequent charging may be vented during each cut throughout the season (for 8 to remove. NOTE: If you charge the battery.
4. Replace with care and keep away... other extended periods of action every time you frequently stop and restart the mower during charging or discharging. Explosive gases
1. Service
19
See Fig. 7-2. ...
Operation Manual - Page 20
....
2. Off-Season Storage
The following steps to handle as described in the lubrication instructions.
• Coat mower's cutting blade ...equipment, especially cables and all moving parts of your lawn mower for correct engine storage instructions.
• Secure side...battery cover.
• Store mower in Fig. 7-6. Battery (If Equipped)
The battery must be started manually if the fuse burns...
Operation Manual - Page 22
... a high cutting height, then mow again at high speed Idles poorly Excessive Vibration Mower will not mulch grass
Cause
Remedy
1. Fuel tank empty or stale fuel. 4. ...low. 2. Fill crankcase with CHOKE (if equipped)
applied. 1. Troubleshooting
9
Problem
Engine Fails to start
Engine runs erratic
Engine overheats Occasional skips (hesitates) at desired height or make a narrower cutting ...
Operation Manual - Page 23
... or worn belt. Place front and rear wheels in same height position.
2.
Wheels not positioned correctly. 2. Dull blade. 1. Inspect and replace belt. Problem
Uneven cut
Mower will not self propel
Cause
1. Remedy
1. Check belt for proper pulley installation and movement.
2. Sharpen or replace blade.
1.
Operation Manual - Page 26
... material and workmanship for rental expenses to be liable for incidental or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for a period of two (2) years commencing on the date of purchase. HOW TO OBTAIN SERVICE: Warranty service is available, WITH PROOF OF...
Similar Questions
Juice To Ignition Switch But Won T Try To Turn Over
with switch on, no juice to spark plug and switch checks out
with switch on, no juice to spark plug and switch checks out
(Posted by Dfuller951 2 years ago)
Does The Tb230 Have A Fuel Filter.
My lawn mower running rough. I cleaned the air filter. new spark plug. cleaned plug nut at bottom of...
My lawn mower running rough. I cleaned the air filter. new spark plug. cleaned plug nut at bottom of...
(Posted by guitod 2 years ago)
Does The Transmission Belt Go Around Both Pulleys In Back Underneath The Battery
The mower wont go forward nor in reverse. Only around 1 pulley in back. Does it need to go around bo...
The mower wont go forward nor in reverse. Only around 1 pulley in back. Does it need to go around bo...
(Posted by shabsingin 9 years ago)
Mower Starts But Shuts Down After 1-2 Mins. Doesn't Seem To Get Full Power
Hey, mower starts but shuts down after 1-2 mins. Doesn't seem to get full power
Hey, mower starts but shuts down after 1-2 mins. Doesn't seem to get full power
(Posted by ltdjtd 10 years ago)
Troy Built Self Propelled Mower Model Tb230 - Side Discharge Chute
side discharge chute does not fit well under the hinge pin on multching plug .. fits - but when plug...
side discharge chute does not fit well under the hinge pin on multching plug .. fits - but when plug...
(Posted by donapatton 10 years ago)