Get support for Troy-Bilt TB6044 XP

Troy-Bilt TB6044 XP Support Question

Troy-Bilt TB6044 XP Support Question

Find answers below for this question about Troy-Bilt TB6044 XP.
Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!
Question posted by ljnson on October 21st, 2013

Brand New And Wont Start.

I put oil in, put gas in, primed bulb, pulled and pulled and pulled string and wont start, any ideas?

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Troy-Bilt TB6044 XP Manual Pages

Operation Manual - Page 1

Operator's Manual Electric Start Capable 4-Cycle Trimmer TB6044 XP TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20 SAVE THESE INSTRUCTIONS SERVICE DO NOT RETURN THIS UNIT TO ...
Operation Manual - Page 2

...8226; READ ALL INSTRUCTIONS BEFORE OPERATING SAFETY WARNINGS FOR GAS UNITS WARNING: When using the unit. 2 The safety...unit immediately, before using the unit, all adjustments or repairs before starting the unit. Take the following precautions: • Store fuel only ... objects. Remove rocks, broken glass, nails, wire, string and other reproductive harm. Forest Land and in property...
Operation Manual - Page 3

... feet away from grass, leaves, excessive grease or carbon build up. • If the unit starts to Starting and Stopping. • Use the right tool. It will do the job. Stop the unit.... unit has a clutch. Be in daylight or good artificial light. • Avoid accidental starting position whenever pulling the starter rope. Do not extend the trimming line beyond the length of trouble. WHILE ...
Operation Manual - Page 4

... repair information. SYMBOL MEANING • ON/OFF STOP CONTROL ON / START / RUN • ON/OFF STOP CONTROL OFF or STOP • PRIMER BULB Push primer bulb, fully and slowly, 10 times. • THROWN OBJECTS AND ROTATING ... and loud noise can be used in serious injury to operator's manual for the proper type of oil. • DO NOT USE E85 FUEL IN THIS UNIT WARNING: It has been proven that may...
Operation Manual - Page 5

... . (0.635 mm) Spark Plug Champion® RDZ4H or equivalent plug Lubrication SAE 30 Oil Crankcase Oil Capacity 2.03 oz. (60 ml) Fuel Tank Capacity 12 oz. (355 ml) ...Housing Air Filter Cover Throttle Control Starter Rope Grip Primer Bulb Fuel Cap Cold Weather Start Lever Cutting Head Coupler Cutting Head Shield Oil Fill Plug Line Cutting Blade SPECIFICATIONS* Engine Type Air-Cooled...
Operation Manual - Page 7

...counterclockwise to assembling the attachment. 1. WARNING: Before using any attachment, read and understand the manual that came with a string trimmer attachment, lock the release button into the primary hole (Fig. 5). 3. Installing the Attachment NOTE: Remove the... hole (Fig. 3). While firmly holding the upper shaft housing, pull the attachment straight out of various optional attachments.
Operation Manual - Page 8

... the oil level before starting the unit. Oil must be overemphasized. Unscrew the oil fill plug (Fig. 7). 5. Reinstall the oil fill plug. DO NOT use . The importance of maintaining the proper oil level cannot be added before each use dirty oil. Reinstall the top of API (American Petroleum Institute) service class SJ. Set the unit on the oil...
Operation Manual - Page 9

... spilled. 5. WARNING: Remove the fuel cap slowly to federal, state and local regulations. Do not start the engine until fuel vapors dissipate. 1. Move the unit at a distance from the area. Definition ...of old fuel is extremely flammable. As little as 1% water in the fuel can make fuel and oil separate, forming acids when stored. NOTE: Dispose of fuel, according to the unit's fuel tank....
Operation Manual - Page 10

... position (Fig. 10). 6. Slowly press and release the primer bulb 10 times (Fig. 9). Pull the starter rope with step 4. IF COLD... DO NOT squeeze ...Bulb Open Closed Cold Weather Start Lever STOPPING INSTRUCTIONS 1. Off (O) / Stop On ( I ) position at all times (Fig. 8). Check the oil level. IF COLD... In cold weather (below 40°F), move the cold weather start , begin the starting...
Operation Manual - Page 11

... times (Fig. 9). If fuel cannot be seen in the primer bulb, press and release the primer bulb until fuel is in the starting procedure with an optional electric start , begin the starting procedure with step 3. Remove the electric start port (Fig. 12). IF... Check the oil level. NOTE: There is properly warmed up for an additional 30...
Operation Manual - Page 13

... Refer to Maintaining the Air Filter. • Change the oil. These can break off and become dangerous projectiles. The line...metal-reinforced line, wire, chain or rope. Installing New Trimming Line 1. Pull the line until the ends are unsure about 5 inches... wind the line until a few inches protrude from starting accidentally. NOTE: Please read the California/EPA statement that...
Operation Manual - Page 14

.... 20). Remove any old trimming line and/or obstructions from entering the oil fill hole. 2. Check the oil level before each use a flashlight if necessary. If the oil level is level (Fig. 19). Adding Oil 1. Unscrew the oil fill plug. 3. CHECKING THE OIL LEVEL WARNING: OVERFILLING THE CRANKCASE MAY CAUSE SERIOUS PERSONAL INJURY. The importance of...
Operation Manual - Page 15

...cover will flow freely and carry away more impurities. 1. Insert the tab on the back of the oil fill hole and into the air filter cover. Fig. 21 Fill Line Fig. 22 Hole Air ... Cover Air Filter Fig. 23 Cover Screw 15 CHANGING THE OIL Change the oil while the engine is not covered by the product warranty. Fill the oil bottle to the right. MAINTAINING THE AIR FILTER WARNING: To...
Operation Manual - Page 16

... screw counterclockwise, 1/8 of engine power MAINTAINING THE SPARK PLUG 1. NOTE: If using a torque wrench, torque to Starting and Stopping. 2. If the engine is cracked, fouled or dirty, replace it clockwise until the engine idles smoothly ... cool. Grasp the spark plug boot firmly and pull it to prevent serious personal injury. Install the spark plug in . (0.635 mm) (Fig. 25). 5.
Operation Manual - Page 17

...more than 30 days. Long-term Storage 1. Reinstall the fuel cap. 2. Pull the starter rope slowly to Changing the Oil. Repair or replace damaged parts and tighten loose screws, nuts or bolts....of the reach of children. Remove the spark plug and put 5 drops of the oil from the carburetor. 3. Change the oil. Start the engine and allow it to cool before storing. • Lock up the unit...
Operation Manual - Page 18

... The cold weather start lever is in the closed position SOLUTION Fill the fuel tank with fresh fuel Press the primer bulb 10 times or...engine and clean the cutting head Refill the cutting head with new line Rewind the line Clean the inner reel and outer spool...knob and pull the line until 4 inches (102 mm) is outside of the cutting head THE CUTTING LINE ADVANCES UNCONTROLLABLY There is oil, cleaner ...
Operation Manual - Page 20

...warranty as to any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to temporarily... been operated and maintained in accordance with the Operator's Manual furnished with respect to new merchandise purchased and used in Canada, or write to P.O. No other express warranty or...
Parts Diagram - Page 1

MODEL TB6044 XP 4-CYCLE TRIMMER PPN 41ADZ6PC766 46 47 ... Assembly Air Purge Primer Top Cover Gasket Screw Starter Housing Assembly Screw Electric Start Adapter O-Ring Intake Port Boot Assembly Carburetor Gasket Insulator Insulator Gasket Washer Screw... Assembly Screw Screw Screw Shortblock Assembly Oil Fill Plug O-Ring Oil Fill Tube Spark Plug Muffler Housing Muffler Assembly Screw Aircleaner Spacer Muffler...
Parts Diagram - Page 2

MODEL TB6044 XP 4-CYCLE GAS TRIMMER PPN 41ADZ6PC766 Item Part No. Description 1 753-06887 Throttle Housing Assembly (includes 2 - 5) 2 791-182405 Switch Assembly 3 753-05171 Throttle Lock-out 4 753-05007 Throttle ...

Similar Questions

How Do I Replace Pull String
pull cord will not rewind
(Posted by Apeersmanxman 11 months ago)
Wont Start, Leaking Fuel
My Troy Bilt TB225 2 stroke tiller won't start, and is leaking fuel. The fuel leak appears to be com...
(Posted by mikemc0969 4 years ago)
Tb22 Ec Wont Start
Have a brand new TB22 EC. Can't start it manually so went and bought the electric starter (49M2027P9...
(Posted by cpsoto1227 8 years ago)
Changing Trimmer Head On Troy-bilt Tb6044 Xp
I have a TB6044 XP and want to replace the trimmer head with a Pivotrim hybrid. But cannot remove th...
(Posted by GCP1 8 years ago)
Starter Cord Will Not Recoil.
I have a TB6044 xp 4-cycle gas trimmer. Recently I tried to start unit and the pull cord did not rec...
(Posted by tstale 8 years ago)
Ask a New Question
Use the box below to post a new question about this Troy-Bilt product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Troy-Bilt Manuals

Find free Troy-Bilt TB6044 XP manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Troy-Bilt Reviews

View thousands of Troy-Bilt user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Troy-Bilt customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Troy-Bilt customer service rankings, employee comments and much more from our sister site.

Troy-Bilt Recalls

Find comprehensive Troy-Bilt recall information updated hourly on RecallOwl.com.