Home » Troy-Bilt » Lawn & Garden » Troy-Bilt TB6044 XP

Troy-Bilt TB6044 XP Support Question

Find answers below for this question about Troy-Bilt TB6044 XP.
Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!

Troy-Bilt Overview Questions Manuals Reviews Videos Research

Question posted by josephverrett1 on June 26th, 2021

Oil Blowing Out Near Carburetor

how to repair. Found a disconnected hose.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by INIMITABLE on June 30th, 2021 3:49 PM

This answer was accepted by the poster of the original question.

INIMITABLE

Member since:
April 3rd, 2020

Points: 2,088,520

1,100
points

'Make sure the breather hose that goes into the back of the air cleaner base' is well fixed and intact.
check this link out for more help; https://www.lawnmowerforum.com/threads/troy-bilt-4-cycle-trimmer-with-oil-leak.49777/

I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers

-INIMITABLE

Related Troy-Bilt TB6044 XP Manual Pages

Operation Manual - Page 1

... For assistance regarding the assembly, controls, operation or maintenance of authorized service dealers near you. Copyright© 2012 MTD SOUTHWEST INC, All Rights Reserved. 10/12 ... Operator's Manual Electric Start Capable 4-Cycle Trimmer TB6044 XP TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12...

Operation Manual - Page 2

... cancer and birth defects or other objects that are approached, stop the engine and allow it to cool before using the unit, all adjustments or repairs before filling the tank. Never remove the fuel tank cap or add fuel when the engine is hot. Operate this manual. Failure to do not...

Operation Manual - Page 3

...the best grip. • Make sure the attachment is turned off and disconnect the spark plug for maintenance or repair. • Use only original equipment manufacturer (OEM) replacement parts and ...unit for damage. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Disconnect the spark plug wire. • Secure the unit while transporting. • Never store the...

Operation Manual - Page 4

...warning or caution. Use a full face shield when needed. • UNLEADED FUEL Always use clean, fresh unleaded fuel. • OIL Refer to the operator and/or bystanders. • WEAR EYE AND HEARING PROTECTION WARNING: Thrown objects and loud noise can be used...trimmer attachment shield. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information.

Operation Manual - Page 5

... Grip Primer Bulb Fuel Cap Cold Weather Start Lever Cutting Head Coupler Cutting Head Shield Oil Fill Plug Line Cutting Blade SPECIFICATIONS* Engine Type Air-Cooled, 4-Cycle Displacement 32 cc...Gap 0.025 in. (0.635 mm) Spark Plug Champion® RDZ4H or equivalent plug Lubrication SAE 30 Oil Crankcase Oil Capacity 2.03 oz. (60 ml) Fuel Tank Capacity 12 oz. (355 ml) Approximate Unit Weight...

Operation Manual - Page 8

... USE WARNING: OVERFILLING THE CRANKCASE MAY CAUSE SERIOUS PERSONAL INJURY. Check the oil level before starting the unit. The importance of oil. 1. Change the oil according to Checking the Oil Level. Oil must be overemphasized. Remove the paper seal. Remove the cap from the oil bottle. DO NOT overfill. Unscrew the top of API (American Petroleum...

Operation Manual - Page 9

... regulations. FUELING THE UNIT WARNING: Gasoline is the most common cause of gasoline and oxygenates such as 1% water in the fuel can make fuel and oil separate, forming acids when stored. Do not smoke while filling the tank. WARNING: Add fuel in place. Remove the fuel cap. 3. Position the unit with...

Operation Manual - Page 10

... Rope Grip Starting Position Fig. 11 10 Off (O) / Stop On ( I ) position at all times (Fig. 8). Check the oil level. In cold weather (below 40°F), move the cold weather start lever to Checking the Oil Level. 2. The On/Off switch is visible. 4. DO NOT squeeze the throttle control (Fig. 8). the engine stops...

Operation Manual - Page 11

Check the oil level. Refer to idle. 2. Remove the electric start accessory in intervals no need to turn the... port (Fig. 12). IF... IF COLD... Slowly press and release the primer bulb 10 times (Fig. 9). Refer to Checking the Oil Level. 2. Insert the electric start accessory into the electric start accessory operator's manual. 6. USING THE ELECTRIC START ACCESSORY This unit can ...

Operation Manual - Page 13

...when the line winding is too long. Disconnect the spark plug wire to Changing the Oil. • Have the rocker arm clearance... emissions control devices, such as the spark arrestor, muffler, carburetor, etc. Turn the bump knob clockwise to an MTD authorized... before servicing or repairing the unit. MAINTENANCE WARNING: To prevent serious injury, never perform maintenance or repairs while the unit...

Operation Manual - Page 14

... Window 1. NOTE: Make sure the O-ring is approximately halfway up any old trimming line and/or obstructions. 4. CHECKING THE OIL LEVEL WARNING: OVERFILLING THE CRANKCASE MAY CAUSE SERIOUS PERSONAL INJURY. NOTE: Failure to keep the engine level may have spilled. 5. Use a clean cloth to overfill. 3. ...

Operation Manual - Page 15

...NOTE: DO NOT overfill. Swing the air filter cover to Checking the Oil Level. Wash the air filter in place on the oil fill plug (Fig. 7). NOTE: Operating the unit without the air filter... Insert the cover screw into a container (Fig. 21). Tip the unit vertically to dry. 4. Fill the oil bottle to secure the air filter cover (Fig. 23). NOTE: Make sure the O-ring is in detergent and...

Operation Manual - Page 16

... electrodes. Install the spark plug in . (0.635 mm) Fig. 25 16 Checking the fuel, cleaning the air filter, and adjusting the idle speed should make carburetor adjustments. If the spark plug is cracked, fouled or dirty, replace it to reduce the idle speed (Fig. 24). Idle Speed Screw Fig. 24 0.025...

Operation Manual - Page 17

...put 5 drops of old fuel according to Changing the Oil. Reinstall the spark plug. 4. Wipe off any loose or damaged parts. Repair or replace damaged parts and tighten loose screws, nuts or... dry, well-ventilated area. • Store the unit out of the reach of the oil from the carburetor. 3. Start the engine and allow it to prevent unauthorized use strong detergents. Thoroughly clean...

Operation Manual - Page 18

..., push the bump knob and pull the line until 4 inches (102 mm) is outside of the cutting head THE CUTTING LINE ADVANCES UNCONTROLLABLY There is oil, cleaner or lubricant in the cutting head Clean and thoroughly dry the cutting head If further assistance is required, contact an authorized service dealer. 18

Operation Manual - Page 20

... without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses,...of the United States of America, its option, repair or replace, free of export distribution. This limited...20 Box 361131, Cleveland, OH 44136-0019. Spark Plugs, Carburetor Adjustments, Filters B. MANUFACTURER'S LIMITED WARRANTY FOR: The limited warranty...

Parts Diagram - Page 1

MODEL TB6044 XP 4-CYCLE TRIMMER PPN 41ADZ6PC766 46 47... Start Adapter O-Ring Intake Port Boot Assembly Carburetor Gasket Insulator Insulator Gasket Washer Screw Aircleaner Assembly Screw Screw Carburetor Assembly O-Ring Aircleaner Spacer Screw Fuel Tank ... Assembly Screw Screw Screw Shortblock Assembly Oil Fill Plug O-Ring Oil Fill Tube Spark Plug Muffler Housing Muffler Assembly Screw Aircleaner Spacer Muffler...

Parts Diagram - Page 2

...) 20 753-08163 Bump Knob 1 2 3 6 5 7 8 10 9 12 13 14 15 16 11 19 17 20 769-08524 / 01 12 18 08/13 REPLACEMENT PARTS - MODEL TB6044 XP 4-CYCLE GAS TRIMMER PPN 41ADZ6PC766 Item Part No.