Whirlpool DU1345XTVQ Support Question
Whirlpool DU1345XTVQ Support Question
Find answers below for this question about Whirlpool DU1345XTVQ.Need a Whirlpool DU1345XTVQ manual? We have 5 online manuals for this item!
Question posted by Anonymous-167236 on November 10th, 2020
How To Re-set My Dishwasher
The lights just bllink and I need to re-set. How?
Current Answers
Answer #1: Posted by INIMITABLE on November 11th, 2020 7:44 AM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,088,520
Member since:
April 3rd, 2020 Points: 2,088,520
To reset it, you will have to have the door open. It can not be latched. Press "Heated Dry," "Normal," "Heated Dry," "Normal" within three seconds of the first pressed button. Now close the door, this should reset your dishwasher.
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Whirlpool DU1345XTVQ Manual Pages
Dimension Guide - Page 1
...counter, or be needed to connect to 33⁷⁄₈" (86 cm) by removing wheels from dishwasher.
**Minimum, measured from narrowest point of the dishwasher door and the... minimum clearance between the side of opening .
Specifications subject to improve
Dimensions are for your dishwasher.
It is not recommended). When connecting the air gap a rubber hose (not provided) ...
Installation Instructions - Page 2
... be performed by a qualified service technician.
This is , tell you how to :
• Slowly open door.
You Need to reduce the chance of the dishwasher. We have provided many important safety messages in this dishwasher as specified in serious injury or cuts. You can result in these instructions.
• Installation should be killed...
Installation Instructions - Page 3
... only partway into opening is not covered by authorized service personnel. Damage from your dealer for installing your dealer for first time installations Tools needed:
Cordless drill with dishwasher
Measuring tape or ruler
Small level
10" adjustable wrench that electrical connections be installed. Make sure pipes, wires and drain hose are included...
Installation Instructions - Page 4
...31"cm)
(621 4c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(612c4m" )**
NOTE: Shaded area of cabinet walls show where utility connections... may be reduced to 33⁷⁄₈" (86 cm) by removing wheels from dishwasher.
**Minimum, measured from the lowest point on the underside of opening.
(86m.344inc"*m)
4
(10...
Installation Instructions - Page 5
...located in house plumbing and 20" (50.8 cm) minimum above code standards can be needed to connect to the waste tee or disposer inlet.
Electrical Requirements
Be sure that the ...8226; Make sure to use with a maximum length of the dishwasher. • Make sure to connect drain hose to the dishwasher opening. If connecting dishwasher with 20-120 psi (138-862 kPa) water pressure can ...
Installation Instructions - Page 6
... electrical power at the fuse box or circuit breaker box before installing dishwasher. Existing utility hookups No existing utility hookups Water line
Cable
Prepare Cabinet...If the water line and the cable extend to the locations shown, proceed to the dishwasher cabinet opening.
1 Power Supply Cord-Drill hole
Optional loactaiotinon
Preeffeerrereddlolocactaiotinon
1¹⁄₂"...
Installation Instructions - Page 7
...)
Drill a ³⁄₄" (1.9 cm) hole in area shown. Metal cabinet: Cover hole with power supply cord kit.
Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will make water connection easier.
1 Drill hole
PrPerfeefrerrereddloloccations
OOpptitoionnaal llolocacattioionnss
¹⁄₂"
(1.3 cm)
Drill a ¹⁄₂" (1.3 cm) hole in compliance with local codes...
Installation Instructions - Page 8
...the 90° elbow fitting as far as it does not touch the dishwasher base, frame or motor.
8
1¹⁄₂"
(3.8 cm)
If needed, drill a 1¹⁄₂" (3.8 cm) diameter hole in cabinet ... operation, route the water supply line so that it will keep the drain hose from moving when dishwasher is moved into a shallow pan until clear to get rid of particles that the ³⁄&#...
Installation Instructions - Page 9
...made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. with air gap • Option D, No waste disposer -
no air gap
SLcarregwe...Connect black end of drain hose to remove plug.
3 Black end
3. Use pliers to air gap and cut if needed . no air gap
No waste disposer - If the drain hose was cut , use a 1¹⁄₂" to...
Installation Instructions - Page 10
.... Excessive Weight Hazard Use two or more people, grasp sides of the tub.
2 Put dishwasher on its back
Using a ¹⁄₄" hex head socket, nut driver or Phillips ... cover. Retain for later use.
5 Install strain relief
Helpful Tip: Place cardboard under dishwasher until completely installed. Make sure screwheads are facing to avoid damaging floor covering. Strain relief...
Installation Instructions - Page 11
...Connect ground wire to be sure both are secured. Pull cord through the ring terminal of dishwasher tub. Do not use ? Make Power Supply Cord Connection
Option A, Power Supply Cord:..."Determine Cabinet Opening," to continue with the installation of your power supply cord to connect your dishwasher. Power Supply Cord: Follow Option A instructions Direct Wire: Follow Option B instructions
If using...
Installation Instructions - Page 12
.... Close cover ensuring wires are tucked inside terminal box. Use ¹⁄₄" nut driver and previously removed screw to "Dishwasher Height Adjustment Chart" for wheel position and the number of turns needed , see website for animated representation of cover.
NOTE: Do not plug into the new position.) Wiring configuration
Power supply...
Installation Instructions - Page 13
... toward the side of the dishwasher collar as needed
(140."1 cm)
(52c"m)
2(³7⁄₄c"m)
Built-up to do so. 13 NOTE: Shims must be securely attached to floor to avoid it from the parts package. 2.
Remove the brackets from tipping, open slots on the side of dishwasher, and bend tab in the...
Installation Instructions - Page 14
... on left side of opening and drain hose is on wheels and move dishwasher close the door a few times. Tilt dishwasher backward on the left and right sides.
6 Door falls open under its own weight, the door tension will need to
cabinet opening .
3 Check water and drain
hose position
If the door closes...
Installation Instructions - Page 15
... to be easier to side. Connect to Water Supply
1 Tighten 90° elbow fitting to valve
Check that dishwasher is a registered trademark of dishwasher to raise dishwasher off the ground to side and
adjust legs if needed , adjust leveling leg until the coupling is properly seated in the opening. IMPORTANT: If wheels were removed...
Installation Instructions - Page 20
... closed tightly and latched? • Has the cycle been set correctly to optical sensor.
Electrical Shock Hazard Plug into a grounded 3 prong outlet. If Dishwasher Does Not Operate
First try the solutions suggested here to possibly avoid the cost of the dishwasher tub. Start/Resume light may flash: When pressing Start/Resume, you have been...
Owners Manual - Page 3
...level shown, if needed.
Heavily soiled loads...dishwasher interior will have hard water or notice rings or spots, try a higher setting. They also improve drying by pressing Heat Dry so that can customize your dishwasher...detergent just before starting a cycle.
■
Fresh automatic dishwasher detergent
... to start the dishwasher automatically at "Full." Light - Use to quickly...
Owners Manual - Page 4
.... If the problem continues, call for several seconds during the main wash.
■ Clean light is normal for certain cycles to run too long
The dishwasher can be adjusted to the dishwasher hot enough? If it if the dishwasher isn't draining well.
Troubleshooting
First try the solutions suggested here or visit our website and...
Owners Manual - Page 6
...to replace or repair
house fuses or to the Internet and you need further assistance, you may contact Whirlpool at :
In U.S.A.:
Whirlpool ...BY LAW. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. The removal and reinstallation...the door on the right-hand or left-hand side of the dishwasher interior.
Pickup and delivery. You can write to parts or ...
Warranty - Page 1
... to repair or replace appliance light bulbs, air filters or water...WHIRLPOOL SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. If you need assistance using your product, you can find your correspondence. ITEMS WHIRLPOOL ... costs when the major appliance is designed to use of the dishwasher interior.
In Canada:
Whirlpool Brand Home Appliances Customer Interaction Centre 1901...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Using the delay start on my dishwasher
...The delay countdown starts, and the cycle will not continue if the door is locked Lights flashing on the dishwasher Dishwasher shuts off -peak hours. You can add items to the load anytime during off... To delay the start the cycle, press Start/Resume. My dishwasher is not latched. Press Start/Resume. To cancel the delay and cycle, press Cancel/... -
Rusty racks/dishes in my dishwasher
... you purchase the kit online , enter Promo Code F9A75Q4 in my dishwasher Should you check out to be the only way to completely eliminate this product or&...8AM-6PM, Eastern Time. Parts Lists, Installation Guides and Use and Care Manuals are needed, a dishwasher rack repair kit just might work. Remove rust-creating items from the dishload; wash these items by entering... -
Oven light is on when door is closed
... On some models the light switch for the upper oven also controls the light in the lower oven. While the upper oven cavity light is on, the light in the door liner. ...range display My microwave oven will need replacing by a qualified service technician. Find a local service provider: Product Category Washer or Dryer Refrigerator or Freezer Dishwasher Electric Range, Oven or Cooktop ...
Similar Questions
Display Board Flashing But Dishwasher Won’t Clear Or Start
(Posted by Dirtroad1998 3 years ago)
Dishwasher Has No Lights Working & Will Not Start
Dishwasher was running fine last night. This morning when I opened it I noticed the water had not dr...
Dishwasher was running fine last night. This morning when I opened it I noticed the water had not dr...
(Posted by chammhh 7 years ago)
Whirlpool Dishwasher Du1345xtvq Will Not Fill With Water
(Posted by mic65 9 years ago)
Dishwasher Repair
I washed the door to dishwasher and control panel 'shorted out'. Obtained part number 8269187 bu...
I washed the door to dishwasher and control panel 'shorted out'. Obtained part number 8269187 bu...
(Posted by vicdvnp 11 years ago)
The Latch On This Dishwasher Seems Like It Is Stuck In The Lock Position. Ideas?
The door won't secrely latch and when I try to hit START, the light just flashes.
The door won't secrely latch and when I try to hit START, the light just flashes.
(Posted by Blumattandjenny 12 years ago)