Whirlpool WFW9150WW Support Question
Whirlpool WFW9150WW Support Question
Find answers below for this question about Whirlpool WFW9150WW.Need a Whirlpool WFW9150WW manual? We have 4 online manuals for this item!
Question posted by djaremko on April 24th, 2011
Washer Will Not Finish Any Load
My washer quits every load at the five minute mark. What gives?
Current Answers
Related Whirlpool WFW9150WW Manual Pages
Energy Guide - Page 1
... will depend on your utility rates and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per therm.
• For more information, visit www.ftc.gov/appliances. (P/N W10252712) U.S. Clothes...
Owners Manual - Page 3
... hurt you don't immediately follow the safety alert symbol and either the word "DANGER" or "WARNING." All safety messages will tell you don't follow instructions. WASHER SAFETY
Your safety and the safety of injury, and tell you what can be killed or seriously injured if you what the potential hazard is...
Owners Manual - Page 4
...mm])
Tools needed for this washer.
The parts supplied are interested in temperatures below 32°F (0°C). Do not operate your washer or refer to Buy
Laundry tub or standpipe taller than 96...
E
A. Some water can remain in the washer and can be considered. To do so you will need to support the washer with a total weight (water and load) of the items listed here, call the ...
Owners Manual - Page 6
... gal. (64 L) per minute.
For cabinet installation, with stacked washer and dryer
The dimensions shown are for closet door. **External exhaust elbow requires additional space. ***Wall, door, and floor molding may be purchased separately. Recommended installation spacing for cabinet installation
The dimensions shown are required.
7" (178 mm) 7"
(178 mm)
A
B
Laundry tub drain system...
Owners Manual - Page 8
Connect the inlet hoses to the hot water faucet. Screw on the washer.
3. Once the bolt is loose, move and install washer. Then pull the power cord through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket, to work properly.
There are 4 transport bolts in the couplings. Attach a hose to the water...
Owners Manual - Page 9
..., kinks, cuts, wear, or leaks are found. To keep drain water from washer drum
1. Hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Slide drain hose onto washer connection.
3. Attach the cold water hose to the washer's hot (H) water inlet valve.
Drape the power cord over drain hose form...
Owners Manual - Page 10
... to clean your washer, measure ½ the detergent
manufacturer's recommended amount of the washer by placing a level on the feet must be tightened. Check for a medium-size load. To test and...Installing washer on . 6. See "Electrical Requirements."
2. If there is level.
5. Do not use an extension cord. Read "Washer Use." 9.
Make sure all four feet are in the laundry tub...
Owners Manual - Page 11
... results. This washer allows a 7-minute period in the dispenser allow loading of water needed for cleaning. Smart Dispensers
The three compartments in which means fewer loads. The Detergent ...washer to give the optimum cleaning, rinsing, and spinning conditions. The products will illuminate for small and large load sizes. The time of the cycle, and the bleach is used, the washer...
Owners Manual - Page 12
...the wash cycle.
Place a load of sorted clothes in the "Changing Cycles and Options" section.
3. Small items can be marked "HE" or "High Efficiency." Close the washer door by turning the cycle selector... cycles by pushing it stops. For All Wash Cycles
1. Sort laundry according to avoid spills. Washer door should be fully loaded, but not tightly packed. It is completed, the door must ...
Owners Manual - Page 13
... D. do not press START/PAUSE within 5 minutes of detergent to use . Fabric softener compartment ...laundry products-one is for detergent, one is for liquid fabric softener. The washer powers down the washer manually after the wash cycle is complete, the DONE status light illuminates, the door unlocks, and the wash load can be removed from the washer. The indicator will be marked...
Owners Manual - Page 15
... heavily soiled garments. This cycle combines medium-speed tumbling, high-speed spin, and a load cooling process to shorten drying time. This cycle combines fast-speed tumbling, a shortened wash... (TEMP, SPIN SPEED) are needed in the washer during the Clean Washer with the lowest spinning to avoid chlorine residues on your laundry. An additional rinse provides optimal rinse performance to...
Owners Manual - Page 16
...illuminated.
This option provides periodic tumbling for an overview of load you press POWER at anytime to unload your faucet. Use... START until the desired time (in the removal of normal washer operation.
See "Troubleshooting." Not all Options are available with...desired setting is automatic for all cycles.
■ See the "Laundry Guide" section for up to 6 hours to . You can ...
Owners Manual - Page 17
Laundry Guide
Refer to each of these washer cycles. Delicate
Curtains and delicate clothing, dresses, skirts, shirts, and
✔
✔
✔
✔
blouses. CYCLE
SUGGESTED LOAD TYPE
AVAILABLE OPTIONS
Delay Extra Start Rinse
Signal TumbleFresh™ On/Off
Whitest Whites Soiled white fabrics
✔
✔
✔
✔
Heavy Duty
Heavily soiled ...
Owners Manual - Page 18
...in a mesh garment bag.
To create a balanced load it is recommended that more than one mesh garment ...9632; Tie strings and sashes so they would normally be marked "HE" or "High Efficiency."
Unloading
■ Remove ...washer after the cycle is completed. This wash system, along with the washer resulting in washer errors, longer cycle times and reduced rinsing performance. LAUNDRY...
Owners Manual - Page 21
... adapter.
Unplug the power cord. 3.
Vacation, Storage, and Moving Care
Install and store your washer. WARNING
5. Follow the "Installation Instructions" to follow these instructions can damage your washer where it .
If storing or moving your washer for a medium-size load, to
rear panel clips. 4. Disconnect water inlet hoses from the drain system and attach...
Owners Manual - Page 22
...laundry tubs, faucets, drainpipe, water pipes) for flooring requirements. Example: If you have 8 flashes (0.5 sec On, 0.5 sec Off) - Failure to follow these instructions can back up out of draining. Unplug washer or disconnect power. The washer....
Do not use an adapter.
Plug in the back of water per minute. Check under the door seal or basket. The plywood may be able ...
Owners Manual - Page 23
...water in the dispenser compartment. Unplug washer or disconnect power. Wait 5 minutes. Slowly pour into a grounded 3 prong outlet? Clean the fabric softener dispenser. AFFRESH® washer cleaner removes and avoids odor-causing... details.
■ Are the laundry products in the same wash cycle repeatedly?
Washer stops working outlet, and check for 1 second?
Run another cycle.
23...
Owners Manual - Page 24
...suds are detected, a special suds routine automatically starts. Check water hose connections to redistribute the load. Check if the home has low water pressure, open the water faucets.
■ Are ... end drum up and down while holding outer tub steady and check for about 2 minutes during certain cycles. Washer won 't fill
■ Low water pressure at the water faucets are detected, a...
Owners Manual - Page 25
... washed? For best results, use the right cycle for the load being washed? This ensures a gentle wash for washing heavy soils in a slow-speed cycle. Add items or try again.
■ Did you unload the washer promptly? If the laundry is wrinkled, twisted, tangled
■ Did you use powdered detergent in the drum...
Dimension Guide - Page 1
... (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. or 20-amp, fused electrical supply is recommended that may be no higher than 17 gal. (64 L) per minute.
The siphon break must... products, we reserve the right to change materials and specifications without notice. Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS WFW9150W
Electrical: A 120 volt, 60 Hz., AC only, 15...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The amount of water seems too low - Front-load Duet washer
... is a low-water-usage washer. Make sure the washer is not cleaning laundry - Find Manuals & The amount of water seems too low - The water level on this washer should seem low, because this is at the lowest 6-o'clock position. The amount of water varies by cycle and load size to give you the proper care... -
Washer will not fill - Front-load Duet washer
... water varies by cycle and load size to give you the best fabric care for the proper water level: Check that the washer is not cleaning laundry - Failure to remove all .... Remove any accumulated film or particles. The washer pauses for 1 second? Allow the cycle to fill normally. Has a cycle been selected, but may take several minutes. Press and hold the End Of Cycle Signal... -
What do I do about stains on my clothing when using my jetted sink?
... of the finish with a mild, liquid detergent and a damp cloth or sponge. Top-load washer Was the jetted sink used for 10 minutes; See "...Loads are wrinkled - To avoid dye transfer, unload the jetted sink as soon as scouring pads. Rinse and wipe dry with cold water and run for 10 minutes to install an iron filter. These can be buffed or polished out of non-sudsing laundry...
Similar Questions
Whirlpool Wfc7500vw Washer Front Load Won't Start.
I am trying to use the "Delicate" cycle but the washer will not start. I live in an apartment buildi...
I am trying to use the "Delicate" cycle but the washer will not start. I live in an apartment buildi...
(Posted by mjohns42 6 years ago)
New Washer Quit After A Week.
We have a washer that is a week old. It is locked and none of the cycles will work. It just says sen...
We have a washer that is a week old. It is locked and none of the cycles will work. It just says sen...
(Posted by amycooper1 9 years ago)
Washer Quit Mid-cycle, Door Locked, Won't Open. No Power/no Lights.
My Whirlpool Duet WFW9150WW quit mid-cycle and the door is locked. No lights on. No power to unit. U...
My Whirlpool Duet WFW9150WW quit mid-cycle and the door is locked. No lights on. No power to unit. U...
(Posted by tishcrawford 10 years ago)
Whirlpool Washers Front Load Duet 4.0 Wfw9150ww Will Not Drain
(Posted by cwasjsabo 10 years ago)
Whirlpool Front Load Washer Wfw9150ww Will Not Spin
(Posted by rgalnaria 10 years ago)